A generator connected to the wheel or hub of a bicycle can be used to power lights or small electronic devices. A typical bicycle generator supplies 6.25 V when the wheels rotate at w = 19.0 rad/s.HINT(a) If the generator's magnetic field has magnitude B = 0.800 T with N = 105 turns, find the loop area A (in m²).m²(b) Find the time interval (in s) between the maximum emf of +6.25 V and the minimum emf of -6.25 V.S

Answered: Image /qna-images/answer/c89ccbe6-f8f2-40e0-9d0e-283f64720917.jpg

A generator connected to the wheel or hub of a bicycle can be used to power lights or small electronic devices. A typical bicycle generator supplies 6.25 V when the wheels rotate at w = 19.0 rad/ HINT (a) If the generator's magnetic field has magnitude B = 0.800 T with N = 105 turns, find the loop area A (in m²). m² (b) Find the time interval (in s) between the maximum emf of +6.25 V and the minimum emf of -6.25 V. S

A generator connected to the wheel or hub of a bicycle can be used to power lights or small electronic devices. A typical bicycle generator supplies 6.25 V when the wheels rotate at w = 19.0 rad/ HINT (a) If the generator's magnetic field has magnitude B = 0.800 T with N = 105 turns, find the loop area A (in m²). m² (b) Find the time interval (in s) between the maximum emf of +6.25 V and the minimum emf of -6.25 V. S

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A 5.00*10^-2 ohm square wire loop 30.0 cm on a side has its plane normal to a uniform magnetic field of magnitude B=4.0 T. If you pull two opposite sides of the loop away from each other, the other two sides automatically draw toward each other reducing the area enclosed by the loop. If the area is reduced to zero in a time of 0.30 s what is the average emf during this time interval? What is the average current during this time interval?
A bicycle generator rotates at 1,975 rad/s, producing a 17.5 V peak emf. It has a 46-turn, 1.00 by 3.00 cm rectangular coil in a 0.640 T field. It is driven by a 1.76 cm diameter wheel that rolls on the outside rim of the bicycle tire. (a) What is the velocity of the bicycle? (Enter the magnitude in m/s.) m/s (b) What is the maximum emf (in V) of the generator when the bicycle moves at 10.0 m/s, noting that it was 17.5 V under the original conditions? V (c) If the sophisticated geherator can vary its own magnetic field, what field strength (in T) will it need at 5.00 m/s to produce a 9.00 V maximum emf?
A 0.230 m radius, 480 turn coil is rotated one-fourth of a revolution in 4.17 ms, originally having its plane perpendicular to a uniform magnetic field. (This is 60 rev/s.) Find the magnetic field strength needed to induce an average emf of 10,000 V. X T
Your camping buddy has an idea for a light to go inside your tent. He happens to have a powerful (and heavy!) horseshoe magnet that he bought at a surplus store. This magnet creates a 0.262 T field between two pole tips 13.6 cm apart. His idea is to build a hand-cranked generator with a rotating 6.8 cm radius semicircle between the pole tips. He thinks you can make enough current to fully light a 2.66 Ω lightbulb rated at 7.48 W. That's not super bright, but it should be bright enough. With what frequency (in Hz) will you have to turn the crank for the maximum current to fully light the bulb?
A 10 H inductor carries a current of 20 A. the magnetic field of the inductor? Latent heat of ice is How much ice at 0° C could be melted by the energy stored in 22.6x 10°J/kg.
A power line carries a current I = 100 sin(380t), where I is in amps and t is in seconds. A clever engineering student wants to steal power by inducing emf in a rectangular loop of copper wire as shown below. If the student wants to induce a maximum emf in the loop equal to 1.7 V, what should be the length L of the loop? Assume that the magnetic field produced by the power line is uniform inside of the rectangular loo and equal to the magnetic field at the center of the loop. 5 mi To equipment I 0.5 m
The 1300-turn coil in a dc motor has an area per turn of 2.4 × 10-2 m2. The design for the motor specifies that the magnitude of the maximum torque is 7.8 N·m when the coil is placed in a 0.19-T magnetic field. What is the current in the coil?
The figure below shows a top view of a bar that can slide on two frictionless rails. The resistor is R = 6.20 Q, and a 2.50-T magnetic field is directed perpendicularly downward, into the page. Let = 1.20 m. x * * Bin xx * X X * R x x x x x * * x X xxxxxx x x X x X X x * x XXXX * F app x X * (a) Calculate the applied force required to move the bar to the right at a constant speed of 2.50 m/s. N (to the right) (b) At what rate is energy delivered to the resistor? W
A bicycle generator rotates at 1,800 rad/s, producing a 15.5 V peak emf. It has a 45-turn, 1.00 by 3.00 cm rectangular coil in a 0.640 T field. It is driven by a 1.48 cm diameter wheel that rolls on the outside rim of the bicycle tire. (a) What is the velocity of the bicycle? (Enter the magnitude in m/s.) m/s (b) What is the maximum emf (in V) of the generator when the bicycle moves at 10.0 m/s, noting that it was 15.5 V under the original conditions? V (c) If the sophisticated generator can vary its own magnetic field, what field strength (in T) will it need at 5.00 m/s to produce a 9.00 V maximum emf?
Transcranial magnetic stimulation (TMS) is a noninvasive technique used to stimulate regions of the human brain. A small coil is placed on the scalp, and a brief burst of current in the coil produces a rapidly changing magnetic field inside the brain. The induced emf can be sufficient to stimulate neuronal activity. One such device generates a magnetic field within the brain that rises from zero to 1.5 T in 120 ms. Determine the induced emf within a circle of tissue of radius 1.6 mm and that is perpendicular to the direction of the field.
A 5-turn conducting loop with a radius of 3.0 cm with axis of rotation in the plane of the paper spins at 60 revolutions per second in a magnetic field of 0.50 T that is perpendicular to the paper. The maximum emf generated is: 0.14 V 8.3 V 28 V 2.7 V 10.5 V
At what speed must a sliding rod move to produce an emf of 1.05 V in a 1.54 T field, given the rod's length is 30.3 cm? m/s