Why does the answer of this problem consider radial stress if it is a thin walled? A light pressure vessel is made of 2024-T3 aluminum alloy tubing with suitable end closures.This cylinder has a 3/-in OD, a 0.065-in wall thickness, and v= 0.334. The purchase orderspecifies a minimum yield strength of 46 kpsi. Using the distortion-energy theory, determinethe factor of safety if the pressure-release valve is set at 500 psi.

Answered: Image /qna-images/answer/dcc20a58-c067-4a6d-bcff-fed2973668f1.jpg

A light pressure vessel is made of 2024-T3 aluminum alloy tubing with suitable end closures. This cylinder has a 31-in OD, a 0.065-in wall thickness, and v= 0.334. The purchase order specifies a minimum yield strength of 46 kpsi. Using the distortion-energy theory, determine the factor of safety if the pressure-release valve is set at 500 psi.

A light pressure vessel is made of 2024-T3 aluminum alloy tubing with suitable end closures. This cylinder has a 31-in OD, a 0.065-in wall thickness, and v= 0.334. The purchase order specifies a minimum yield strength of 46 kpsi. Using the distortion-energy theory, determine the factor of safety if the pressure-release valve is set at 500 psi.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Where is maximal torsional stress experienced?
I need the answer quickly
Drive the relation of stress transformation.
For a plate with inside hole under tension, the stress concentration will Select one: a. decrease with the hole increasing b. increase with the hole increasing C. the hole does not cause any stress concentrations d. need more information
Statement: At any point in a body subjected to load, therer are different stresses or cominations of stresses developed on planes of different inclinations. Question: Is the above statement true or not true? Yes No
[4] In thin walled sphere, the wall is subjected to A. Hoop stress only B. Longitudinal stress only. C. Both A & B D. Radial stress only ترك ترك السوال کاملا [5] When the bar subjected to torque, the maximum shear stress occur at. A. External surface of the bar B. Middle of the bar A. Distance below the external surface D. Both A & B ترك السوال کاملا
please answer quickly
Example 4.5 (Stress on a shrunk fit cylinder): A shrunk fit thick cylinder made of steel having an inner radius 8cm, interface radius 10 cm and outer radius 12 cm is subjected to an external pressure of -0.09M Pa. Internal pres- sure is atmospheric. Given that the shrinkage is 0.02 cm. Determine the radial and tangential stress distribution across the the thickness of the cylin- der (2) before loading with pressure and (b) after loading with pressure. The equation for the contact pressure with usual notations is given as AE(c² – a²)(b² – c²) Pc = 2c°(b² – a²) Take E = 200 x 106 kPa.
i need the answer quickly
I need answer within 20 minutes please please with my best wishes
A wire with circular base of radius 3 mm was subjected to tensile stress of 13.5 N. If half the amount of stress is to be applied to a wire with square base of 1.86 mm width, what must have been the force (in Newton) applied to this new wire?
Please solve it quickly