A helix antenna has a spacing between the turns 0.05m and D= 0.1m. The number of turns (N) = 20. The antenna is designed to operate at 1000 MHz. Find the following: 1- HPBW 2-FNBW 3-Do in dB 4-AR 5-input impedance (R)

Q: Why is Preventive Maintenance (PM) important?

A:

Q: Q2/ Compare between star connection and delta connection ?

A: In this question we will compare between star and delta connection.....

Q: Which is a better source of information, the power supply or the DMM? Why?

A:

Q: List the minimum trade size Type EMT for each of the following applications. (Objective 12-1)…

A: As per Bartleby expert policy only first individual question is to be answered. So, answering only…

Q: Fire due to faulty equipment's will result in emission of Answer:

A: According to the given question, it is required to determine that what will result in the emissions…

Q: Can I use the 66-block in telephone wire distribution to its outlets? How is it distributed?

A: According to the question, we need to explain the 66-block in telephone wire distribution.

Q: Define the unit step function and the shifted unit step function. Need

A: The unit step function and its shifted counterpart has been defied in the following section.

Q: 2. Explain the following sensors with neat diagram. (construction, operation and applications) a)…

A: A transducer that transforms force into an electrical signal is a load cell. The weight or force…

Q: Define the unit step function and the shifted unit step function. Need correct solution within 20…

A: The unit step function and the shifted unit step function have been defined in the following…

Q: overcurrent protection

A: Given :- Transformer rated at 1000V,              Primary overcurrent protection device is at 250%…

Q: What are the key challenges in power transmission within a power grid?

A: Key challenges in power transmission within a power grid?

Q: Draw the block diagram for the light pupil system using close loop system

A: The block diagram for the light pupil is drawn below:

Q: Calculate the number of luminaires required in the room of length 12.46m and Width 5.91m. If 100 W,…

A: Given Room length = 12.46 m Room width =5.91 m Utilization factor (UF)=0.71 Maintenance factor (MF)…

Q: I dont get it. howcan I make sure its in low condition?

A: You have asked that how to make sure it is in low condition.

Q: Skitch  a wire of installation

A: Sketch  a wire of installation

Q: Which of the following systems of wiring has poor durability? O TRS Wiring O CTS wiring O Lead…

A: There is the table for some wiring system with its durability:   Wiring system Durability…

Q: Identify and describe the operations of all major equipment used in substations

A:

Q: A 4" conduit installed with 4 # 750 kcmilTHWN-2, and 1 #1 THWN conductors. The conduit due to…

A: It is given that: Pull boxes are utilized in straight pull configuration so that the conduits enter…

Q: Electric Powers System for Nonelectrical Professional can you describe effective preventive…

A: Electrical Preventive Maintenance (EPM) is the act of leading routine assessments, tests, and the…

Q: -6) Solid grounding is used for voltages

A: Solid is used for the voltages below:

Q: ) current signs determined?: (b) voltage signs determined

A:

Q: 0.048L 0.2728 0.32 0.08503 9A 4.7 2.80A Radio 20. 4.20V(* Battery Wind Solar Panel Repeator…

A: A thevenins equivalent circuit is used for solving complicated circuits, by converting the voltage…

Q: what is the type of the Iraq electricity tariff

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: The expressions for the steady-state voltage and current at the terminals of the circuit seen in…

A: The source voltage,The current supplied by the source,

Q: Define the unit step function and the shifted unit step function. Need

A: The solution is provided in the following section.

Q: inm do A ☺ 52

A: From the mesh Analysis

Q: What is a closed path made of several branches of the network called? Select the correct response:…

A: Select the correct option : The closed path made of several branches of the network called :…

Q: 12 M R1 120 VAC 13.2 H L1 1k2 MW R2 60 Hz

A:

Q: was If the number of layers/slot is 4 then the number of coils ----- the number *.of slots twice O…

A: Four layers/ slot means there are 4 diffrent coil sides under one slot one coil has it sides in two…

Q: Vhich of the following systems of wiring is the costliest? O Conduit wiring O Wooden casing and…

A: Option A  Conduit wiring is costliest among all wiring systems

Q: ladder diagram for three circuits, circuit A is one lampholder and one duplex receptacle controlled…

A: According to the question, we need to design a ladder diagram for three circuits, circuit A is one…

Q: find out what type of flow meter is used in Dialysis machines.

A: Dialysis machine :  Dialysis machine is used for kidney failure patients for dialysis of blood .…

Q: Define the unit step function and the shifted unit step function. Need correct solution within 20…

A:

Q: (h) Find the steady-state and peak values of the response for this gain (1) Determine the value of…

A: (h)

Q: 39. Using branch current analysis, find the voltage drop across the 1 kN resistor in the figure…

A: If we consider I1 as current flowing in the first loop in clockwise direction and I2 is the current…

Q: Q2: Draw the single line diagram of a substation having the following equipments: (1) Incoming…

A: Equipments used in High voltage substation design Isolator- Isolate the section for maintenance…

Q: 5. Determine whetneo or not each of the following systems are i) yon) = >cCn) + n.xcn+1) (i) yen) =…

A: A system is BIBO-stable only if bounded-input always produces bounded output.

Q: How to convert 22 mW of power into the units of dBm

A: In this case, 22 mW of power is to be converted into its equivalent power in dBm.

Q: explain span length for ovehead service line

A: Span Length:- The span length is the distance between the two neighboring poles.  It is often…

Q: x Mol Technician/Electrician Cand X Exam - c…

A: An electric cable is a wire which carries charge or current from on point to another.

Q: a metal device box has four 12 AWG conductors, two internal clamps, and a duplex receptacle. Total…

A: A metal device box has four 12 AWG conductors. According to the national electric code table,…

Q: 14. Which of the following statements about the neutral ground-strap ground fault protection system…

A: An Equipment Grounding Conductor (EGC) is used to ground the metallic parts of the equipment, which…

Q: 3 What is a Pump Storage Hydro Power Plant? Explain briefly.

A:

Antenna Characteristics

The antenna is an important concept in the domain of electronics and communication engineering. An antenna forms an integral part of many commonly used devices such as wireless modems, routers, game controllers, mobile phones, bluetooth devices, and so on. In simple terms, any wireless communication makes use of antennas to serve the purpose. An antenna, also known by the term 'arial', is an electrical device that converts electrical signals into electromagnetic waves or electromagnetic waves into electrical signals. An antenna contains a transmission line usually made up of co-axial cable, it then receives the signals and converts them into electromagnetic waves, which are then transmitted via space into their required destination. A communication system essentially makes use of two antennas, a transmission antenna, which converts electrical signals into electromagnetic waves, and a receiving antenna, which receives the electromagnetic waves and converts them back into electrical signals.