A permanent bar magnet is moved away from the solenoid as shown below. Agalvanometer (G) is a very sensitive device to measure small amounts of electriccurrent.IN SG21. Due to the bar magnet being pulled away from the solenoid the induced pole thacreated at location I is agalvanometer would beipole. The electron flow through theiiThe statement above is best completed by the answers in row:Rowiiinorthrightsouth leftsouthrightnorthleft

A permanent bar magnet is moved away from the solenoid as shown below. A galvanometer (G) is a very sensitive device to measure small amounts of electric current. I N S G 21. Due to the bar magnet being pulled away from the solenoid the induced pole th created at location I is a galvanometer would be i pole. The electron flow through the ii The statement above is best completed by the answers in row: Row i ii north right south left south right north left

A permanent bar magnet is moved away from the solenoid as shown below. A galvanometer (G) is a very sensitive device to measure small amounts of electric current. I N S G 21. Due to the bar magnet being pulled away from the solenoid the induced pole th created at location I is a galvanometer would be i pole. The electron flow through the ii The statement above is best completed by the answers in row: Row i ii north right south left south right north left

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

part a and b
A metal bar is sliding on conducting rails at a speed of 40 m/s as shown below. There is a magnetic field pointing out of the page. The resistance of the bar is 1.6 0. There is a, induced current of 4.1 A in the bar. What is the direction of the current in the bar? What is the magnitude of the magnetic field B? What is the magnitude of the applied force needed to keep the bar traveling at this speed? Put the value of B in the answer box. B 36 cm v = 40 m/s Answer:
Two coils with iron cores are positioned as shown in the figure. The smaller coil is part of a circuit with a battery and a switch. Immediately after the switch Sis closed, which one of the following statements is true? O A magnetic field that points away from the smaller coil appears inside the larger coil. O An induced current will flow from right to left in R. O A magnetic field that points away from the larger coil appears inside the smaller coil. O A current will pass through r, but there will be no current through R. O An induced current will flow from left to right in R.
OTT a c) Sketch a graph of the magnitude of B as a function of the distance from the axis of the cable, from = 0 to r = 2c. B(r) Solenoid 10 11 12 13 14 +x-direction -x-direction Justify your selection. b 4 C alla Sa Axis of Solenoid 2c y Cutaway View X Note: Figures not drawn to scale. 7. A solenoid is used to generate a magnetic field. The solenoid has an inner radius a, length e, and N total turns of wire. A power supply, not shown, is connected to the solenoid and generates current I, as shown in the figure on the left above. The x-axis runs along the axis of the solenoid. Point P is in the middle of the solenoid at the origin of the xyz-coordinate system, as shown in the cutaway view on the right above. Assume l » a (a) Select the correct direction of the magnetic field at point P. +z-direction +y-direction -y-direction -z-direction (b) i. On the cutaway view above and right, clearly draw an Amperian loop that can be used to determine the magnetic field at point P at the center of…
A solenoid has 505 turns over a length of 0.54 m. What current will produce a magnetic field of 0.017 T within the solenoid? A
1. The figure shows a long straight wire just touching a loop carrying a current /,. Both lie in the same plane. R I2 (a) What direction must the current l, in the straight wire have to create a field at the center of the loop in the direction opposite to that created by the loop? Up O Down O Left O Right Into Screen O Out of Screen (b) What is the ratio of I,/, that gives zero field strength at the center of the loop?
Calculate the energy associated with the magnetic field of a 179-turn solenoid in which a current of 2.23 A produces a magnetic flux of 3.67 x 104 T. m2 in each turn. Your response differs significantly from the correct answer. Rework your solution from the beginning and check each step carefully. m)
In the diagram below, a bar magnet moves toward a solenoid. Use Lenz's а. Law to find the direction of the induced current in the solenoid and then determine the direction of current flow through the resistor connected to the solenoid. Motion N The direction of the current through the resistor is: A. upward B. downwards In the diagram below, a solenoid moves toward a bar magnet. Use Lenz's Law to find the direction of b. the induced current in the solenoid and then determine the direction of current flow through the resistor connected to the solenoid. Motion The direction of the current through the resistor is: O A. upwards B. downwards
A loop of wire carries a current (provided by a battery which is not shown) next to a bar magnet. The magnet is repelled from the loop. Which way does current run in the loop? Cannot determine, we need to know if the flux is changing. Out of the page on the top, Into the page on the bottom. Into the page on the top, Out of the page on the bottom.
A solenoid 2.5 cm in diameter and 30 cm in length has 2400 turns and carries a current of 2.0 A. A)Calculate the magnetic flux through the circular cross-sectional area of the solenoid. Hint: Assume this is a very long solenoid and use the simplified magnetic field formula for an infinite solenoid.
The distance between the wire and the circular current loop is r = 2.4 cm. (Figure 1) Figure O 2.0 A -Wire 0.20 A 1 of 1 2.0 mm What is the magnitude of the torque on the circular current loop? Express your answer with the appropriate units. T = Submit Part B μÀ Value Request Answer Units What is the loop's stable equilibrium position? ? O The dipole will be in equilibrium after rotating clockwise 135°. O The dipole will be in equilibrium after rotating clockwise 180°. O The dipole will be in equilibrium after rotating clockwise 45°. O The dipole will be in equilibrium after rotating clockwise 90°.
A small bar magnet experiences a 1.60×10-2 N. m torque when the axis of the magnet is at 45.0° to a 6.00×10-2 T magnetic field. Part A What is the magnitude of its magnetic dipole moment? Express your answer in ampere meteres squared. VGI ΑΣΦ Submit Request Answer 2) ? A.m²