A particular roadway segment has a 6000-ft section of 3% upgrade, followed by a 5000-ft section of 5% upgrade. The traffic on the road includes 8% trucks and 4% recreational vehicles. Determine the PCE

A particular roadway segment has a 6000-ft section of 3% upgrade, followed by a 5000-ft section of 5% upgrade. The traffic on the road includes 8% trucks and 4% recreational vehicles. Determine the PCE

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A six-lane freeway (three lanes in each direction) in rolling terrain has 10-ft lanes and obstructions (fLw = 6.0 mph) 4 ft from the right edge of the traveled pavement (fic = 0.8 mph). There are five ramps within three miles upstream of the segment midpoint and four ramps within three miles downstream of the segment midpoint. A directional peak-hour volume of 2000 vehicles (primarily commuters) is observed, with 600 vehicles arriving in the highest 15-min flow rate period. The traffic stream contains 12% large trucks (ET = 2.5) and buses and 6% recreational vehicles (ER = 2.0). 1.) What is the estimated free-flow speed of the traffic stream in mph (whole number, nearest 5)? 2.) What is the peak-hour factor 3.) What is the heavy-vehicle adjustment factor? 4.) What is the service flow rate? 5.) What is the service measure value if the average speed of the traffic stream is 65 mph
A multi-lane Minor Arterial is being designed through a level urban area. The current daily volume = 8000 vpd in both directions with 10% Trucks, peak hourly factor 90%and a 60% directional distribution factor. How many lanes are required?
A six-lane freeway (three lanes in each direction) in rolling terrain has 10-ft lanes and obstructions (fLW = 6.0 mph) 4 ft from the right edge of the traveled pavement (fLC = 0.8 mph). There are five ramps within three miles upstream of the segment midpoint and four ramps within three miles downstream of the segment midpoint. A directional peak-hour volume of 2000 vehicles (primarily commuters) is observed, with 600 vehicles arriving in the highest 15-min flow rate period. The traffic stream contains 12% large trucks (ET = 2.5) and buses and 6% recreational vehicles (ER = 2.0). What is the heavy-vehicle adjustment factor (2 decimal places)?
A 5% upgrade on a six-lane freeway (three lanes in each direction) is 1.25 mi long. On this segment of freeway, there is 3% SUTS and 7% TTs, and the peak-hour factor is 0.90. The lanes are 12 ft wide, there are no lateral obstructions within 6 ft of the roadway, and the total ramp density is 1.0 ramps per mile. What is the maximum directional peak-hour volume that can be accommodated without exceeding LOS C operating conditions in veh/h? Round of your answer to whole number. Blank 1
A two-lane rural highway carries a peak hour volume of 465 (vph) and has the following characteristics: Roadway: 60mph design; 11 foot lanes, 2 foot shoulders; rolling terrain; 60% no-passing zones; length = 3 miles. Traffic: 70/30 directional split; 4% trucks; 2 percent recreational vehicles; 1 percent buses; PHF = 0.95 a) What Level of Service will the highway operate under during peak periods? b) What is the capacity of the highway? Explain why this is less than 2,800 (vph)?
A new four-lane divided multilane highway (two lanes in each direction) is being planned with 12-ft lanes, 6-ft shoulders on both sides, and a 50-mi/h speed limit. One 3% downgrade is 4.5 mi long, and there will be 4 access points per mile. The peak-hour directional volume along this grade is estimated to consist of 1800 passenger cars, 140 SUTs, and 60 TTs. If the peak-hour factor is estimated to be 0.85, what level of service will this segment of highway operate under? What is the percent trucks - PT? What is the value of the passenger car equivalence factor - ET? What is the heavy vehicle factor - fHV? What is the median adjustment factor - fM?
A four-lane freeway with the following characteristics: ten foot travel lanes lateral obstructions at 0 feet at the roadside total ramp density is 4.5 ramps/mile rolling terrain The roadway has a current peak demand volume of 3500 veh/h. The peak hour factor is 0.95 and there are no trucks, buses, or RVs in the traffic stream because the roadway is classified as a parkway and such vehicles are prohibited. At what level of service will the freeway operate during its peak period of demand?
Problem 2. New freeway is being designed on a level terrain, free-flow speed 70 mph 12-ft lanes, 6-ft lateral clearance Peak hour volume 2700 veh, 12% heavy vehicles PHF = 0.92 FIND: Number of lanes for LOS C
An existing four-lane freeway in rural area is with the following :information Lane width 3.5m, 0.9m lateral clearance, 1800 veh/hr peak hour volume, PHF=0.9, interchange density =0.90, 5% trucks, 5% buses and the road is within a mountainous terrain. Then based on the HCM procedure, the service flow rate (pc/h/In) is
An existing six-lane divided multilane highway with a field-measure free-flow speed of 45mph serves a peak-hour volume of 4,000 vehicles per hour, with 10% trucks (50% SUT, 50% TT). The PHF is 0.88. The highway has generally rolling terrain. What is the likely level of service for this segment? Good weather, no incidents, no work zones, and regular drivers may be assumed.
6.14 A freeway segment currently has four 11-ft wide lanes and a 3-ft right shoulder in the southbound direction. It is operating in LOS B with a traffic density of 15.6 pc/mi/ln and a peak-hour factor of 0.85. The freeway is on level terrain with 15% heavy vehicles, and currently has no on- or off- ramps within a distance of three miles upstream and downstream of the mid-point of the analysis section. New interchanges are to be constructed that would result in 6 on- and off-ramps within the distance of three miles upstream and downstream of the mid- point of the analysis section and total traffic volume is projected to double, with the same percentage of heavy vehicles, and the peak-hour factor going to 0.95. What would the new LOS and density be after the interchange construction and new traffic conditions?
The heavy vehicle adjustment factor for a freeway in rolling terrain with 5% heavy trucks is: 1.08 1.13 0.89 0.93 1.00 OOO O