A layer of sand 6 m thick lies beneath a clay stratum 5 m thick and above abed thick shale. In order to determine the permeability of sand, a well was driven to the top of the shale and water pumped out at a rate of 0.01m3/sec. Two observation wells driven through the clay at 15m and 30 m from the pumping well and water was found to rise to levels of 3m and 2.4 m below the ground water surface. Calculate the permeability of soil.

A layer of sand 6 m thick lies beneath a clay stratum 5 m thick and above abed thick shale. In order to determine the permeability of sand, a well was driven to the top of the shale and water pumped out at a rate of 0.01m3/sec. Two observation wells driven through the clay at 15m and 30 m from the pumping well and water was found to rise to levels of 3m and 2.4 m below the ground water surface. Calculate the permeability of soil.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

(e) A soil profile consists of a clay layer between layers of sand, the water table being in theupper sand layer. Before the construction of a raft foundation for a large reservoir, piezometers were placed in the saturated clay layer. The whole process of filling the reservoir may be approximated to applying rapidly a single pressure increment of 200 kPa uniformly throughout the clay layer. One year after filling the reservoir, the piezometers indicated a distribution of excess porewater pressure as indicated in Figure Q-e. Estimate the average degree of consolidation at this time.
11.15 For a normally consolidated σ = 2 ton/ft² • σ + A' = 4 ton/ft²2 • e = 0.96 The hydraulic conductivity k of the clay for the preceding loading range is 1.8 x 10 ft/day. • clay, the following are given: • e = e = 1.21 a. How long (in days) will it take for a 9 ft thick clay layer (drained on one side) in the field to reach 60% consolidation? b. What is the settlement at that time (that is, at 60% consolidation)?
In a drained triaxial test on consolidated clay the stress and angle are as follows : Deviator stress is 20 lb/in2 and friction angle 210 . calculate the effective confining pressure at failure.?
It is known that a particular deposit of clay has the following shear strength parameters: c' = 15 kPa, o' = 23°; Cu = 10 kPa, cu = 13° A sample of this clay is consolidated in a triaxial cell to an all-round pressure (03) of 250 kPa. The sample is then sheared by increasing 0₁, keeping 3 constant and the drainage valve closed. What is: i) ₁ at failure? ii) Pore water pressure inside the sample at failure? iii) Final values of 0₁' and 03'? iv) Value at failure of Skempton's pore pressure coefficient A?
1) A dry rock weighs 240 grams and has a bulk density of 2.5 grams per cubic centimeter. Whensaturated with pure water at room temperature (T = 25 °C), it weighs 255 grams. At room temperature,specific volume of water is 1.00295E-03 m3/kg. Calculate the porosity of the sample. 2) A cylindrical core sample of 1.5 cm length and 1.2 cm2cross-section has upstream and downstreampressures of 2 atm and 1.25 atm, respectively, during steady state flow of water at 1.00 g/s at roomtemperature. Calculate the permeability of the core. (Water @ 25 °C, viscosity = 1 cp, density of water = 0.997 g/cm3).
Question 20 A soil profile consists of sand (5-m thick) which overlies a layer of clay (9-m thick). Ground water table is located at the interface of the sand and clay. The effective stress at the bottom of the clay layer was determined. If the water table rises to the top of the ground surface, what is the change in the effective stress (in kPa) at the bottom of the clay layer? For sand layer: Void Ratio = 0.82, Specific gravity = 2.68, Degree of Saturation = 0.6 For clay layer: Void Ratio = 0.92, Specific gravity = 2.86 Round off to two decimal places.
Situation 3:The water table in a certain deposit of soil is at a depth of 2m below the ground surface. The soil consists of clay up to depth of 4m from the ground and below which lies sand. The clay soil is saturated even above the water table:Clay strata: ? = 30%, ?? = 2.72Sandy Strata: ? = 26%, ?? = 2.64 1. Compute the total pressure.2. Compute the pore water pressure.3.Compute the effective stress pressure at a depth of 8m below the ground surface.
For a laboratory consolidation test on a clay specimen (drained on both sides), the followingresults were obtained. (7.5)Thickness of the clay layer = 25 mmP1= 100 kN/m2 e1= 0.81P2= 200 kN/m2 e2= 0.73Time for consolidation (t50) = 3.4 minDetermine the hydraulic conductivity of the clay for the loading range
Question-3: (a) In a consolidated drained triaxial test, a specimen of saturated sand failed under an deviator stress of 250 kN/m², when the cell pressure was 100 kN/m². i. Illustrate by drawing the Mohr circle for the failure stress condition. Solve for ø' and the theoretical inclination of the failure plane to the ii. horizontal. iii. failure. iv. Solve for the shear stress on the failure plane and maximum shear stress at Solve for factor of safety with respect to shear strength on the plane of maximum shear stress?
Effective Stress in Soil Problem 1. The water table in a certain deposit of soil is at a depth of 2m below the ground surface. The soil consists of clay up to depth of 4m from the ground and below which lies sand. The clay soil is saturated even above the water table: Clay strata: ? = 30%,?? = 2.72 Sandy Strata: ? = 26%, ?? = 2.64 1. Compute the total pressure. 2. Compute the pore water pressure. 3. Compute the effective stress pressure at a depth of 8m below the ground surface
In a drained triaxial test on consolidated clay the stress and angle are as follows: Deviator stress is 20 lb/in2 and friction angle is 21°. Calculate the effective confining pressure at failure.? a) 21 lb/in2 b) 22.2 lb/in2 c) 25.4 lb/in 2 d) 17.9 lb/in2
The water table is lowered from a depth of 3 m to a depth of 6 m in a deposit of silt. The silt remains saturated even after the water table is lowered. What would be the increase in the effective stress in kPa at a depth of 3 m and at 10 m on account of lowering of the water table? Assume the water content as 27% and grain specific gravity 2.67. a.29.43 b.88.29 c.117.72 d.58.86