A mild steel plate has to be rolled in one pass such that the final plate thickness is 2/3rd of the initial thickness, with the entrance speed of 10 m/min and roll diameter of 500 mm. If the plate widens by 2% during rolling, the exit velocity (in m/min)

A mild steel plate has to be rolled in one pass such that the final plate thickness is 2/3rd of the initial thickness, with the entrance speed of 10 m/min and roll diameter of 500 mm. If the plate widens by 2% during rolling, the exit velocity (in m/min)

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Q3) Explain briefly the relationship between the load-stroke in open die forging as illustrated in the figures bellow. Take in consideration the effect of coefficient of friction. 1500- 1000- 500 75 62 49 36 h (mm) 13 26 39 (h.-h) Stroke Forging force (1000 N)
A tube of 12 mm external diameter and 1mm thickness is to be reduced to 16 mm external diameter and 0.5 mm thickness. The die angle is 24º and plug angle is 16º. The coefficients of friction at die and tube interface and tube and plug (mandrel) interface is 0.5. The flow stress of tube material is 340 N/mm2 . The tube drawing is carried at a speed of 0.4 m/s. Calculate the fixed plug
None
How can we find the value of shear flow?
04: In Flat Strip Open Forging (FSOF) Process, A strip ingot of length (90.5mm), width (4.75cm), and initial thickness (1.75cm), is open forging to thickness (15mm). The mean flow stress o y 280+110, and friction facter (0.065), Determine the maximum plate pressure and the press capacity at. (1) forging anset. (II) forging end. 96.5mm
Do please
find the die shape factor in an extrusion process, if the diameter of the extruded cross-section is =15 cm and the diameter of the circle of the same area as the extruded shape is = 10 cm
the work metal has a flow curve defined by K=300MPa and n=0.2, and the coefficient of friction between the rolls and the work is assumed to be 0.1. a 250mm wide strip 2.0cm thick is fed through a rolling mill with two powered rolls each of radius=300mm. the work thickness is to be reduced to 18mm in one pass at a roll speed of 50rev/min. what will be the power for this operation?
Answer the following questions:
Calculate (1) die pressure distribution and (2) forging force for plane strain forging (open die forging). Assume yield strength of the material is Y, and yielding criterion is von Mises. ho 2Lo h Forged to 2L xdx L 'x+value Note: Assume Zo Constant Plane strain Die pressure distribution h L L Die pressure distribution h MATERIAL L dx -(-1) Friction Hill Y L When 0; =Y P=Y' = Calculate forging force X L dF elemental volume Average pressure
I need the answer as soon as possible
Would you kindly answer this question A rolling operation on a 250 mm wide, 8 mm thick, 1112 cold rolled steel takes place using hardened steel rolls with a surface finish of 0.03 μm. The rolls have a diameter of 350 mm and rotates at 115 rpm. The final thickness of the plate is 6 mm and the entry speed of the plate is 1.8 m/s. Calculate: 3.1 The minimum coefficient of friction required, that will make the rolling operation possible. 3.2 The required roll force. 3.3 The position of the neutral point, ?? 3.4 Indicate, using a sketch, the neutral point showing all relevant notation and dimensions.