Answered: A metal rod slides along two metal… | bartleby

Related questions

Question

A metal rod slides along two metal rails. The rails are connected to a resistor R, forming a complete circuit. What would the direction of the current in the circuit be if the direction of the magnetic field is into the page?

Expert Solution

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

She then uses a permanent magnet of strength B = 0.5 mT to induce a voltage in the (same) coil. Calculate the expected voltage if she pulls the magnet from the coil in 0.03 seconds.
(b) Figure 6 shows a metal plate moves with constant velocity through a uniform magnetic field, B. The magnitude of the magnetic field is 2.0 mT directed perpendicular to the plate. The dimension of the plate is 5.0 cm long, 0.5 cm wide and 1.0 mm thick. If the metal plate moves with the speed of 1.0 m/s, calculate the potential difference generated between points x and y across the plates. х В Figure 6
When the current flows clockwise on a 2D diagram of a circuit, what is the direction of the magnetic field, clockwise, counter-clockwise, into the page, or out of the page?
A thin 50 cm (0.5 m) long metal bar with mass 0.75 kg rests on (but is not attached to) two metallic supports in a uniform 0.45 T magnetic field as shown in the figure. A battery and a 25 Ω resistor in series are connected to the supports.Find the highest voltage the battery can have wihtout breaking the circuit and the initial acceleration of the bar if the resistor decreased resistance to 2 ohms.
In the figure below, a metal bar sitting on 2 parallel conducting rails connected to each other by a resistor is pulled to the right at a constant speed. The resistance R=9 ohms, the distance between the rails is l=1.2m and a uniform 2.10T magnetic field is directed into the page. At what speed (m/s) should the bar be moved to produce a current of .500 A in the resistor?
What is the value of the Magnetic Flux through one loop when it is at an angle of 59 degdeg to the face of the table ? What is the value of the Flux when one loop is on the table ?