A mineral particle of roughly spherical shape with a diameter of 0.02 mm was found to settle in a quiescent pool at a terminal speed of 3.6 m/hr in accordance to the Stokes’ Law. For the same mineral but with a smaller diameter of 0.01 mm, what is your estimate of the terminal settling velocity it will achieve?

Q: Which of the following statements is true?

A: The design parameters of setting tank includes loading rate of solids, overflow rate, side water…

Q: When a soil is submerged, the solid particles are subject to buoyancy caused by the water pressure…

A: Saturated as in context the voids are loaded up with the liquid say water, when we speak regarding…

Q: After an isocratic elution has been optimized with several solvents, the chromatogram has a…

A: There are basically two solvent delivery system in the gas chromatography technique First is…

Q: 1. In a series of triaxial compression tests on a sandstone, the following repre- sent the stresses…

A: As per company's policy, we can only answer first question only.Kindly send other questions as a…

Q: A given sludge with 98% moisture content is X times more bulky than with 95% moisture content. The…

A: "A given sludge with 98% moisture content is X times more bulky than with 95% moisture content."The…

Q: a)           What are the forces that influence the separation of minerals of different densities in…

A: Gravity concentration is a method of separation of the minerals that depends upon the difference in…

Q: What happens to the settling velocity under hindered conditions as you increase the concentration of…

A:

Q: A sample of saturated soil has a water content of 20% and the bulk unit weight os 19.8Kn/m^3…

A: water content = 20% bulk unit weight =19.8Kn/m3To find:a) Dry unit weight(b) the void ratio(c)…

Q: An experiment was conducted to determine the hydraulic conductivity of an artesian (i.e., pressured…

A: piezometric head difference=60-56=4mdistance between piezometers=150mtime to travel between…

Q: A cubic meter of dry (no water) quartz sand (G, = 2.65) with a porosity of 60% is immersed in an oil…

A: Vt = 1 m3Gs = 2.65n = 60% or 0.60 = 0.92 g/cm3 or 920 kg/m3 Vair = 0.27 m3

Q: Problem 14: An underground hard rock mine operation employs a 8 -m3 skip with an 14-tonne capacity…

A:

Q: A clay has a surface density of charge of one charge per 150 A˚ 2 . Its cation exchange capacity is…

A: Given are  Surface density Converting exchange capacity units to meq/ kg  We will be able to find…

Q: 1. Assumptions for using Darcy’s law. 1.1. Darcy’ Equation 1.2. Units of each parameter in Darcy’s…

A:

Q: The slope in the surface groundwater table is termed the __________.

A: The slope in the surface groundwater table is termed the hydraulic gradient.

Q: Compare the models of diffusion out of sediments with and without mass transfer resistances at the…

A: The sediment water interface is the boundary between the bottom or bed sediment and the overlying…

Q: Mean diameter of the particles present of the bottom of a channel is 5cm. If the value of chezy's…

A:

Q: A higher true density and a lower bulk density would mean what? A higher tapped density in relation…

A: Brief Concept- Density- The general term density means the ratio of the mass of the substance and…

Q: The definition of a clastic sedimentary rock would read as: Select one: O Composed of carbonate…

A: Clastic sedimentary rocks These rocks are made up of pieces of pre existing rocks. These pieces of…

Q: The dimensions of a cylindrical core sample are 10.16 cm long and 3.81 cm in diameter after it was…

A: This question is related to the Soil Mechanics.

Q: A large piece of dry rock as a mass of 2450 kg and volume of 0.925 m. The specific gravity of the…

A: Given data : Mass of  dry rock (MDry)=2450 kgVolume of dry rock (VDry)=0.925 m3Specific gravity…

Q: In a laboratory test of an aquifer materia fully saturated sample of volume 5 liters was taken and…

A: Given:- V=5litres W=97N To find:- unit weight of water =9.79kN/m3 To find:- specific yield and…

Q: The velocity of a particle traveling along a straight line is v = (8t2 - 9t) ft/min, where t is in…

A:

Q: The water content of a sample of Fully Saturation is 3.23% and the specific gravity was found to be…

A:

Q: The liquid limit and plastic limit of clay materials is 45% and 25% respectively, what is the…

A:

Q: lon concentrations obtained for a ground water sample (having pH = 8.1) are given below Ion Ca²+…

A: To Determine :-  Carbonate hardness present in the given water sample.

Q: A water sample having a pH of 10 at 25°C contains the following ions: Na* = 56 mg/1 Mg²+ = 24 mg/1…

A:

Q: According to AS 1726, specify the symbols and generic names used for coarse,medium and fine grain…

A: In AS 1726, which is an Australian Standard, sands are classified based on their grain size using…

Q: 6 Core samples were taken randomly from a heterogeneous reservoir. The measured absolute…

A: Solution: Given Data: Core sample      Height      C/s Areacm         Porosity…

Q: Find Void ralio Juen geo porasity

A: We knowPorsity=Volume of voidsVolume of Soiln=.VvVn=VVVV+VSn=VVVSVVVS+1we knowe=VVVSso,n=ee+1

Q: Consider a saturated clay layer of thickness of 6 m on top of a layer of stiff sand. The clay has an…

A:

Q: A sample of water has been analyzed for common ions and results are presented in the form of a bar…

A:

Q: concentration was found to be 150 mg/L. Given k20°c = 0.20/day (base e) and temperature coefficient…

A: Given data-   BOD of 3 days  at 20° C  = 150 mg/L  K 20° C = 0.20/day  temperature coefficient for…

Q: Suppose the A horizon of your soil is 5 inches thick, with a bulk density of 1.03 g soil/cm3 soil,…

A: Furrow slice  Description. The plow turns up a chunk of the earth called a furrow slice. (Depth up…

Q: Estimate the teminal settling velocity in water at a temperature of 15 °C of spherical silicon…

A:

Q: A cubic rock sample has the following dimensions: 33 cm x 12 cm x 24 cm. If the porosity of the rock…

A: given  dimensions of cube=33 cm×12 cm ×24 cm VT=total volume = 33×12×24=9504 cm3 VP= pore volume n=…

Q: The liquid limit and plastic limit of clay materials is 45% and 25% respectively, what is the…

A: given- Liquid limit LL=45%Plastic limit PL=25%% of clay materials=20%

Q: Calculate the Porosity. Area = 16468 acres

A: Porosity provides information of void spaces in a material. Also known as void fraction.

Q: The volume of a reservoir is 2×107 m3, the catchment area is 500 km2, the average annual inflow of…

A: