A homogenous bar AB weighing W is supported by a ball and socket joint at A and two cables attached to B. Determine the reactions at A and the tension at cables. Enter the absolute value for all answers. B L6 L5 L3 y D • Given o L1 = 4.3 m o L2 = 3.2 m o L3 = 4.6 m o L4 = 2.7 m L5 = 4.9 m L6 = 4.5 m W = 350 N

Q: The simple machine shown below has 2 parts connected via a pin at A. The gripp ceeth at B exerts a…

A:

Q: F 200 N F3=300N M. 100 Nm 0.4 m F, 300N 0.5 m 0.6 m The pipe system shown in the figure is supported…

A:

Q: A bar with a right angle bend is supported by a collar A on smooth square rod, and by a roller at B.…

A: Given:Required:Support reactions

Q: Question The electric motor exerts 600 Nm torque on the aluminum shaft ABCD when it is rotating at a…

A: T = 600 Nm GBC = 16 GPa or 16000 MPa GCD = 12 GPa or 12000 MPa dBC = 30 mm

Q: F RAX F RAY F2 RDY The figure above is a pin-joint frame with angle 0 65° between members AF and AB.…

A:

Q: Determine the forces in members AB, AC, and AD. Forces are positive if in tension, negative if in…

A: Given Data: The applied force at point A is P=4.9 kN.   To Determine: The forces in members AB, AC…

Q: All the tension/compression members of the frame structure shown in the figure are pin-jointed and…

A:

Q: You have been tasked with designing a beam to support a lifting crane. The applied load is offset…

A:

Q: 400 lb 400 lb 160 lb/ft 100 lb/ft MATHalino com 5 ft 5 ft 3 ft * 10 ft 6 ft *3 ft R1 R2 R3 R4 Figure…

A:

Q: One of the cranks of a child's bicycle is shown. The entire crank lies in the xy plane. Take F= 90…

A:

Q: A uniform beam of length L carries a concentrated load wo at x = =(x-4). y(x) = Elday dx4 subject to…

A:

Q: The bent rod is supported at A, B, and C by smooth journal bearings as shown in (Figure 1). Part A…

A: Reactions are the forces acting at the supports of the system. If there is a force acting by support…

Equilibrium and Support Reactions

Civil engineers deal with structures that are composed of several members connected or with individual members such as beams and columns. To analyze such structures, the condition of statics must be applied. Under the static condition, the members are considered to be in equilibrium under the action of forces, that is, the members are assumed to be having negligible velocity.