Answered: A motion EMF system consists of a… | bartleby

Related questions

Question

A motion EMF system consists of a conductive bar that can freely slide across bare wires in which it is in contact with at its ends. The resistance of the system is constant at 24.0 Ohms. A constant force of 1.7 N is applied to the bar, making it slide across the wires at a constant rate of 7.6 m/s. What is the induced current in this system

Expert Solution

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

A coil of radius 3 cm has 60 turns of Cu wire of diameter 4 mm. The plane of the coil is perpendicular to a field that changes at the rate of 0.2 T/s. What is the power loss in the coil? The resistivity of Cu is 1.7 × 10-8 S. m. mW
A single loop of copper wire, lying flat in a plane, has an area of 7.80 cm2 and a resistance of 1.50 Ω. A uniform magnetic field points perpendicular to the plane of the loop. The field initially has a magnitude of 0.500 T, and the magnitude increases linearly to 2.00 T in a time of 1.10 s. What is the induced current (in mA) in the loop of wire over this time?
The 5-cm by 8-cm rectangular coil of a bicycle generator is rotating at a rate of 125 rpm in a 255-mT magnetic field. The output voltage of the generator is used to power a bicycle headlight that has a total resistance of 360 N. (a) How many turns are there in the coil if the peak output voltage is 1.8 V? N = turns (b) What is the rms-average current through the headlight? Irms mA
Suppose you have a long, skinny conductor that is oriented with its long axis parallel to a uniform magnetic field. Suppose also that the conductor is moving along its long axis in a straight line at constant velocity v. Despite the motion of the conductor, no motional emf is induced. Why? The magnetic field is too uniform The velocity has no component normal to the magnetic field The velocity is too low The conductor is so long and so thin that its electrical resistance is too high
A technician wearing a circular metal band on his wrist moves his hand into a uniform magnetic field of magnitude 2 T in a time of 0.21 s. If the diameter of the band is 5.2 cm and the field is at an angle of 59° with the plane of the metal band while the hand is in the field, find the magnitude of the average emf induced in the band. 0.0061 V 1.0417 V 0.0417 V 0.0104 V
A 5-turn conducting loop with a radius of 3.0 cm with axis of rotation in the plane of the paper spins at 60 revolutions per second in a magnetic field of 0.50 T that is perpendicular to the paper. The maximum emf generated is: 0.14 V 8.3 V 28 V 2.7 V 10.5 V
Magnetic flux increases from 0 to 2 Tm2 in one turn conducting loop within 0.5s. What is the induced emf in the loop? 0.5 V 2 V 0.3 V 4 V 1 V
A generator is made from a set of 50 wire loops of radius 40.0 cm that turn in a uniform 0.0900 T magnetic field. What frequency of rotation is needed to supply a peak emf of 85.0 V?.