A practical battery is connected across a single resistive load. Which of the following is true regarding the power being supplied by the battery? The product of the EMF plus the power being consumed by the internal resistance of the battery; The square of the current in the circuit times the resistance of the load; O (The answer cannot be found on the other choices.) O The product of the EMF plus the power being consumed by the resistive load;

A practical battery is connected across a single resistive load. Which of the following is true regarding the power being supplied by the battery? The product of the EMF plus the power being consumed by the internal resistance of the battery; The square of the current in the circuit times the resistance of the load; O (The answer cannot be found on the other choices.) O The product of the EMF plus the power being consumed by the resistive load;

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter21: Current And Direct Current Circuits

Section: Chapter Questions

Problem 1OQ: If the terminals of a battery with zero internal resistance are connected across two identical...

See similar textbooks

Similar questions

A 12.0-V emf automobile battery has a terminal voltage of 16.0 V when being charged by a current of 10.0 A. (a) What is the battery’s internal resistance? (b) What power is dissipated inside the battery? (c) At what rate (in °C/min ) will its temperature increase if its mass is 20.0 kg and it has a specific heat of 0.300 kcal/kg • °C, assuming no heat escapes?
A potential difference of 1.00 V is maintained across a 10.0- resistor for a period of 20.0 s. What total charge passes by a point in one of the wires connected to the resistor in this time interval? (a) 200 C (b) 20.0 C (c) 2.00 C (d) 0.005 00 C (e) 0.050 0 C
The student engineer of a campus radio station wishes to verify the effectiveness of the lightning rod on the antenna mast (Fig. P21.71). The unknown resistance Rx is between points C and E. Point E is a true ground, but it is inaccessible for direct measurement because this stratum is several meters below the Earths surface. Two identical rods are driven into the ground at A and B, introducing an unknown resistance Ry. The procedure is as follows. Measure resistance R1 between points A and B, then connect A and B with a heavy conducting wire and measure resistance R2 between points A and C. (a) Derive an equation for Rx in terms of the observable resistances, R1 and R2. (b) A satisfactory ground resistance would be Rx 2.00 . Is the grounding of the station adequate if measurements give R1 = 13.0 and R2 = 6.00 ? Explain. Figure P21.71
A 20.00-V battery is used to supply current to a 10-k resistor. Assume the voltage drop across any wires used for connections is negligible, (a) What is the current through the resistor? (b) What is the power dissipated by the resistor? (c) What is the power input from the battery; assuming all the electrical power is dissipated by the resistor? (d) What happens to the energy dissipated by the resistor?
A 6.00 nF capacitor that is initially uncharged is connected in series with a 900 2 resistor and an emf source with & = 360V and negligible internal resistance. A long time after the circuit is completed (enough time that capacitor is fully charged), what is the current across the resistor? O 0.20 A O 0.067 A 1.33 A OA 0.24 A O 0.40 A 0.16 A
Consider a capacitor C that is fully charged by a 10 V power supply. Later on, the resistor R, shown in the circuit, is connected across this fully charged capacitor. When the capacitor lost 50% of its stored energy, the current I (in A) - shown in the circuit- is: R= 22 O 2.3 O 3.5 O 2.9 4.1 O 1.4
Given two batteries: one with voltage Vand internal resistance r1; another with also voltage Vand internal resistance r2. Which of the following is true if we connect them in parallel the positive terminal of one connected to the negative of the other? O The answer cannot be found on the other choices. The total voltage will be V, while the total internal resistance is (r1-1 + r21)1. No voltage will remain, while the total internal resistance is (rıi -1 + r2 O The total voltage will be 2V, while the total internal resistance is (r11 + r2)1.
An uncharged capacitor with C = 33 μF and a resistor with R = 65 Ω are connected in series with a battery of ε = 1.5 V. Express the time constant τ in terms of R and C and use it to calculate the numerical value of τ in microseconds. Express the maximum charge Q on the capacitor in terms of C and ε and use it to calculate the numerical value of Q in microcoulombs.
Given two batteries: one with voltage V and internal resistance r₁; another with also voltage V and internal resistance r2. Which of the following is true if we connect them in series with the same polarity (facing the same direction)? O The total voltage will be V, while the total internal resistance will be r1 + 12. O The total voltage will be V, while the total internal resistance will be either r₁ or r2. No voltage will remain while the total internal resistance will be r₁ + 12. The total voltage will be 2V while the total internal resistance will be r₁ + r2.
A 2.00-nF capacitor with an initial charge of 4.93 µC is discharged through a 1.93-k resistor. dQ (a) Calculate the current in the resistor 9.00 µs after the resistor is connected across the terminals of the capacitor. (Let the positive direction of the current be define such that dt 1.72 The current through the resistor is considered to be negative, so that I = dQ/dt. mA (b) What charge remains on the capacitor after 8.00 µs? μC (c) What is the (magnitude of the) maximum current in the resistor? A > 0.)
A solar cell generates a potential difference of 0.17 V when a 550 resistor is connected across it, and a potential difference of 0.24 V when a 970 resistor is substituted. What are the (a) internal resistance and (b) emf of the solar cell? (c) The area of the cell is 1.2 cm² and the rate per unit area at which it receives energy from light is 4.9 mW/cm². What is the efficiency of the cell for converting light energy to thermal energy in the 970 2 external resistor? (a) Number (b) Number (c) Number i Units Units Units Ω V per
A capacitor with a capacitance of 3.5 μF is initially uncharged. It is connected in series with a switch of negligible resistance, a resistor with a resistance of 19 kΩ, and a battery that has a potential difference of 170 V. What is the charge Q, in microcoulombs, on the capacitor when the current in the resistor equals one half its maximum value.