please explain step by step A mixture consisting of 11.6 g of calcium fluoride, CaF2, and 10.8 g of sulfuric acid, H2 SO4, is heated to drive off hydrogen fluoride, HF.CaF2 (s) + H2SO4(1) → 2HF(g) + CaSO,(s)What is the maximum number of grams of hydrogen fluoride that can be obtained?Mass HF

Calcium fluoride reacts with sulfuric acid to form hydrogen fluoride and calcium sulfate. The…

A mixture consisting of 11.6 g of calcium fluoride, CaF2, and 10.8 g of sulfuric acid, H2 S04, is heated to drive off hydrogen fluoride, HF. CaF2 (s) + H2SO4(1) → 2HF(9) + CaSO4 (s) What is the maximum number of grams of hydrogen fluoride that can be obtained? Mass HF =

A mixture consisting of 11.6 g of calcium fluoride, CaF2, and 10.8 g of sulfuric acid, H2 S04, is heated to drive off hydrogen fluoride, HF. CaF2 (s) + H2SO4(1) → 2HF(9) + CaSO4 (s) What is the maximum number of grams of hydrogen fluoride that can be obtained? Mass HF =

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Related questions

Q: A reaction, shown below, was carried out at room temperature (21.5 ºC). This reaction was carried…

A: Given that: temperature = 21.5 ºC = 21.5 + 273.15 = 294.65 K volume = 1256 L pressure = 1.02 atm…

Q: A scientist observes the consumption of a reactant A in an experiment. This is the data they…

A: The relationship between the initial concentration of the reactant ([A]o) and the concentration of…

Q: Can laws only be written after enough data has been collected to summarize the data?

A: Laws can be written for a variety of reasons, and the process varies depending on the legal system…

Q: [A] M 0.200 0.200 0.400 The order in A is The order in B is k= O k=[A]²[B] Ok=[A][B]² [B] M O…

Q: Calculate the average rate using the graph below. 1.2 1.0 1.0 0.8 0.6 [HO] - 0.4 0.2 10 20 30 40 50…

A: Rate is change in concentration per unit time. So, Rate = Change in concentration / Change in time…

Q: The density of water is approximately 1 g/cm³. Which of these substances will sink in water? A)…

A: Explanation :- More than 1 g/cm3, it will Sink in water.

Q: Before heating 4 qt. saucepan 8 qt. stockpot 24.5 °C Temp. 24.5 °C Temp. After heating for 5 minutes…

A: Water has specific heat constant of 4.184 J per g per oC which means that 4.184 J of energy is…

Q: AB(g) → A(g) + B(g) Time(s) [AB] (M) 0 50 100 150 200 250 300 350 400 450 500 0.950 0.459 0.302…

A: Rate for the given reaction can be given as:r = k[AB]mWhere m is the order of the reaction.

Q: 18. Which solute is not soluble in the given solvent for the solute-solvent pair? Solute Solvent…

A: 18) Solubility of a solute in a solvent depends on the polarity of solute and solvent. If the…

Q: Match the reservoir with the correct turnover rate of carbon: + land biosphere A. centuries + ocean…

A: Turnover rate: fraction of material that leaves a reservoir in a specifed time interval.…

Q: Convert each "b" value from the three Graphs ln(Conc) to the Initial Concentration. Graph Two: y=…

A: To convert the "b" value from the ln(Conc) versus time graphs to the initial concentration, you need…

Q: Part A The rate constant for a certain reaction is = 8.40x10 s. If the initial reactant…

A: In this question given Rate constant of a certain reaction is K = 6.40 × 10–3 s–1. If initial…

Q: In aqueous solution, chlorine dioxide oxidizes iodide ion to iodine and chlorine dioxide is reduced…

A: This is second order rate equation with respect to ClO2. In case of second order, the plot between…

Q: Automobile catalytic converters have to work at high temperatures, as hot exhaust gases stream…

A: Most vehicles are now fitted with pollution-reducing units called catalytic converters which turn…

Q: A chemist adds 40.0 mL of a 0.083 mmol/L sodium thiosulfate (Na, S,0,) solution to a reaction flask.…

Q: Aqueous hydrobromic acid (HBr) will react with solid sodium hydroxide (NaOH) to produce aqueous…

A: Welcome to bartleby ! We have to calculate excess weight of HBr

Q: in step 4 and step 5 why divide by 4 and 16?

A: Step 4 The initial concentration of NO2 is, The concentration of NO2 after 24 seconds is…

Q: For each reaction, identify the reactant as an acid , a base , or neither an acid or base : a. HCl +…

A: In a reaction taking place is HCl + H2O → H3O+ + Cl- Since here HCl is transfering H+ ion in the…

Q: Choose the correct description of the meaning of the expression "collecting a gas over water". A. A…

A: In many chemical reactions, the product is a gaseous product and the amount of the gaseous product…

Q: These are some objects from the scale tool. Rewrite them in order from smallest to largest Incorrect…

A: Here, we need to arrange the given substances(or particles) in ascending order in terms of their…

Q: C5H12 + O2 →CO₂ + H₂O For the given reaction, the partial pressure of C5H12 is 0.5 atm, and of O₂ is…

A: The balanced chemical reaction for the combustion of pentane is as follows:The stoichiometry of the…

Q: Calculate the average rate using the graph below. 1.2 1.0 0.8 [HO 0.6 0.4 0.2 10 20 30 40 50 60 70…

A: To calculate the average rate of the reaction.

Q: Rates of reaction are typically measured as the change of concentration per unit time. Some typical…

A: The unit for combustion of gasoline is mM/min. b) Conversion of organic material into crude oil is a…

Q: In a chemical reaction, a certain compound changes into another compound at a rate proportional to…

A: Initially there is 784 g of original compound and 588 g after 1 hour.need to find when 75 percent of…

Q: student increases the temperature of a 300 cm³ balloon from 300 K to 600 K. What will the new volume…

Q: A reaction at 34.0 °C evolves 436. mmol of boron trifluoride gas. Calculate the volume of boron…

A: The ideal gas law shows the relationship between the number of moles, temperatures, pressure, and…

Q: A student conducts an experiment using an unknown hydrate and obtains the following data Crucible…

A: Given - Crucible = 24.31g Crucible+ hydrate = 29.31g Crucible+ anhydrate = 28.26g Mg % = 29.44% S…

Question

please explain step by step

A mixture consisting of 11.6 g of calcium fluoride, CaF2, and 10.8 g of sulfuric acid, H2 SO4, is heated to drive off hydrogen fluoride, HF.
CaF2 (s) + H2SO4(1) → 2HF(g) + CaSO,(s)
What is the maximum number of grams of hydrogen fluoride that can be obtained?
Mass HF

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Final answer

Trending now

This is a popular solution!

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

4PH3(g) → P4(g) + 6H₂(g) The average rate of consumption of PH3 is 0.048 M s¹¹. Based on this average rate, what amount of P4 would be collected in 4.00 minutes in a 15.0 L container? A. 173 moles B. 43.2 moles C. 86.4 moles D. 692 moles E. 346 moles
When the temperature is lowered, the speed at which molecules move is slowed. O False stly cloudy True O Search
10. A student reacted dilute nitric acid with lead(II) oxide to prepare lead(II) nitrate. The diagram shows the stages in the method used. 1 50 cm³ of dilute nitric acid was measured into a beaker DILUTE NITRIC ACID 3 The mixture was separated 2 Lead(II) oxide was added until all the nitric acid had reacted b. Why is the dilute nitric acid heated? heat a. Complete the boxes to identify the pieces of apparatus. 4 The solution was allowed to cool solution of -lead(II) nitrate
Temperature that is lowest A. 10.37 B. 38.10 C. 12.11 Temperature that is highest A. 10.37 B. 38.10 C. 12.11
What is occurring in section C? A B C temperature (°C) D time (minutes) t OA. Particles of a liquid are separating into a gas. B. Temperature of a liquid is rising. OC. Particles of a gas are condensing into a solid. OD. Particles of a solid are separating into a liquid. E
Convert the following measurement. 3 g kg 1.6 x 10 x10 mol · L mol · dL
Item 10 10 of 33 Complete I Review | Constants I Periodic Table Part A The compound MgCl2 is named dimagnesium chloride. magnesium chlorine. magnesium (II) chloride. magnesium dichloride. magnesium chloride.
You experimentally determine the rate of reaction at different temperatures while keeping the initial concentrations of the reactants constant. What relationship would you expect to find between temperature and rate? A. As temperature increases, rate decreases. B. As temperature increases, rate increases. C. Temperature has no effect on the rate of a chemical reaction. D. The relationship depends how many reactants are present.
Q2. Carbonic Anhydrase or carbonic dehydratase is a family of metalloenzymes containing zinc (Zn) ion in its active site. Carbonic anhydrase can greatly increase the rate of this reaction, reaching a reaction rate of 104 - 106 per second. It is defined as the enzyme found in red blood cells, other parts of animals and plants, that breaks down carbonic acid with carbon dioxide and water. CO:(2) – H»O(1) – H.CO:(ag) For the carbonic anhydrase activity specified by the equation above, evaluate the standard reaction Gibbs energy at 25 °C?
Magnesium will burn in air to form both Mg3N2 and MgO. What mass of each product would be found if burning a 3.29 g sample of magnesium to completion produces a combined total of 5.09 g of the two products?