A multi plate clutch has three plates and four pressure plates, pressed together by an axial force of 500N. µ = 0.3. The outer radius of the plates is 100mm, and the inner radius is 80mm. Calculate the torque that the clutch can transmit. If the inner radius and axial force are to remain the same, but the torque is increased by 25%, what must the outer radius than

A multi plate clutch has three plates and four pressure plates, pressed together by an axial force of 500N. µ = 0.3. The outer radius of the plates is 100mm, and the inner radius is 80mm. Calculate the torque that the clutch can transmit. If the inner radius and axial force are to remain the same, but the torque is increased by 25%, what must the outer radius than

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Give Right answer only
please I want quick answer
single plate clutch with both sides of the plate effective. The axial. Pressure being limited to 0.13 N/ mm. the outer diameter of the contact surface is (250mm) and the inner diameter (150 mm). the M=0.3 find the power transmitted by clutch at (500r.p.m). Assuming uniform wear
A)It is required to use a multiplate clutch to transmit power of 24 kW at 1200 r.p.m. If the clutch has the following data: • The Outer and inner plate radii are 120 mm and 80 mm respectively. • Maximum axial pressure pmax=0.12 N/mm?. • Coefficient of friction=0.3. Find: 1. The axial load (W) required. 2. The number of effective pairs of contact surfaces (n).
A brake test is carried out with a balance and a direct current motor. The purpose of this experiment is to calculate the torque on the motor shaft. The following values were obtained in the experiment. U=220 volts., I=107 amps, n = 1200 rpm. The length from the axis of the motor shaft to the point where the brake lever presses on the scale is L=80 cm. and the weight read on the balance G = 20 Kg. is Accordingly, calculate the following values: a) the shaft power taken from the shaft of the motor, b) the electrical power drawn by the motor from the mains c) motor total losses and motor efficiency Calculate
Q1/ An open belt drive connected two pulleys 120 cm and 50 cm diameter on parallel shafts 4 m apart. The belt weights 0.9 kg/m length and maximum tension in it is not to exceed 2000 N. 0.3. The 120 cm pulley, which is the driver, runs at 200 rpm. Due to belt slip on one of the pulleys, the velocity of the driven shaft is only 450 rpm. Calculate the torque on each of the two shafts and power transmitted.
Q2/ A conical clutch an included angle of 60°. the outer radius and inner diameters are 80 and 20 cm respectively. Calculate the maximum and minimum intensity of pressure and force required to press the two halves together if it is to transmit 20 MW, at 60 rev/h. the coefficient of friction is 0.3, Use both the uniform wear theory and the uniform pressure theory.
5. There is a small amount of friction in the bearings of the pulley wheel. Suggest a way to measure this friction force (in grams).
i need the answer quickly
...A plate clutch with single driving plate with contact surfaces on each is required to transmit 35 kW at 2400 rpm. Given that μ = 0.29, R = 1.25r, Pmax = 0.2 MPa, determine the inside radius of the frictional surface in mm. Assume the uniform wear conditions.