/A mechanic has an engine from a 1950 model car which works on the basiS of Otto cycle. The engine displaces 1.8 liters, has a compression ratio of 10.2:1 and has six cylinders. The piston in the original engine are 120 mm in diameter. The mechanic bores the cylinder and replaces the piston with new pistons that are 2 mm larger in diameter than the originals. Keeping all other factors same. (a) What will be the percentage change in power output? (b) By what percentage will the engine efficiency change?

/A mechanic has an engine from a 1950 model car which works on the basiS of Otto cycle. The engine displaces 1.8 liters, has a compression ratio of 10.2:1 and has six cylinders. The piston in the original engine are 120 mm in diameter. The mechanic bores the cylinder and replaces the piston with new pistons that are 2 mm larger in diameter than the originals. Keeping all other factors same. (a) What will be the percentage change in power output? (b) By what percentage will the engine efficiency change?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

What kind of crankshaft should you use for a v-type engine with 12-cylinder assembly?
1. Discuss an Internal combustion Engine? 2. Briefly explain a 2 and 4 stroke Engines and how each operation. Add a caption... > Status (Contacts)
A cranking compression test i did gave the following results i had 155 psi in cylinder 1 and 140 psi in cylinder 2 and ihad 145 psi in cylinder 3 and i had 105 psi in cylinder 4. Would it be a burnt intake valve or a defective head gasket?
Describe a 4-stroke compression ignition engine operation with neat sketches.
6. Two-stroke engine is more efficient than four-stroke engine as: (a) Njaturally aspirated SIE (b) Naturally aspirated CIE (c) Turbocharged SIE (d) Turbocharged CIE
When the car engine is cold, the main cooling cycle is blocked to allow good oil filtration. O increase the engine temperature up O to the optimum engine temperature. easier to be derived. O be better for transmission system. O replace radiator cap. O
Describe how would you check an engine for internal wear without dismantling the engine?
a.) A four-stroke reciprocating engine have a 2000 indicated horsepower. What would be the indicated mean effective pressure (lb/in^2) if the length of the stroke is 0.5 foot, and the area of the piston head is 28.27in^2. The engine runs at 2700rpm with 12 cylinders. b.) What would be the Friction Horsepower of the Engine in (a.) if its BMEP is 150 lb/in^2.
Question 1 Draw and explain the four stroke petrol engine. Label the various parts on the schematics of these engines. Draw p-v and T-s diagrams. Question 2 Draw and explain the four stroke diesel engine. Label the various parts on the schematics of these engines. Draw p-v and T-s diagrams. Question 3 Make a table of differences between 4s and 2s engines. Question 4 Make a table of differences between petrol and diesel engines. Question 5 What is supercharging? Why it is considered in the IC engines. What is the difference between supercharging and turbocharging? Draw a neat sketch of turbocharger and label the diagram.
For THERMODYNAMICs
Discuss the main functions of the lubricating system of an engine