A horizontal Venturi meter with a throat diameter of 150 mm is connected a pipe of diameter of 250 mm to measure the discharge in the pipe. The pressures just upstream of the connection and at the throat were found to be 140 kPa and 80 kPa, respectively. Determine the flow rate in the pipe. Take the coefficient of discharge for the Venturi meter as 0.98 and T = 55°C. (Expected answer range: 0.190 m²ls

A horizontal Venturi meter with a throat diameter of 150 mm is connected a pipe of diameter of 250 mm to measure the discharge in the pipe. The pressures just upstream of the connection and at the throat were found to be 140 kPa and 80 kPa, respectively. Determine the flow rate in the pipe. Take the coefficient of discharge for the Venturi meter as 0.98 and T = 55°C. (Expected answer range: 0.190 m²ls

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

10 PLEASE PROVIDE COMPLETE AND DETAILED SOLUTION
An illegal connection was detected along a water 400 mm water supply line made with cast iron pipe (n=0.012). before the said illegal connection the difference in pressure for every 100 meters is 1 m and after it the difference in pressure for 100 meter is only 0.7 m compute the decrease in supply due to this connection.PLEASE DRAW FIGURE/DIAGRAM
Given a three-pipe system, the total pressure drop is P,- P, 150,000 Pa, and the elevation drop is Z, - Z, = 5 m. The pipe A data are: Pipe L, m d, cm E, mm eld 1 100 8 0.24 0.003 2 150 0.12 0.002 3 80 4 0.20 0.005 The fluid is water (density 1000 kg/m' and kinematic viscosity 1.02x10 m/s). Calculate the flow rate Q in m'/h through the system. 3
2. Oil of specific gravity of 0.90 is discharging through a 100 mm circular sharp edge orifice in the end of a 120mm pipe. The pressure head on the center line of the pipe just upstream from the orifice is 9m of oil, and discharges takes place into a closed tank in which the vapor pressure is - 20 kPa. Use C = 0.68 and Cv = 0.97. Compute the discharge. 120 mm pipe P = - 20 kPa 100 mm orifice
HYDRAULICS LABORATORY EXPERIMENT NO.4 3. Using the value of Cd, which you have obtained by experiment, determine the throat diameter of a Venturi meter which would measure a flow of 0.40 m3/s in a pipe of 0.60 meter diameter with a differential head of 0.80 meter
A cylinder is placed in a steady water flow as shown. Calculate the pressure difference PB - PA in psi if the flow speed at A is 10 ft/sec. .A O 1.04 O 1.53 0.67 1.92 0.82 O 1.74
A differential manometer is attached to a pipe shown. Calculate the pressure difference between points A and B.
Solve fast
A 25-mm-diameter pipe 35m long is used to convey oil. The oil has a density of 880kg/m³ and a kinematic viscosity of 0.25×10*m³/s. The discharge in the pipe is Q=24x10*m³/min. Given that the pipe is placed horizontally and there are no any minor losses. Determine the pressure drop between the entrance and exit of pipe.