A heart defibrillator is used to enable the heart to start beating if it has stopped. This is done by passing a large current of 12 A through the body at 25 V for a very short time, usually about 3 milliseconds. How much energy is transferred from the defibrillator to the body? A 300J B) 0.90 J Ⓒ900J (D) 0.30 J

A heart defibrillator is used to enable the heart to start beating if it has stopped. This is done by passing a large current of 12 A through the body at 25 V for a very short time, usually about 3 milliseconds. How much energy is transferred from the defibrillator to the body? A 300J B) 0.90 J Ⓒ900J (D) 0.30 J

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A 6.0 Q resistor and a 3.0 Q resistor are connected in parallel to a 1.5 V battery of negligible internal resistance. What is the current in the 3.0 Q resistor? Select one: 0.75 A 0.17 A 0.25 A 2.00 A 0.50 A
Two lightbulbs both operate on separate 120 V sources. One has a power of 40 W and the other is 80 W. Which of the following is true? o a. they have the same current flowing o b. the 80 w bulb has more current flowing O c. the 40 W bulb has a lower resistance o d. they have the same resistance
A defibrillator sends a 6.75 A current through the chest of a patient by applying a 9500 V voltage as in the figure. What is the resistance of the path in kΩ?
The circuit shown consists of four resistors and a 48 Volt power supply. Resistance values are shown in ohms. You do not have to "solve" the circuit. Below the circuit diagram is a table of "solutions". The volts and amps for each resistor is listed. Calculate the current that moves through the segment of wire between points "A" and "B". 48 V В 60 Q 66 Q 220 2 12.5 2 V (V) I (A) R (2) 15 1.20 12.5 33 0.15 220 33 0.55 60 33 0.50 66 Lenovo Home End Insert Delete 画 E11 F12
A current I flows through a resistor. A source maintains a potential difference of V across the resistor. The energy supplied by the source in time t is A) V I t2 B) V I C) V I t D) V I/t
The potential difference across a resting neuron in the human body is about 75.0 mV and carries a current of about 0.200 mA. How much power does the neuron release? How many electrons will flow in a resting neuron?
A typical cellular phone consumes an average of about 1.32 W of electrical power and operates on 3.80 V. HINT (a) What average current (in A) does the phone draw from its battery? A (b) Calculate the energy (in J) stored in a fully charged battery if the phone requires charging after 9.03 hours of use. J
Three resistors and two batteries are connected as shown in the circuit diagram. 10 Q 10 V= 20 Q 15 V 10 Q What is the magnitude of the current in the 20-2 resistor? O 0.75 A O 0.50 A O 0.00 A O 0.25 A O 1.00 A
A current of 6.0 A flows through an electrical device for 10 seconds. How many electrons flow through this device during this time? (e = 1.60 × 10-19 C) O 0.20 O 37 x 1020 O 2.0 O 20 O 3.7 x 1020
The brightness of a lightbulb is dependent on the current that goes through the lightbulb (in reality on the power, which is I^2/R). In Europe, the voltage used is 220 Volts, as opposed to the 120 Volts used in the USA. Will a lighbulb that is made for European voltage work well or poorly in the USA? It will work poorly in the USA. Since I=V/R, if V decreases, so does I, and so does the brightness. It will work more efficiently in the USA. Since I=V/R, if V decreases, I increases, and the brightness increases. It will work better in the USA because the resistance of the wires is smaller. Whether it works better or worse depends on how modern the wiring system is, regardless of the voltage, V.
4. A 12.0 V battery is connected to the resistor combination shown below. (a) How much current leaves the battery due to the resistors? (b) What is the current through each resistor? a 12 Q2 W R₁ R3 R₁ 692 w 692 692 www R₂ R₁ www 6Ω b
A 4.0- 2 resistor has a current of 3.0 A in it for 5.0 min. How many electrons pass through the resistor during this time interval? A 7.5 x 10 21 B 5.6 x 10 21 В (с) 6.6 x 10 21 D) 8.4 x 10 21 E) 2.1 x 10 21