A hydroelectric station has a turbine efficiency of 80% efficiency of 85%. Determine the volume of water required when delivering a load of 40 MW for 6 hours if its effective head is 120 m. Water weighs 1200 kg/m³. A. 899,424 m³ В. and a generator С. C. 845,041 m3 B. 945,352 m3 D. 905,412 m3

A hydroelectric station has a turbine efficiency of 80% efficiency of 85%. Determine the volume of water required when delivering a load of 40 MW for 6 hours if its effective head is 120 m. Water weighs 1200 kg/m³. A. 899,424 m³ В. and a generator С. C. 845,041 m3 B. 945,352 m3 D. 905,412 m3

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Combined Cycle Power Plants are having higher efficiency comparing to open cycle Power plant because…

A: we need to find why the combined cycle power plants are having higher efficiency comparing to open…

Q: An 11-kV, 1000-kVA, 3-phase, Y-connected alternator has a resistance of 2 per phase. The…

Q: 1. Refer to Figure 1. A Y-connected source supplies 3 balanced 3-phase loads. The source has voltage…

A: Source is star connected. V =Vab =380 V Note: frequency is not given, we assume f= 50 HZ

Q: A 100MW hydro-electric station is supplying full load for 10 hours in a day. The water is supplied…

Q: A hydro-electric station has to operate with a mean head of 250 m and is supplied from a reservoir…

A: Given that H= 250 m A= 120 Km2 available rain off =50 % Annual rain fall = 100 cm =1 m capacity…

Q: Problem 3 A climate control system, a motor load, and a lightning circuit of a small warehouse…

A: Step 1: Given data and solution to part a,b Step 2: Solution to part c

Q: Q A power station with capacity of 800 kW is to supply two loads (A & B). The daily load curve of…

A: As per the policy we can solve only 3 sub-parts of a question, please re-upload the remaining part…

Q: 3. A system consists of two plants connected by a tie and a load is located at plant two. When 100MW…

Q: A load of 1000 KW is connected at the receiving end of a 3 phase transmission line 60 km long. The…

Q: Transmission Power Lines Tutorials Tutorial n° 0: Construction of transmission power lines A Young…

A: Here is the detailed description of the electrical network layout:The electrical network starts with…

Q: 7. A power station has to meet the following load demand : 50 kW Load 4 between 10 A.M. and 6 P.M.…

A: The solution can be achieved as follows.

Q: Maria Cristina falls located at south has a height of 100 meters, it discharges at constant rate 2.5…

Q: A power generating station is required to cater to a 3-phase balanced load of 1500 kW at 11 kV, 50…

A: Given data, Load power P=1500 kW=1500×103 W Line voltage VL=11 KV = 11×103 V Frequency f = 50 Hz

Q: a) Find the burmed average power in the 6Ose load, P b) Find the avenage power provided by the…

A: For the given circuit, the equivalent impedance is:

Q: The maximum demand of a power station is 15 MW. Annual load factor is 50% and capacity factor is…

Q: Given a (step-down) DC Chopper. The input DC voltage, Vi = 30 V. The measured output of the chopper…

Q: 39. A power plant has a maximum demand of 15 MW. The load factor is 50 % and the plant factor is…

A: Given- Maximum load = 15 MW, Load factor =50%, Plant factor = 40%, To find- Operating reserve.

Q: Calculate the continuous power that will be available from hydroelectric plant having an available…

A: Givem Data: Efficiency = 0.96 * 0.86 * 0.97 density = 1000 head h = 300 m g = 9.81 Q = massflow =…

Q: 2. An electrical power transmission system has various equipment and parameters. As shown in the…

A: The given circuit is shown below.

Q: Two systems have a continuous load of 105 MW. Find the expected load loss (ELL) of each system if…

A: It is given that : Two systems have a continuous load of 105MW. a) hydro generators =6 units The…

Q: 5. The maximum load on the Thermal Plant of 60MW capacity is 50MW at an Annual Load Factor of 50%.…

A: Thermal power plant is generate the electricity . it is also known as a combustion power plant . it…

Q: Problem 2:- Consider the simple power system below. The reactance data is tabulated in the provided…

A: “Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: Which component represents Y axis of load duration curve ? a Time of a day b. Peak Demand C Power…

A: Choose the correct option Which component represents Y axis of load duration curve?

Q: A hydro electric power station is used to supplement the unmet constant load demand for 2 hours and…

Q: systems? A. The purely resistive load absorbs the real power from the power grid B. The purely…

Q: Q2.The single line diagram of a three phase power system is shown in Fig.(1). Draw an impedance…

Q: A 200 MW power station delivers 20 MW for 5 hours, 75 MW for 8 hours, 30 MW for 2 hours and is shut…

Q: 2. Gather the data about hudan-eleckic power stations in 1lant @ capacily (gncation capacity) O…

A: Hydroelectric Power plant Generation Capacity Large Hydropower plant (> 30 MW) Small Hydropower…

Q: A generating station has a maximum demand

Q: Assume that a load of 100 kW is connected at the Riverside substation of the NL&NP Company. The…

A: Given data, Load, P = 100 kW. Demand, D = 75 kW. Weekly energy consumption, E = 4200 kWh.

Q: A generating station distributes the following loads. 2500KW, 7500KW, 15000KW and 3500KW, The…

Q: Two alternators A and B operate in parallel and supply a load of 15MW at 0.5 power factor lagging.…

Q: Open Cycle Natural gas power plants are having less efficiency comparing to combined cycle Power…

A: Combine cycle power plants have HRSG to increase its efficiency while the open cycle power plants ,a…

Question

A hydroelectric station
efficiency of
efficiency of 85%. Determine the volume of
water required when delivering a load of 40
MW for 6 hours if its effective head is 120
m. Water weighs 1200 kg/m³.
A. 899,424 m3
B. 945,352 m3
has a turbine
80% and
a generator
C. 845,041 m3
D. 905,412 m3

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Trending now

This is a popular solution!

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Two alternator A and B, with ratings of 250 KW and 450 KW respectively. If the no load voltage is 260 V and full load voltage is 240 V, calculate the terminal voltage when the total output is 575 KW.A. 242.3 V C. 245.3 VB. 248.3 V D. 243.6 V
Q2 A power station is to supply two loads. The daily load curves of two loads are shown in figures below: MW MW 25 25 20 20 15 15 10 10 12 16 20 24 hours 12 16 24 hours Load curve A Load curve B 1- Plot the load and duration curves of power station. 2- Find: i- Load factor of each load. Load factor and Diversity factor of power station. iii- The reserve capacity and Capacity factor of the power station .If the power station consists of three units, the installed capacity of each unit is 20 MW. 11-
A generating station has a maximum demand of 30,000 kW. Calculate the cost per unit generated from the following data: Capital cost = P 130M; Annual load factor = 50%; Annual cost of fuel and oil = P7.5M ; Taxes, wages and salaries etc. = P7M and Interest and depreciation = 12%
O:28)
On a particular day, the head of a dam is 85.37 m and the generators deliver 6000 MVA at a power factor of 0.9 lagging. Assuming the average turbine efficiency is 0.92 and the average generator efficiency is o.98, calculate: a. The active power output [MW] b. The reactive power supplied to the system [Mvar] c. The amount of water flowing through the turbines.
Power factor and power rating
A power station is to supply three loads. The daily cycle of loads are given below: 1- Load factor of the power station. 2- Diversity factor of the power station. 3- The capacity factor when the station is having reserve set 20% of the max. Demand.
A generating station has a connected load of 100 MW and a maximum demand of 60 MW. The number of units produced per year is 210 × 10^6, then find (1) Demand factor (2) Load factor.