A large storage tank, open at the top and filled with water, develops a small hole in its side at a point 17.0 m below the water level. The rate of flow from the leak is found to be 2.20 X 10-3 m3/min. 1 ა C Show Transcribed Text a. Determine the speed (in m/s) at which the water leaves the hole. answer- m/s b.Determine the diameter of the hole (in mm). answer- mm c. If the hole is 10.0 m above the ground and the water is projected horizontally from the hole, how far (in m) from the base of the tank would a bucket have to be initially placed to catch the water from the leak? answer- m

A large storage tank, open at the top and filled with water, develops a small hole in its side at a point 17.0 m below the water level. The rate of flow from the leak is found to be 2.20 X 10-3 m3/min. 1 ა C Show Transcribed Text a. Determine the speed (in m/s) at which the water leaves the hole. answer- m/s b.Determine the diameter of the hole (in mm). answer- mm c. If the hole is 10.0 m above the ground and the water is projected horizontally from the hole, how far (in m) from the base of the tank would a bucket have to be initially placed to catch the water from the leak? answer- m

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter14: Fluid Mechanics

Section: Chapter Questions

Problem 88P: (a) Using Bernoulli's equation, show that be measured fluid speed v for a pitot tube, like the one...

See similar textbooks

Similar questions

(a) Using Bernoulli's equation, show that be measured fluid speed v for a pitot tube, like the one in figure 14.32(b), is given by v=( 2gh)1/h , where h is be height of be manometer fluid, p' is the density of the manometer fluid, p is the density of the moving fluid, and g is be acceleration due to gravity. (Note that v is indeed proportional to the square root of h, as stated in text) (b) Calculate v for moving air if a mercury manometer's h is 0.200 m. Figure 14.32 Measurement of fluid speed on Bernoulli’s principle. (a) A manometer is connected to two tubes close together and small enough not to disturb the flow. Tube 1 is open at the end facing the flow. A dead spot having zero speed is created there. Tube 2 has an opening on the side, so the fluid has a speed v across; thus, pressure there drops. The difference in pressure at the manometer is 12v22 , so h is proportional to . 12v22 (b) This type of velocity measuring device is a Prandtl tube, also known as a pitot tube.
The flow of blood through a 2.00106 m -radius capillary is 3.80109cm3/s . (a) What is the speed of be blood now? (b) Assuming all the blood in the body passes through capillaries, how many of them must there be to carry a total flow of 90.0 cm3/s?
A container of water has a cross-sectional area of A=0.1m2 . A piston sits top of the water (see be following figure). There is a spout located 0.15 m from the bottom of tank, open to the atmosphere, and a stream of water exits the spout. The cross sectional area of the spat is As=7.0104m2 . (a) What is the velocity of the water as it leaves the spout? (b) If the opening of the spout is located 1.5 m above the grand, how far from be pout does water hit the floor? Ignore friction and dissipative forces.
The inside diameters of the larger portions of the horizontal pipe depicted in the figure below are 2.64 cm. Water flows to the right at a rate of 1.52 x 10-4 m³/s. Determine the inside diameter of the constriction. cm 10.0 cm 5.00 cm i a V Y ld ag
A Venturi tube is used to measure flow rate of 37 l/s. Tube diameter is 125 mm and throat diameter is 89 mm. Water density is 1000 kg/m³. Calculate the pressure difference Ap= P₁-P2 between the tube and the throat, using continuity equation and Bernoulli's equation. Round off the answer to one decimal digit in kPa, but enter the answer without the unit. Answer:
Calculate the absolute pressure at an ocean depth of 1.4 km. Assume that the density of Water Pwater is 1.025 × 10³ kg/m³ and the atmospheric pressure, Patmosphere = 1.01 × 10$ Pa. (Use: acceleration due to gravity, g=9.8 m/s?) Select one: a. 1.42 x 107 Pa b. 1.15 x 10s Pa Oc102 × 106 Pa
A pumped fluid distribution system is being designed to deliver Q=200 gal/min of water to a cooling system in a power generation plant. Read the corresponding flow areas in m2 of discharge line Ad from Appendix F _________ A. 3.090 x 10^-3 m^2 B.1.314 x 10^-3 m^2 C.4.768 x 10^-3 m^2 D.2.168 x 10^-3 m^2
A teenager is stealing gasoline from his father's car with a siphon with diameter of 12 mm. The heights in the figure are: z1 = 970 mm and z2 = 181 mm. Calculate the volumetric flow rate out of the tank. Round off the answer to two decimal digits in l/s, but enter your answer without the unit. Z₁ Answer: 22
A very simple way of measuring the depth of a fluid in a gas station's underground gasoline tank is by using a pressure gauge that measures gauge pressure. Assume the fluid in the tank is gasoline with a density of 700 kg/m3 and g = 9.80 m/s2. If the gauge pressure is 25.9 kPa what is the depth of the gasoline in the tank? Assume 3 significant digits. Watch the units! A. 3.78 cm B. 37.8 m C. 0.378 m D. 3.78 m E. 3.78 mm
Please answer as much as you can! Thank you in advance! A beachball has a diameter of 24 cm and weighs about 6N. A-What is the volume of the beachball? Then, use this number to calculate the beachball’s average density in kg m-3. B-What is the volume of water displaced by the beachball if it is in the pool? C- Now, using a rope, you tie the beachball to the bottom of the pool so only half of the ball is submerged. What would the diagram look like? D- What is the buoyant force of the tethered beachball? What is the tension on the rope?
A large open tank contains water as shown in the figure. The level of the water in the tank is 8 m from the ground while the circular opening in the side of the tank is 1.5 m above the ground. If the discharge rate at the opening is 75 li/sec, determine the diameter of the opening. 1
P 0:). A docs.google.com ll. Classroom ► Your answer Q1/ In both inspiration and expiration, a pressure difference of 0.4 cm H2O causes a flow rate of 0.15 liter/sec in the nose. What is the airway resistance Rg? * 1 Add File Q2/ If there are 3x10^8 alveoli in a lung with a functional residual capacity of 2.5 liters, calculate the average volume of an alveolus. 1 Add File Q3/lf Rg = 3 cm H2O/(liter/sec), what air flow rate would occur at an expiratory pressure of 100 mm Hg? * 1 Add File