The steel shaft with two different diameters rotates at 4.4 Hz. The power supplied to gear C is 73 kW, of which 48 kW is removed by gear B. Find the maximum shear stress (in Pa) in the shaft if d = 59 mm, h = 61.7 mm, L = 3.9 m, M = 2.5 m, and G = 83.34 Gpa. Round off the final answer to two decimal places.

Q: The shaft CD is affected by a torque T = 1000 Nm as shown. The shaft diameters are DAB = 53 mm and…

A:

Q: A compound shaft consists of brass segment (1) and aluminum segment (2). Segment (1) is a solid…

A: According to the given dataWe need to findminimum required diameter for the segments 1 and 2

Q: A 2.25 kN m torque is applied to the solid cylinder made up of a hollow cylinder and an inner core…

A:

Q: 103 (30 points) Derive the expressions for 03 and 04 in terms of 02 using the geometry shown in the…

A:

Q: A  25.4 mm diameter short shaft is used to transmit 33.3 hp . Determine the shaft speed.

A: The diameter of the short shaft is .The power transmitted by short shaft is .To find:The shaft…

Q: A hollow steel shaft, 5.6 ft long, has an outer diameter of 3.02 in. and an inner diameter of 1.5…

A:

Q: Question 1 Pulleys A and B with the dimension of 66 mm in diameter are connected to solid shafts AB…

A:

Q: Select the diameter for a solid steel shaft that is to transmit 60 HP at 850 rpm without exceeding…

A:

Q: The solid shaft in (Figure 1) is subjected to a torque, bending moment, and shear force. igure 300…

A:

Q: 18 mm diameter, solid circular shaft is made of a metal with a shear modulus, G = 19,515 MPa. The…

A: Given   Shear modulus, G = 19.515 MPa               Torque, T = 9 Nm           Diameter, d = 18 mm…

Q: angle of twist

A: .given: T1 = 10 kN-m T2 = 4 kN-m T3 = 3 kN-m. L1 = 0.55 m. L2 = 0.63 m. L3 = 0.58 m   To calculate…

Design of Shafts and Shaft Components

The shaft is basically defined as the machine element that rotates, is in circular cross-section, it is majorly used to transfer the power from one part of the system to another, or from a power generating machine to a power absorbing machine. The shaft is supported on bearings and is rotated with the help of a set of gears or pulleys that are used for the power transmission. Bending moment, torsion, and an axial force act upon the shaft. Designing of shaft primarily involves determining stresses at a critical point in the shaft that is arising due to loading.