A liquid feed of pure A (1 mole/liter) is treated in two reactors of 2-liter volume each and reacts with a rate of rA=0.05 CA2, mole/liter-sec. Find what feed rate in liters/min that will give a final outlet concentration of CA=0.50 mole/liter if a CSTR and plug flow reactor hooked up in parallel are used.

Q: The ff rxns occurs in a constant temperature constant volume batch reactor with k₁=0.05/min,…

A: Given data: k1=0.05 min-1k2=0.025 min-1k3=0.015 min-1k4=0.008 min-1CAO=10 mol/litt=30 min

Q: A reversible reaction A + BeR + S was performed in a liquid-phase batch reactor. Several samples…

A: Given Reversible reaction A+B⇌ R+S Liquid phase batch reactor Normality=0.675N Volume of sample…

Q: A liquid phase that is homogeneous as well as irreversible reaction X → Y proceeds where temperature…

A: Given:  Xx  = 70% = 0.7  Cxo  = 10 mol X/ L  vo = 3 L/min k = 0.15  -rx = k Cx1.5  = k [ Cxo - Cxo…

Q: A liquid feed of pure A (1 mole/liter) is treated in two reactors of 2-liter volume each and reacts…

A: Give data: Initial concentration of A = 1 mol/L Volume of each reactor = 2 L The rate equation (-rA)…

Q: SO2 concentration in the flue gas of a coal burning power station is 1,300 ppm. The molar flow rate…

A: Find -The dewatered sludge mass flow rate Given:Flue gas molar flow rate Flue gas temperature…

Q: rate of 100 kmol/hr, Calculate the molar flow rate and composition of the purge gas, and the overall…

A:

Q: In a petrochemical plant, it is desired to produce 2282.30 g/min of acetylene (C,H2) from pure…

A: Given data: Rate of acetylene production = 2282.3 g/min Volume of PFR = 3 m3 Conversion of ethane =…

Q: In a distillation tower, a mixture of two components A and B with equal molar ratio and a rate of…

A: Following questions are asked to answer. Flow rates of each components Expression for rectifying…

Q: A liquid feed of pure A (1 mole/liter) is treated in two reactors of 2-liter volume each and reacts…

A: Given Data (Reactors connected in series)  The molar concentration of pure A (CA0)= 1 mol/litre  The…

Q: In the R&D (research and development plant) the elementary gas-phase reaction of organic compound is…

A: Given: At T1 = 60 oC or 333 K, the rate constant is K = 0.004 min-1 Partial pressure of A i.e. PA =…

Q: A liquid reactant solution is pumped through a pre-heater before entering a reaction vessel. The…

A: a) and b) The liquid reactant at a temperature of 25oC is pre-heated before it enters the reactor.…

Q: With respect to the above reaction, calculate the rate at which heat must be transferred to or from…

A: The flow chart for the given system is:

Q: You can assume constant molar flow rates 2. A distillation column with eight equilibrium stages and…

A: a) given = no of equilibrium stage = 8 xd = 0.95 xf = 0.5 relative volatility = 2.5 = α we know that…

Q: 03:0.75 lbm/min of C3H8 is burned at 77 °F with 150 percent excess air that enters the furnace at 40…

A:

Q: A liquid feed of pure A (1 mole/liter) is treated in two reactors of 2-liter volume each and reacts…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Determine the number of equilibrium stages and optimal-stage locations for the feed and liquid…

A:

Q: A distillation column is separating component A from Component B. Component A is the MVC. The column…

A: The minimum reflux ratio for the distillation process is to be calculated.

Q: Aqueous A at a concentration CA0 = 1 mol/liter is introduced into a batch reactor where it reacts…

A: First, draw the graph of t vs CA to find the value of the rate constant:

Q: A continuously operating distillation column is fed 40% ethanol and 60% propanol by weight at a…

A: A mixture of ethanol and propane is fed to a continuous distillation column, with the following…

Q: between the mole fractions of methanol in the vapour and liquid phases is y* = 4x. The ratio of…

A: Given that  Feed flow rate ,F =1000 kmol/h Xf= 0.5 Y*=4x      D/F = 0.5

Q: A partial oxidation is carried out by bubbling air through a batch of liquid in a pressurized…

A: Partial oxidation -In batch of liquid by bubbling air in a pressurized reactor D=3m and h=5m…

Q: Q3: One example of synthetic gas is the off-gases from a gasoline stabiliser that fed to a reforming…

A: Given that, The mole fraction of CH4 in the off-gas xCH4 = 0.775 The mole fraction of C2H6 in the…

Q: In a distillation tower, two-component mixtures A and B are introduced by two streams, one with…

A: Following questions are asked to answer. Flow rates of each components Expression for rectifying…

Q: Fuel used as the main energy source for incineration contains M% of carbon. The amount of carbon…

A:

Q: b. Fuel used as the main energy source for incineration contains M% of carbon. The amount of carbon…

A:

Q: A distillation column is separating component A from Component B. Component A is the MVC. The column…

A: Distillation is a process of separation of liquid components from the liquid mixture. Distillation…

Q: In the cooling section, the fresh milk input is at a flow rate of 187.5 L/h with an initial cow-body…

A: Given data: Flow rate of milk=187.5L/h Cow-body temperature=38.6oC which is stored at 5oC or below.…

Q: A plug flow reactor (PFR) with a volume of 120 m has been designed to degrade a pollutant from a…

A: Given: Volume of the plug flow reactor (PFR), V = 120 m3 Volumetric flow rate of the waste stream, v…

Q: Assume we have a bioreactor where the following two reactions are taking place. The bioreactor has…

A: Hi and thanks for the question. Since you have posted a question with multiple subparts, we will…

Q: Q.1A distillation column receives a feed that is 40 mole % n-pentane (Cs) and 60 mole % n-hexane…

A: F=2500 lb/hr xF=0.4 xD=0.97 xB=0.02 Overall material balance equation: F=B+D  2500=B+DD=2500-B…

Q: A plug flow reactor operating at 30 °C is to be used for the first order reaction of substance A in…

A: Plug flow reactor T=30℃ First order reaction Liquid phase reaction CA0=2 kmol/m3 FA0=0.07 kmol/s k=…

Q: Q.1 A hydrocarbon gas A is fed continuously to a mixed flow reactor at 450°C and pressure 6 atm,…

A:

Q: 8

A: To find the pressure drop across the catalyst bed in a fixed-bed catalytic reactor, you can use…

Q: In a distillation tower, a mixture of two components A and B with equal molar ratio and a rate of…

A:

Q: a continuous-stirred tank reactor where is receiving a feed of 200 liters per hour and a reactant…

A:

Q: In a distillation tower, a mixture of two components A and B with equal molar ratio and a rate of…

A: Given: Consider the below schematic diagram for the distillation column with a feed of 10,000…

Q: Fuel used as the main energy source for incineration contains M% of carbon. The amount of carbon…

A: