A hydropower station has a gross head of 13.35 meter Head loss in water conductor system is 1.22 meters generates a power of 18 MW. Calculate the optimum discharge in cubic meters per second considering the efficiency of a) 80 % b) 82 % c) 85 % d) 87 % e) 92 %

A hydropower station has a gross head of 13.35 meter Head loss in water conductor system is 1.22 meters generates a power of 18 MW. Calculate the optimum discharge in cubic meters per second considering the efficiency of a) 80 % b) 82 % c) 85 % d) 87 % e) 92 %

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: The characteristic of the UJT exhibits the following values: n = 0.575, R81 = 10 k-ohms, Vv = 1.3 V,…

A: a) According to the intrinsic stand off ratioη=RB1RB1+RB20.575=10k10k+RB2RB2=7.39kΩ

Q: Which of the following cannot be said for Channel capacitance? a) All b) it is formed as a result…

Q: reactance of G3 in per unit on a base of 100 MVA, 35 KV is ооо ΟΟΟΟ Three generators rated as…

Q: Which of the following statement is wrong for the outdoor substations? O For voltages below 33 KV O…

A: The voltage ratings of outdoor substations usually lies between 55KV to 765KV .

Q: Table 7.3 Electrical characteristics of PV module A and module B Characteristic at STC Module A…

A: As we know, in solar panel standard test condition is Irradiance is 1000 W/m2 at module temperature…

Q: The indication of a lagged demand meter approaches the value of the actual load at a rate which is…

A: Concept- A lagged demand meter- The pointer is made to move in the electromechanical thermal or…

Q: A man has a body resistance of 600 N. How much current flows through his ungrounded body: (a) when…

A: The solution can be achieved as follows.

Q: Q 1 You are hired as Maintenance Engineer for Pakistan Accumulator Ltd., the company that…

A: The Given company is hired as Maintenance Engineer for Pakistan Accumulator Ltd., the company that…

Q: The below table shows all the combinations considered when solving a unit commitment problem…

A: Given Data: The table of all the possible combinations of three thermal units explains, The cost…

Q: The 3-phase power and line-to-line voltage ratings of the electric power system shown in the…

Q: 5. Discharges form according to streamer mechanism is: a) Filamentary b) Diffused c) Circular d)…

A: (1) A streamer discharge is also known as filamentary discharge. It is a type of the electrical…

Q: 11. A string insulator has 3 units. The capacitance from each joint to tower is 15% of the…

Q: TM Thermal Visayas Incorporated Power Plant generates actual load of energy for 1.352 MW supplying…

A: Here is your answer! I hope this will help you.

Q: Q1. List any two reasons for shifting to alternate energy resources?

A: Alternative energy resources are also known as renewable energy. It is energy that comes from…

Q: 6.5 EDG Loading An EDG loads are: 20% Constant impedance. 70% constant kVA, 10% constant current…

A: Given: Z=20% 70% KVA 10% constant current Considering p.u. value considering the EDG is three phase…

Q: theirs clear deferent between linear reference and sawtooth more harmonics less harmonics the…

A: Inverter has a role to convert DC into AC . Inverters can be of various types.

Q: In electric power systems, all the following parameters will be reduced after improvement of power…

A: To choose the correct answer

Q: In a string of 2 suspension insulators, each unit has a self capacitance X and a pin to earth,…

Q: $02 DEATH 3. Use the diagram below to answer the following questions: 10: 1 240v ✓ 50Hz Ver…

A: Use the given diagram below to answer the following questions, a) The transformer peak primary…

Q: 1. In the waveform shown. Find the ripple factor y, if V1 = 8 volts and V2 = 10 volts- V(Volts)| V2…

Q: Lightning over-voltages and switching phenomena of switchgears are two examples of transient…

A: Lightning surge: A lightning surge is a very short burst of high voltage which if not suppressed can…

Q: 10. If a generator is overcompounded and you want to decrease the degree of compounding, then the…

A: simple straight forward questions on DC machines

Q: Current does not flow in the neutral wire in symmetrical 3-phase system a. True O b. False

A: In this question, We need to determine the current flow in the neutral wire in symmetrical 3 phase…

Q: The energy that "sloshes in and out" of a load without causing any net power transfer is called the…

A: Power:- Power can be defined as the amount of work completed in a given amount of time. Watt (W),…

Q: 1. (a) How can geothermal energy be extracted for useful purposes? Discuss the various ways of power…

A: It is asked to tell how geothermal energy can be extracted for useful purposes and we need to…

Q: Classification of 1200 MWe capacity natural gas power plant

A: We need to tell about classification of 1200 MWe capacity natural gas power plant.

Q: Explain 6 methods of improving power factor in electrical system

A: There are mainly 6 methods for improving power factor in electrical system which are as below,…

Q: SOURCE TRANSFORMATION VS RA RB Do not include the unit. The answer must be in 2 decimal places. IS…

A: We need to find out the current through given resistor in the given circuit by using of source…

Q: b) A1000 MW turbine generated 648 MWh during 30 da What would is capacity factor be?

A: In this question we will find capacity factor of turbine...

Q: Discuss three classes of FACTS, their roles and impact on power systems.

A: FACTS, or Flexible AC Transmission Systems, are a set of advanced power electronics devices that…

Q: Consider a Pumped storage micro-hydel plant is to be built as a Peak load-plant on above mentioned…

A: The above question is based on the analysis of a hydel power plant.

Q: Do you think the country has potential to have geothermal power plant? Why or Why not?

A: Geothermal energy : the energy which situated in earth in form of heat is known as geothermal energy…

Q: Power system

A: According to question: The sag in the transmission line is calculated as…

Q: There are 4 single phase circuit to be wired in 90oC THHN copper wire installed inside a conduit in…

A: Given information, Type of material of the wire is copper. Type of insulation is THHN (in 90°C).…

Q: Setting the voltage amount to 50 and the number of winds/turns to 20. Afterwards, increase the…

A: We know that, Voltage is directly proportional to number of turns Using this condition let's solve…

Q: A string of suspension insulators consists of three units. The capacitance between each link pin and…

A: First we will derive the relation between voltage across the various units of the string.string…

Q: ) Wind farm consist of ten wind turbines with nominal capacity of 2MWper turbine, has a total of 20…

A: Capacity factor =Average load / installed capacity. Average load = no. Of units produced / no. Of…

Q: Q1) A system consists of two generators. Data of these generators as follow GI has 30 MW capacity…

A: Answer (A) From the data of G1 which is having 30 MW capacity and the failure rate is 0.38day and…

Q: 5. A three-phase rectification system has a voltage ripple of 14%. If the output kVp is 150, what is…

A: Given data, Output voltage VO=150 V. Ripple voltage Vr=14 %.

Q: ii) A string of suspension insulators consists of three units if the voltage across the line unit is…

A: A string of suspension insulators consists of three units. voltage across the line unit is 20 kV.…

Concept explainers

Methods of Wiring

Electrical wiring is the way of integrating cables and wires to interconnected equipment such as fuses, switches, sockets, lights, fans, and so on to the main distribution board, which is a specific structure attached to the utility pole that ensures a constant power supply.

Question

100%

A hydropower station has a gross head of 13.35 meter Head loss in water conductor system is 1.22 meters generates a power of 18 MW. Calculate the optimum discharge in cubic meters per second considering the efficiency of
a) 80 %
b) 82 %
c) 85 %
d) 87 %
e) 92 %

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A Single Area consists of 3 generating units (G1/G2/G3) with the following characteristics: G1: 425 MVA rating, R1 = 0.015 pu (on the 425 MVA base), initial output P1 = 300 MW. G2: 300 MVA rating, R2 = 0.02 pu (on the 300 MVA base), initial output P2 = 200 MW. G3: 300 MVA rating, R3 = 0.03 pu (on the 300 MVA base), initial output P3 = 200 MW. The frequency of the system is 60 Hz. Assuming D = 0 pu and using a common base of 1000 MVA, what is the new steady-state frequency for a load increase of 100 MW? Select one: O a. None of these O b. 59.96 Hz O c. 58.75 Hz O d. 59.88 Hz
Solve b), c) and d) only
Solve it quickly please
clear and correct or dislike
Mixing (non reacting fluids), Electric circuits. Problem: Determine the current flowing through the circuit 3 sec after closing the switch. A. 12.25 A B. 14.25 A C. 13.25 A D. 11.25 A
Qa1. The three phases of a generator can be connected in either delia (D) or wye (Y) connection. List two advantages of three phase system over a single phase system. Also write mathematical relationship between the phase voltage and the ine voltage, and the phase current and the line current for both delia (D) and wye (Y) connections. Please answer in typing format please..
Electrical Engineering Could you please answer these questions? 1. For unsymmetrical analysis in power system why we use operator a? 2. In Delta connected load, proof Voltage and currents in zero sequence network is equal to zero
Hydro 3.10% DIST, 0.1% HYD, 14.8% Solar Others 0.60% 0.10% Gas COAL, 26.3% GAS, 58.8% 42.30% Coal 53.90% TNB Generation Fuel Mix FY 2009 TNB Generation Fuel Mix FY 2019 Figure 1 TNB Generation Fuel Mix for 2009 and 2019
Part 4 please.
please write your Introduction about this topic , and answer please in print font do not write in hand writing ? beceuse I want to copy it ?
Range of a generating voltmeter is 30 to 300 kV dc and its indicating meterreads a minimum current of 3μA and maximum current of 35 μA, find the capacitance of thegenerating voltmeter.
A Single Area consists of 3 generating units (G1/G2/G3) with the following characteristics: G1: 250 MVA rating, R1 = 0.02 pu (on the 250 MVA base), initial output P1 = 200 MW. G2: 350 MVA rating, R2 = 0.015 pu (on the 350 MVA base), initial output P2 = 300 MW. 0.03 pu (on the 300 MVA base), initial output P3 = 150 MW. G3: 300 MVA rating, R3 = The frequency of the system is 60 Hz. Assuming D = 1 pu on a common base of 1000 MVA, what is the new generation output for G3 for a load increase of 75 MW? Select one: O a. 190.55 MW O b. None of these O c. 203.38 MW d. 166.01 MW