A hydraulic lift in a service station has a large piston 30 cm in diameter and a small piston 2 cm in diameter. What force is required on the small piston to lift a load of 1500 kg. What is the pressure increase due to the force in the confined liquid
Q: A fluid with a viscosity of 2.0 x 10-3 Pa s has a velocity of 1.48 m/s through a 12 m long pipe with…
A: Viscosity of the fluid η=2.0×10-3 Pa s Velocity of the fluid v=1.48 m/s Length of the pipe L=0.085 m…
Q: Bowling balls are roughly the same size but come in a variety of weights. Given that the official…
A:
Q: ater travels through a pipe at 8.22 m/s. The pipe contracts from a crossectional area of 2.5 m2 to…
A:
Q: Consider the hydraulic lift shown in the figure. The small piston has an area A1 of 0.0330 m², and…
A:
Q: A pipe of diameter 0.3 m increases to a diameter of 0.84 m. If the fluid is traveling at 4.6 m/s in…
A:
Q: sure sensor is used to measure the water level in a tank. The water density is 1000 kg/m3. What…
A:
Q: The vertical cross-section of a pipe with flowing water is shown in the diagram. The gauge pressure…
A:
Q: A rock with a mass of 572 g in the air is found to have an apparent mass of 360 g when submerged in…
A: Given mass of a rock in air = 572 g mass of a rock in water = 360 g We have to to calculate (i) mass…
Q: A Juniper wood log with a weight density of about 35 pounds/ft3 and a volume of 2 ft3 is submerged…
A: Density of Juniper wood log (d1) = 35 poundft3Volume of Juniper wood log (V) = 2 ft3Density of water…
Q: A piston of cross-sectional area a is used in a hydraulic press to exert a small force of magnitude…
A:
Q: Water travels through a pipe at 7.50 m/s. The pipe expands from a crossectional area of 2.2 m2 to an…
A:
Q: An object weighing 575 N and the volume of 0.6 m3 in air is immersed in fluid after being tied to a…
A: Given, Weight of object ( W)= 575 N Volume of object(V) = 0.6m3 Object tied to a string that is…
Q: You come across an open container that is filled with two liquids. Since the two liquids have…
A:
Q: Q1: A cubical box 25.00 cm on each side is immersed in a fluid. The pressure at the top surface of…
A: SIDE OF CUBICAL BOX = 25cm = 0.25 m pressure difference from top to bottom of box is pressure…
Q: The side view of a pipe is shown. The pipe diameter increases and then remains constant. P; is the…
A:
Q: Water travels through a pipe at 8.57 m/s. The pipe expands from a crossectional area of 2.8 m2 to an…
A: a) With respect to equation of continuity, the expression used to calculate speed of water in the…
Q: A rock displaces 0.65 m3 of freshwater when it is completely submerged. Consequently, since the…
A:
Q: liquid pored into a container fills it to a depth of 11.0ft. If the pressure at the bottom of the…
A:
Q: To suck lemonade of density 1000 kg/m3 up a straw to a maximum height of 85 mm, what is the minimum…
A: The density of lemonade is given as The maximum height is
Q: A₂ of 4.00 m². What force F₂ will the large piston provide if the small piston is pushed down with a…
A:
Q: Water in the lake behind Hoover Dam is 221 m deep. What is the water pressure at the base of the…
A: At the foot of the dam, we have water pressure. Given that the dam is 221 m deep, the water has a…
Q: The liquid in a horizontal pipe of diameter d1 before a constriction is at pressure P1 and flowing…
A: In the question, it is given thatREMMBER THAT SINCE THERE IS NO HEIGHT CONCEPT FOR BOTH ENDS WE HAVE…
Q: n object weighing 550 N and the volume of 0.4 m3 in air is immersed in fluid after being tied to a…
A: GivenWeight of object in air , W=550 NVolume of object in air , V=0.4 m3object is immersed in fluid…
Q: When a 1 meter long cylinder with cross-sectional area of 16 cm? is immersed in a tank of water, 12…
A: Given information: Here, l and A is the length and the cross-sectional area of the cylinder, lout…
Q: Water flows with a constant speed through pipe of constant cross-sectional area in the ground floor…
A: Part a: The pressure difference between top (P1) and bottom (P2) is given in terms of density of…
Q: A stone was hung from a light rope. When the stones are in the air, the rope tension is 39.2 N. When…
A:
Q: A barrel contains a 0.160-m layer of oil floating on water that is 0.245 m deep. The density of the…
A: Thickness of oil layer is Depth of water is The density of oil is Note:Gravitational acceleration is…
Q: A large diameter tank with the top closed and sealed is filled to a fluid depth of 3 meters. (fluid…
A: Given: The depth of water in tank h1 = 3 m. The height of water in pipe h2 = 5 m. Density of fluid…
Q: Consider the hydraulic lift shown in the figure. The small piston has an area A₁ of 0.0330 m², and…
A: Step 1:Step 2:Step 3:Step 4:
Q: A pipe with a cross section area of 0.5 m^2 has a fluid flowing through it at a speed of 2m/s. If…
A:
Q: A 150-N object of density=870kg/m3 floats in a liquid of density with three-fourths of its volume…
A: a) The buoyant force on the object= 150N (Since the body is floating, the net upward force i.e., the…
Q: Container partially filled with a known amount of fluid that has density = 921kg/m³. When a solid…
A: Density of the fluid, Displaced volume, Acceleration due to gravity,
Q: hole is poked through the metal side of a drum holding water. The hole is 18 cm below the water…
A: Given height = 18 cm = 0.18 m We have to calculate the initial speed of outflow
Q: You come across an open container that is filled with two liquids. Since the two liquids have…
A: Pressure is the result of a force acting upon a certain area. Pressure at the bottom of the…
A hydraulic lift in a service station has a large piston 30 cm in diameter and a small piston 2 cm in diameter. What force is required on the small piston to lift a load of 1500 kg. What is the pressure increase due to the force in the confined liquid?
Trending now
This is a popular solution!
Step by step
Solved in 4 steps
- A hydraulic jack piston has a diameter of 0.06 m. The hydraulic jack is connected to another piston that supports the load. The support load piston has a diameter of 0.50 m. If the jack can lift a mass up to 2500 kg, what is the maximum force that one needs to apply to the piston in order to lift the given mass?Glycerin flows through a 6.0 cm diameter pipe at 0.98 m/s. What is the fluid’s speed in a 3.5 cm diameter pipe that connects with it, both pipes are flowing full.Hi please help: A cylindrical container with a cross-sectional area of 69.2 cm^2 holds a fluid of density 856kg/m^3. At the bottom of the container the pressure is 128kPa. Assume Pat= 101kPa A. What is the depth of the fluid? B. Find the pressure at the bottom of the container after an additional 2.25x10^-3m^3 of this fluid is added to the container. Assume that no fluid spills out of the container
- A large diameter closed top tank is filled with a depth of 3 meters of a fluid (density 1200 kg/m3). A small pipe leading from the bottom of the tank must carry the fluid some height above the fluid level in the tank. a) If a pressure of 2.5 Atmospheres is maintained in the space above the fill line in the tank how high above the fill line can the pipe carry the fluid and still provide an exit speed of 2 m/sec for the fluid out of the pipe? (the pressure at the exhaust end of the pipe is 1 atmosphere or about 1 x 105 pascal) If the pipe diameter is 2 cm, what will be the volume rate of flow (m3 /sec)Water is flowing through a pipe with a constriction. The area of the narrow section is one-half the area of the wide section. If the velocity of the incompressible fluid is 3.2 m/s in the narrow section, then what is the velocity of the fluid in the wide section? Multiple Choice 0.9 m/s 1.0 m/s 1.6 m/s 1.8 m/s 1.9 m/sWhat is the buoyant force of an object with a volume of 0.5 m3 that is fully submerged in water? The density of water is 1000 kg/m3. O 500 N O 420 N 4,900 N 9,800 N
- A rock weighs 39.2 N in air and 26.4 N when submerged into the water of density 1000 kg/m³. What is the volume of the rock? Oa. 0.0011 m³ Ob. 10.8 m³ OC. 0.0013 m³ Od. 1.1 m³A typical pressure in a vein is 18 mm Hg. How high would you need to hang an IV bag so that the fluid enters the blood stream at this pressure? Assume the IV fluid has a density of 1000 kg/m3. A nozzle with an area of 0.3 cm2 is attached to a garden hose with an area of 1.5 cm2. The flow rate through the nozzle is 0.12 L/s.What is the speed of the water in the hose in cm/s? (1 L= 1000 cm3) What is the speed of the water in the nozzle in cm/s? (1 L= 1000 cm3)A certain pressure can support a column of water 0.7 m. The same pressure will support a column of saline solution 0.6 m high. What is the density of saline solution?. The density of water = 1000 kg/m.
- A force of 120.0 N is applied to 2.000 cm diameter piston, which is in contact with a closed container of water (density of water = 1,000 kg/m3). A second piston, with a diameter of 25.00 cm and at the same height as the first piston, is also in contact with the water. What force does the water pressure exert on the second piston? Multiple Choice 10,450 N. 8,450 N. 18,750 N. 9,150 N. 9,500 N.A hydraulic system where a force f=5N is exerted on the left piston of area a=2m2. This is the result of an upward force being exerted on a larger piston of area A=100m2 on the right. a) What is the added pressure applied to the fluid by the force f? b) What is an upward force applied to the large piton?