A mercury manometer is connected to a pipeline carrying water at 150 degrees Fahrenheit and located in a room where the temperature is also 150 degrees Fahrenheit. If the elevation of point B is 6 ft above A and the mercury manometer reading is 48 in, what is the pressure in the pipe in psi? Be as precise as possible, and note the effect of temperature. Note that at 150 degrees Fahrenheit the specific gravity of mercury is 13.45. (b) Repeat, assuming all temperatures are 68 degrees Fahrenheit. * Patm Rm B'-B |c+ SM Figure 3.11

A mercury manometer is connected to a pipeline carrying water at 150 degrees Fahrenheit and located in a room where the temperature is also 150 degrees Fahrenheit. If the elevation of point B is 6 ft above A and the mercury manometer reading is 48 in, what is the pressure in the pipe in psi? Be as precise as possible, and note the effect of temperature. Note that at 150 degrees Fahrenheit the specific gravity of mercury is 13.45. (b) Repeat, assuming all temperatures are 68 degrees Fahrenheit. * Patm Rm B'-B |c+ SM Figure 3.11

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: 3. An object with a temperature of 88°C is placed into the water of 25°C. After 15 minutes, the…

A: To given problem can be solved using newton law of cooling, Let, ∅ = temp. of given body ∅∘…

Q: At 15°C water temperature, vapor pressure of water is 1.70 kN/m“. The saturation vapor pressure at…

Q: Construct a vertical U-tube manometer to measure the pressure difference across a flow section.…

A: U-tube Manometer - A U-tube manometer consist of a glass tube of U shape, whose one end is…

Q: Calculate the percent error in the system if the specific weight of the air is to be neglected.…

Q: Two pipes namely A and B are connected by a mercury manometer (SHg = 13.6). The fluid in both pipes…

A: SHg=13.6 To find h'

Q: Taking the coefficient of compressibility of water to be 2200 MPa, determine the pressure increase…

Q: If the pressure in a tank of oil (spec. gr.= 0.80) is 60 lb/in 2 , what is the equivalent pressure…

Q: For the shown inverted manometer, all fluids are at 20°C. If P - P = 97 kPa, what must the height X…

A: Using concept of Pressure in left limb of manometer = pressure in right limb solution = 1.31m

Q: A 90-Pa capacity manometer has a reading error of + 0.421 mm. Determine the ratio of d/D so that the…

Q: A manometer is attached to a water tank as shown in the figure. Find the pressure at the interface…

Q: Water is flowing at a rate of 8 ft³/s in a rectangular channel with a 2 ft water depth and a 4 ft…

Q: 14 in, da measures 3 in. If SGmercury is 13.55, a) calculate the pressure difference (in psi)…

Q: PROBLEM 10: For the manometers shown, Determine the 18 in difference in pressure between A and B in…

Q: Describe Components of Menard-type pressuremeter.

A: pressuremeter: Pressuremeter test on soil is very easy and quick way of calculating stress-strain…

Q: Oil with specific gravity of 0.88 flows through a pipe which changes from 6 in. at section A to 18…

Q: what is the pressure (in Pa) at the higher center (P₂) if H=

Q: Problem 1: A closed tank contains 0.5m of air, 1.5 of oil, 1.0 of water and 10cm of mercury. The…

A: A closed tank with 0.5 m of air, 1.5 m of oil, 1 m of water, and 0.1m of Hg. The gauge pressure…

Q: Explain the Menard-type pressuremeter: Components and operating principles.

A: A pressuremeter is a device that is used for determination of the relations of stress strain of…

Q: Atmospheric pressure is 1 atm. Find pressure of gas in terms of atm;lf system is open manometer, and…

Q: The cyclindrical tank with hemispherical ends shown in the figure below contains a volatile liquid…

A: Let Point A at the surface of liquid & Point B at 1m below the surface of liquid. Given density…

Q: A tank is fitted with a manometer on the side, as shown. The liquid in the bottom of the tank and in…

Q: Please help with solving

Q: 2. If the absolute pressure in a tank is 140 kPa, determine the pressure head in mm of mercury. The…

Q: A pressure gauge at elevation 3 m at the side of a tank containing a liquid reads 88 kPa. Another…

A: Given Depths 11m and 3mPressures 122 and 88 kPaTo find out Specific gravity NoteDensity of water =…

Q: 4. In figure, fluids A and B have specific gravities of 0.75 and 1.00, respectively. If mercury is…

A: Given data : S.GA=0.75S.GB=1.00

Q: An open tube is attached to a tank as shown. If Liquid X (Water) rises to a height of 800 mm in the…

Q: The velocity through the throat of a venturi meter is four times that of the velocity through a pipe…

Q: nere are two (2) mercury barometers at the mountain. At the top reads 500 mm and at the base reads…

A: To find the height of the mountain (H)-

Q: Gasoline line is connected pressure gage through a double-U manometer, as shown in Figure (1). If…

A: The given figure is shown below:

Q: Question 1 a) Figure Q1 (a) shows manometer connected a piston A. The piston A has diameter 0.1m…

A: Figure is as shown

Q: water up to a height of

A: To find : Location of center of pressure

Q: 10. The compartment B and C below are closed and filled with air. The barometer reads 1.02 kg/cm².…

Q: 20 P Dinby given, m? 01 000 cific

Question

A mercury manometer is
connected to a pipeline carrying
water at 150 degrees Fahrenheit
and located in a room where the
temperature is also 150 degrees
Fahrenheit. If the elevation of point
B is 6 ft above A and the mercury
manometer reading is 48 in, what is
the pressure in the pipe in psi? Be
as precise as possible, and note the
effect of temperature. Note that at
150 degrees Fahrenheit the specific
gravity of mercury is 13.45. (b)
Repeat, assuming all temperatures
are 68 degrees Fahrenheit. *
Patm
Rm
B'-B
|c+
SM
Figure 3.11

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1 Interpretation of data

VIEW

Step 2 Primary calculations

VIEW

Step 3 Calculations for pressure

VIEW

Step 4 Calculations for pressure when the temperature = 68 degree F

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 4 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

I need the answer as soon as possible
A docs.google.com/forms/d/e/1FAlpQLSetk8UE/ PROBLEM 6: A gasoline line is connected to a pressure gage through a double-U manometer, as shown. If the reading of the pressure gage is 260 kPa, determine the gage pressure of the gasoline line. Assume the density of air to be 1.225 kg/m3 * Oil SG = 0.79 P gage = 260 kPa Gasoline SG= 0.70 Pipe Air 45 cm 50 cm 22 cm 10 cm Mercury SG= 13.6 Water Your answer
I need the answer to the question in fluids
An oil of specific gravity 0.89 is flowing through a horizontal venturimeter fitted to a 242 mm diameter pipe at the rate of 108 liters/s and throat diameter is 98 mm. The entrance and throat of the venturimeter are connected in the two limbs of a U-tube mercury manometer. The difference in mercury level shows 841 mm. Calculate (i) the head difference in m of oil, (ii) the theoretical discharge in m3/s, (iii) the actual discharge in m3/s, and (iv) the coefficient of discharge of a venturimeter. If instead of a U-tube mercury manometer, the pressure gauges are inserted at the entrance and throat of venturimeter. Find (v) the pressure at the throat in N/mm2, if the entrance pressure gauge shows0.13 N/mm2.
please solve in 40 mins i need help i will give you positive feedback
A pressure gage 10.52 m. above the bottom of a tank containing a liquid reads 58.5 kPa; another gage at height 3.16 m. reads 85.83 kPa. Determine the density of the liquid. Round off to three decimal places.
Note: please indicate the labeled diagram and complete formula and solution. A Venturi meter 45 cm by 25 cm has its axis inclined upwards by 400 from the horizontal. The distance measured along the axis, from the inlet to the throat is 1.50m. The differential manometer connected at the inlet and throat shows a deflection of 20 cm of mercury. If the flow is upward and the flowing fluid has specific gravity of 2.5, find the discharge and the pressure head difference between the inlet and throat if the meter coefficient is 0.97.
A manometer is attached to a tank containing three different fluids. Find the value of y in the mercury column in the manometer