A L M B

Q: Several forces are applied to the pipe assembly shown. Knowing that Q=250 lb and that the pipe has…

A:

Q: Determine the normal stress at bar AC. Use diameter of bar AC = 215 mm. B 500 N 2 m -J.- 2 m 451

A: According to the given dataThe diameter of the AC is 215mmWe need to findStress in the member AC

Q: The steel shaft with two different diameters rotates at 4.4 Hz. The power supplied to gear C is 73…

A: find the maximum shear stress in the shaft.

Q: Q5) A material is subjected to two mutually perpendicular linear strains together with a shear…

A: For the solution refer below images.

Q: a) The stress in the wire. Answer in MPa b) The strain in the wire. c) The increase in the length of…

A:

Q: –79. The two aluminum rods AB and BC have diameters of 25 and 20 mm, respectively. Determine the…

A: to find:the value of "P" that can be supported.given:The diameter of the rod "AB" is the diameter of…

Q: The state of stress at a point is shown on the element. Determine (a) the principal stress and (b)…

A: (a) Write stresses that are shown in the element.   σx=240 MPaσy=100 MPaτxy=80 MPa

Q: The state of stress at a point in a member is shown on the rectangular stress element where the…

A: The state of stress at a point in a member is shown on the rectangular stress element where the…

Q: A spherical pressure vessel of 5.7 meter diameter is subjected to an internal pressure of 3.8 MPa.…

A: Given data  d=5.7 mP=3.8 MPat=5 mm Here, d is the diameter, P is the pressure on the vessel.  Now we…

Q: An aluminium pipe is rigidly clamped to the face of a concrete building. On a hot day the face of…

A:

Q: In a tensile test for an aluminum alloy, the sample is 2 inches long and 0.5 inches in diameter. The…

A:

Q: A typical aluminum-alloy scuba diving tank is shown in the figure. The outside diameter of the tank…

A:

Q: Mohr's cirde is shown for a point in a physical object that is subjected to plane stress. Each grid…

A:

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.