A preliminary design of a reservoir is shown in Figure (5). The flownet is given below. It is required to: a) Calculate the flow rate. b) Calculate the porewater pressure at A & B. c) Calculate the factor of safety against downstream heave, given that the saturated unit weight of the silty sand layer is 17 kN/m³. Retaining wall Water 10 m 2 m Water 5 m 4 m. В 26 m. Silty sand keg =1 x 106 cm/s. Homogeneous, impervious clay Figure (5) Datum a d 6. 26 m 3 4 h 5 m scale Flownet Sketch

Q: Determine radius of mohr circle 9 MPa 4 MPa 6 MPa

A:

Q: Surveys are carried out to define land ownership and boundaries O Cadastral Surveying Topographical…

A: Surveys are carried out to define land ownership and boundaries--> Cadastral Surveying

Q: Define fundamental strength-related geotechnical engineering properties

A: Geotechnical engineering is the study of how soils respond to loading forces and interactions…

Q: What is sag in surveying

A:

Q: st BS -00 3.54 +10/ +20 + 1 | 1 1 I 2.994 2.044 0-171 00249 1.497 Is 3.269 2.966 Fs 1.845 1.840…

A:

Q: What are the five limitation of PLAXIS 2D, a  finite element method geotechnical software?

A: Geotechnical Finite Element Method Software: Geotechnical software is software based on the finite…

Q: What is the use of geosynthetic fabrics

A: Geosynthetics can be defined as it is a synthetic product, which is used to support the terrain. It…

Q: locate a missing point on the ground: a. You need at least three reference points b. You need at…

A: Given To locate a missing point on the ground:

Q: Discuss the importance of accuracy and precision in surveying measurements

A: In surveying, accuracy, and precision are key ideas that guarantee the dependability and caliber of…

Q: What is the type of traverse shown in the picture? (select all that apply) Az Mk (a)

A: Given that:

Q: Why Bearings are predominately used in boundary surveying?

A: Bearing usually are measured with respect to a fixed meridian(generally true North) unlike normal…

Q: Name this force system         Question 19 options:   Non-planar parallel…

A: Given a system of force system

Q: Establish the relation linking d to AB, a, and ß. Calculate d for AB-500m, a = 65°, and ß = 55°.

A: Given: The length AB is 500 m. The angle a is 65o. The angle B is 55o.

Q: Identify and describe the following surface analysis techniques AES, AFM, EDS, FIB, FTIR, SEM, TEM,…

A: Atomic Force Microscopy (AFM) Atomic Force Microscopy (AFM) is an analysis that quantifies surface…

Q: Define fundamental volume-related geotechnical engineering properties

A:

Q: 2) The following table contains a set of measured levels for a closed traverse (i.e. BM level = CP5…

A: The set of measured levels for a closed traverse…

Q: Complete the notes, find the elevation of point A and state the error in the network. Determine the…

A: HI= Elevation +BS Elevation= HI-FS

Q: Pitched roof Cavity wall Brick wall Floor Dead Load (kN/m2) 2.1 3.5 3.3 1.0 Imposed Load (kN/m2) 1.0…

A: Given data:- Unit weight of concrete is 2.35 kN/m3 Below table is given;   Dead load  (kN/m2)…