A heat pump that operates on the ideal vaporcompression cycle with refrigerant-134a is used to heat a house. The mass flow rate of the refrigerant is 0.25 kg/s. The condenser and evaporator pressures are 1400 and 320 kPa, respectively. Show the cycle on a T-s diagram with respect to saturation lines, and determine (a) the rate of heat supply to the house, (b) the volume flow rate of the refrigerant at the compressor inlet, and (c) the COP of this heat pump.

Q: . Consider a natural gas with a molar composition of 92% methane, 5% ethane and 3% propane. An…

A: given,T1=300 KT2 = 320 KP1 =1 barP2 = 300 barsheat removed = 875 kWflow rate = 0.4 kg/s

Q: blanks) Calculate the efficiency of the Carnot Engine for ideal gas. Consider the figure below for a…

A: Introduction: A slow process in which the pressure and volume of a system change at a constant…

Q: A stream of refrigerant-134a at 1 MPa and 20°C is mixed with another stream at 1 MPa and 80°C. If…

A: Basic Details According to the mass balance equation, the mass of the system remains constant. The…

Q: A certain gas expands from 350 mL to 800 mL very, very slowly at 45 °C. If there is 2.25 mol of gas…

A: The problem is based upon the expansion of a gas at a constant temperature. Here the given gas…

Q: (a) Calculate the rate in watts at which heat transfer through radiation occurs (almost entirely in…

A:

Q: Consider a classroom for 63 students and one instructor, each generating heat at a rate of 100 W.…

A: To determine the rate of internal heat generation in the classroom when it is fully occupied, we…

Q: Define C.O.P. of the simple vapor compression refrigeration cycle R-134a. The evaporation…

A:

Q: Consider a pan placed on top of electric range to cook. The bottom section of the pan is 0.4 cm…

A: A steel pan placed on top of an electric range is considered. The differential equation for the…

Q: An ideal diatomic gas has an initial pressure of 1.00×10°P , an initial volume of 2.00m', and an…

A: Iso choric process is the process where the system volume remain constant during the process. Iso…

Q: An ideal gaseous reaction (which is a hypothetical gaseous reaction that conforms to the laws…

A: Given:  Pressure, P = 30 atm = 30 x 1.01 x 105 = 3030000 Pa heat release, dQ = - 55.7 kJ = - 55700 J…

Q: Calculate the net radiant heat flux for two large parallel planes at temperatures of 427°C and 77°C…

A: TH=427°C=700KTC=77°C=350 KεH=0.6εC=0.2εshield=0.04

Q: Even when shut down after a period of normal use,a large commercial nuclear reactor transfers…

A: Given : Rate of heat ( P ) = Qt = 150 MW = 150 * 106 W Mass of reactor core = 1.60 * 105 kg Specific…

Q: (a) How much power is radiated by an iron sphere (emissivity e = 0.60) of radius 24 cm at a…

A: (a) Calculate the power radiated by the iron sphere. Qt=σeAT4    =5.64×10-8×0.60×4πr2205+2734…

Q: During an experiment conducted in a room at 25°C, a laboratory assistant measures that a…

A:

Q: In a 20 ml syringe, covid-19 vaccine is taken at 27°C at a pressure of 104 kPa. The volume of…

A: Given Data, Syringe volume = 20mLtemperature = 270CPressure =104 kPavolume expanded = 35mLand final…

Q: In a system similar to that shown in Active Figure 12.1, the gas in the cylinder is at a pressure…

A:

Q: Suppose that a deep shaft were drilled in Earth’s crust near one of the poles, where the surface…

A: The given values are,

Q: A system gains 2730 J of heat at a constant pressure of 1.49 x 105 Pa, and its internal energy…

A:

Q: onsider two isolated parcels of dry air masses M1=2kg and M2=3kg at the same pressure p1=p2 (same…

A: Given data, M1 = 2 kg M2 = 3 kg P1 = P2 T1 = 250 K T2 = 260 K Cp = 1

Q: A rigid tank with a volume of 1.8 m3 contains 15 kg of saturated liquid–vapor mixture of water at…

A: The volume of the water tank,

Q: What happens to the internal energy of a gas during an isothermal expansion?

A: In an isothermal process, temperature is maintained constant. Thus, the change in temperature is…

Q: Question 1: Water enters a tube (shown below) at a flow rate of 6 lit/min and an inlet temperature…

A: Note: As per the guidelines, we can only answer three subparts of a question. Sorry for the…

Q: A closed rigid tank filled with water initially at 20 bar, a quality of 80% and a volume of 0.5 m3…

A: Given,'

Q: A large electrical power station generates 1000 MW of electricity with an efficiency of 35.0%. (a)…

A: Part (a) Given: The power of electrical energy in one day is P=1000 MW. The efficiency of station…

Q: (a) Calculate the rate of heat transfer by radiation from a car radiator at 110C into a 50.0C…

A: (a) Given, A=1.20 m2TRadiator=T2=110°C=383 KTsurrounding=T1=50°C=323 Ke=0.750 From Stefan’s law,…

Q: A freezer is to convert 1.75 kg of water at 27.5°C to 1.75 kg of ice at -4.63°C. If the coefficient…

A:

Q: Figure (a) below shows a cylinder containing gas and closed by a moving piston. The cylinder is…

A: Given data The mass of the ice is m = 122 g

Q: A storage building with well-insulated walls and containing 800 m³ of air at 285 K is heated at…

A: The density of the air = 1.225 kg/m^3The volume of the gas = 800 m^3The mass of the gas =…

Q: A nuclear power plant operates at 66 % of its maximum theoretical (Carnot) efficiency between…

A:

Q: Consider steady one-dimensional heat transfer through a plane wall exposed to convection from both…

A:

Q: Steam to drive an old-fashioned steam locomotive is supplied at a constant gauge pressure of (about…

A: Here, process is carried out at constant pressure this means the process is isobaric calculate work…

Q: A sample of 0.1g of water at 100°C and normal pressure (1.013 x 10°Nm¯²) requires 54 cal of heat…

A: Given :             Water Vwater = 0.1 g = 0.1 cc             Pressure P = 1.013 ×105Nm-2…

Q: An enclosed chamber contains a gas that is cooled while stirred by a wheel. The work applied on the…

A: Thermodynamics.

Q: A piston-cylinder device contains a mixture of 1.0 kg of H2, and 1.6 kg of N2 at 100 kPa and 300K.…

A: Solution-Given thatmass of H2 (m1) =1.0 kgmass of N2 (m2) =1.6 kgPressure (P)=100 kPaInitial…

Q: A heat pump operates between reservoirs with temperatures of -2 oC and 21 oC. According to the 2nd…

A:

Q: A work of 522 KNm is done on a system while heat energy of 110 KNm is being transferred from it.…

A: According to guidelines we need to solve only first question kindly repost other questions in the…

Q: The rate of heat leaking into a house from the warmer outdoors is given by A(TH – TC) where TC and…

A: The rate of heat leakingR=A(TH -TC)where TH is the indoor temperature and TC is the outdoor…

Q: What is the enthalpy of helium in an isothermal process where the non flow work is equivalent to 200…

A: Given that Work w = 200 kJ

Q: An electric kettle was marked 500 Watt, 230 volt and was found to bring one kg of water at 15 degree…

A:

Q: Compute the heat transfer through the air condition if the outside temperature is outside…

A: Given:-            Outside temperature T∞ = 5° C              Inside temperature Ti = 20° C…

Q: A vertical piston cylinder arrangement shown below with a piston mass of 60kg with a face area of…

A:

Q: A mass of an ideal gas has initial temperature of 16 °C. If the temperature is raised

A: Specific heat at constant pressure cp =1·005 kJ/kg k Specific heat at constant volume cp= 0·718…

Q: calculate the thermal recharge of an area 25.0 km by 40.0 km where the average heat flow is 270 mW…

A: