A piston-cylinder device initially contains 5.00 L of air at 100 kPa and 25°C. Air is now compressed to a final state of 600 kPa and 150°C. The useful work input is 1.2 kJ. Assume the surroundings are at 100 kPa and 25°C.

Q: GIVEN THE ORTHOGRAPHIC VIEWS, CREATE AN ISOMETRIC SKETCH OF THE FOLLOWING OBJECT.

A: Find Create an isometric sketch of the given object on isometric paper.

Q: 13. User tool frame UT[3] was set up by the programmer with three-point method for UT setup provided…

A: Given: User tool frame with 3 point method is setup To find: correct statements

Q: (ii) Figure A2-3 shows the torque and power of the employed EMRAX 208 Permanent magnet synchronous…

A: Given: To find: Design the drivetrain system

Q: The last 3 compartments in a feature control frame provides the datum references; this is known as…

A: The last 3 feature control frame provides the datum referances, this is known as datum order of…

Q: raph A block of weight 3.6 N is launched up a 30° inclined plane of length 2.40 m by a spring with…

A: Given values, Weight of the block(W) =3.6*2=7.2 N Angle of inclination (θ)=300 Inclined plane…

Q: A particle moves along the x-axis with velocity given by v(t) = 3t 2 + 6t for time t> 0. If the…

A: Given data: vt=3t2+6t Need to determine the position of the particle at t=1 sec.

Q: 1. Sketch the CAVALIER OBLIQUE of the given object. Use corner "A" for orientation.

A: according to the details provided in the question, we need to draw a cavalier view of the given…

Q: Please use the isometric graph paper in my picture to draw it to scale!

A: According o the given data Three orthographic views of the object are given  We need to draw The…

Q: 21 - A new piece of production machinery has the following costs: Investment cost = $35,000 Annual…

A: Given:To find:Calculate the marginal cost.

Q: DIMENSION THE OBJECT SHOWN BELOW. NOTE THAT NOT ALL ORTHOGRAPHIC VIEWS WILL REQUIRE DIMEN- SIONS. DO…

A:

Q: Feature orientation is controlled by the O tertiary O primary O secondary O final datum feature.

A:

Heat Exchangers

Heat exchangers are the types of equipment that are primarily employed to transfer the thermal energy from one fluid to another, provided that one of the fluids should be at a higher thermal energy content than the other fluid.

Heat Exchanger

The heat exchanger is a combination of two words ''Heat'' and ''Exchanger''. It is a mechanical device that is used to exchange heat energy between two fluids.