A jet of water 75 mm in diameter has a velocity of 30 m/s. It strikes a flat plate inclined 45 degrees from the horizontal. Find the normal force in the plate. Select one: O a. 2,622.5 N O b. 3,708.1 N O c. 2,050.2 N O d. 2,811.5 N

A jet of water 75 mm in diameter has a velocity of 30 m/s. It strikes a flat plate inclined 45 degrees from the horizontal. Find the normal force in the plate. Select one: O a. 2,622.5 N O b. 3,708.1 N O c. 2,050.2 N O d. 2,811.5 N

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Q8
1. What is the maximum value of shear in the shear diagram
In the figure provided below: determine the vertical reaction at Point B and E.
Problem no. 2. A wheel of carries a load of 1000kg, as shown in figure. a. Determine the horizontal force P applied at the center which is necessary to start the wheel over a 5m. block. Also find the reaction at the block. b. If the force P may be inclined at any angle with the horizontal, determine the minimum value of P to start the wheel over the block; the angle P makes with the horizontal; and the reaction at the block. 7m 5m 10m
Blocks A and B weigh 30 lb and 50 lb, respectively. В µ = 0.5 20° MBA 0.6 A MẠC = 0.4 D If the weight of block D is to be greatest without causing motion, using the coefficients of static friction indicated, what is the frictional force (Ib) between block A and the floor C?
H.W. 6.32 Q: in a (45°) bend a rectangular air duct of (1) m² cross-sectional area is gradually reduced to (0.5) m² area. Find the magnitude and direction of the force required to hold the duct in position if the velocity of flow at (1) m² section is (10) m/s and pressure is (2.943) N/cm². Take density of air as (1.16) kg/m³. 66
The gate AB is a quarter circle of 2.5 meters in diameters and 3 meters wide asshown in figure#2. How Find the horizontal component of the resultant hydrostatic forceacting on the gate in kilonewtons. How find the vertical component of the resultant hydrostatic force actingon the gate in kilonewtons, and how to find the location of PH and Pv from hinge A in meters. And if the weight of the gate is 100 Newtons, how find the force “F” just sufficient to preventrotation about hinge A.
1. The forces acting on a 1-ft length of a dam are shown. The upward ground reaction varies uniformly from an intensity of pa ( Ib/ ft ) at A to ps ( Ib/ ft ) at B. Determine pa and ps and also the horizontal resistance to sliding H. Ans. pA = 1222.22 Ib/ ft - 7' - W=24000lb P=10000lb 1 60° -F=6000lb 6' PA ps 18'
Calculate the support reaction at point A and B of the given figure. kindly show your complete solutions.
QUESTION 4) Calculate the 12kN/m support reactions and hinge force in the system shown in figure. 6771 H 3m B 3m OG 10kN 4 5kNm A
Water flows at a rate of 107L /s round a 1510 contracting pipe bend which lies in a horizontal plane. The diameter at the bend entrance is 771mm and at the exit 418mm. If the pressure at the entrance to the bend is 256kN/m2, determine the resultant force in the Horizontal direction (taking to the Left as positive) exerted by the fluid on the bend, correct to the nearest N. (Use π = 3.14)
Q34. A 10 cm diameter jet of water éxerts a force of 2 kN in the direction of flow against a stationary flat plate which is inclined at an angle of 30° with the axis of the stream. Find, (i) Force normal to the plate (11) Velocity of the jet (ii) Mass flow rate of water kg/sec. Answor