A gaseous reaction, A→2B + C takes place isothermally in a constant pressure reactor. Staring with a gaseous mixture containing 50% A and (rest inert), the ratio of final to initial volume is found to be 1.6. The percentage conversion of A is...?

Q: Blue water gas (BWG) is obtained by passing steam over red hot carbon-enriched coal. The gas is…

A:

Q: In the refinery facility based in the Durban South basin, there is a need to separate benzene from a…

A: Given T=80oC we have, ln P=A-BT+C ln P=13.7819-2726.8180+217.572 Psatbenzene=101.33 KPa For Toluene,…

Q: 4.114. Calculate the heat of reaction at the standard reference state for the following reac- tions:…

A: Step 1: Step 2: Step 3: Step 4:

Q: a) 4H b) 4S c) AG

A:

Q: The following calculations require standard enthalpies from this table. Reaction AH° (kJ mol ) Std…

A: Cyclopropane (C3H6) is a colorless gas. It is the cyclic compound with the least amount of carbon…

Q: You are to design an experiment to determine the enthalpy of combustion( fuel value) of the two…

A: Enthalpy of combustion is the amount of energy of heat released when 1 mol of substance is…

Q: 5) Ethylene gas (25°C) and steam (30°C) and atmospheric pressure are fed to a reaction process in an…

A:

Q: Calculate Kp for the reaction S(s) + 2 CO(g) SO2(g) + 2 C(s) At the temperature in question, 2 bar…

A: In thermodynamics, equilibrium constant Kp, the equilibrium constant is calculated from the partial…

Q: Q4. Fuel (C,H1s) is burned with air, both being supplied at 25 °C and at pressure of 1 atm. It is…

A:

Q: Propane (C 3H 8) burns completely with 190% of theoretical air entering at 74°F, 1 atm, 50% relative…

A:

Q: Methanol (CH3OH) and acetic acid (CH3COOH) react in the gas phase at a temperature of 170°C to form…

A: Given data: Equilibrium constant = 3.87 Initial number of moles of methanol = 92 mol Moles of…

Q: The standard reaction Gibbs energy of the isomerization of borneol (CoH17OH) to isoborneol in the…

A:

Q: (a) LPG (liquefied petroleum gas) is commonly used in households. It contains 95% propane (C3H8) and…

A:

Q: 100 A в та

A:

Q: The fuel in the form of biomethane is burned in a furnace. In order for the combustion to take place…

A: Hi and thanks for the question. Since you have not provided the composition of biomethane, I am…

Q: 2. A 100-L constant-volume reactor is evacuated and then filled with 1 mole of dinitrogen tetraoxide…

A: Given data: Initial number of moles of N2O4 = 1 mol T = 298 K

Q: You perform the distillation of the cyclohexane/toluene mixture as shown in the JOVE Video. The…

A: Given Info Composition of the starting solution=2 mL cyclohexane + 2 mL toluene To Find a) the…

Q: Q2 Sulphur trioxide gas is obtained by the combustion of pyrites (FeS,) according to the following…

A: The equations for the combustion of pyrites are: 4FeS2+15O2→2Fe2O3+8SO3              ......…

Q: QUESTION 1 Calculate the standard "enthalpy" heat of reaction for the following reaction at 25°C…

A: 3Feo + 2Al= Al2O3 +3Fe Enthalpy of Feo at 298 oC (H1)= -264.84 KJ/kg Enthalpy of Al2O3 at 298 oC…

Q: 3C(s) + 3H, (g) → C,H, (g.propylene) AH" = +20.42 kJ/ mol C(s) + 02(g) CO,(g) AH" = -393.51 kJ/ mol…

A: In process calculation, change in enthalpy is calculated using the principle of conservation of…

Q: Calculate the equilibrium constant for the following reaction at 60°C using the data at 298°K H₂O(g)…

A:

Q: consider that you mixed 10 g of KClO3 and 45 g H2O. Following to this step, you stirred the mixture…

A: • Here 10 grams of KClO3 (salt) is mixed with 45 grams of H2O (liquid). The reaction between KClO3…

Q: Q4- A gas stream (0.1 CO, 0.3 CO2, 0.4 N2, 0.2 NO), the gas stream at 1200 K. Determine the absolute…

A: Given: Mole fraction of species in a gas mixture: xCO=0.1xCO2=0.3xN2=0.4xNO=0.2 The temperature of…

Q: A mixture containing 33% n-hexane, 37% n-heptane and 30% n-octane by mole is fed to a flash…

A:

Q: A binary mixture of n-heptane and n-octane at its boiling point containing 70% (mol percent) of…

A: A mixture of n-heptane and n-pentane is separated into distillate and bottom product in a continuous…

Q: 9. Gasoline is a complex mixture, assume gasoline is a mixture of 2,2,4-trimethylpentane (an isomer…

A: Given that there are two component mixed i.e isomer of octane and n-heptane x1 =87% =0.87 T =25 C…

Q: a) Why does the boiling point increase and freezing point decrease of a solution when compared to…

A: When a solute is dissolved in a solvent, the solute particles interact with the solvent particles.…

Q: 1) Using below given information construct the unary (one component) phase diagram of iron. At 1 atm…

A: A unary phase diagram consists of only one component, and hence, there will be no variables, such as…

Q: Consider the following gas phase reaction that occurs within a new reactor for the conversion of…

A: The heat of reaction at the given conditions is to be calculated.

Q: 2. A decomposition reaction (A +2P) takes place in a variable volume batch reactor in gas phase at…

A: Given: reaction-  A→2P Volume expansion factor - ε = yAOδA=> ε = 0.85 x 1 = 0.85

Q: b) Silicon nitride is a very hard, high-temperature-resistant ceramic used as a component of turbine…

A: Given: 3 Si + 2 N2 ----> Si3N4 2 g of Si 1.50 g of N2 Which is the limiting reactant.

Q: QUESTION 3-) The normal boiling point of butane is given as 0.6°C and the default specific…

A: In thermodynamics, the boiling point of a substance is defined as the temperature at which the vapor…

Q: Gaz fazı reaksiyonu izotermal olarak aşağıdaki reaksiyondaki gibi gerçekleşmektedir. Molar besleme,…

A:

Q: A vapor mixture, 4.652 mol/s, of n-butane and n-hexane containing 50 mole % n-butane at 120˚C and 1…

A: Given, The molar flow rate of the mixture, nF= 4.652 mol/s The mole% of n-butane is 50 mol% The…

Q: Calculate the standard enthalpy of combustion for the reaction SiH,(9) + 2 0,(g) → sio,(9) + 2…

A: Given: The standard enthalpies of formation of each component present in the reaction are given as;…

Q: Calculate the quantities of gas and liquid formed when 7.5 lb moles of mixture of 60% methane and…

A: Given data: Amount of mixture = 7.5 lbmol Composition of gas mixture is, CH4­ = 60 % C2H6 = 40 % T =…

Q: AH£/kkalmol-1 ASP /kalmol-1 K-1..... 49,15 -4,8 -71,0 -68,3 ..... .... 59,4 7,62 16,72 ..... ...

A: The standard free energy or Gibbs free energy is a thermodynamic state function which can be…

Q: A feed mixture of 40% methanol and 60% ethanol is subject to flash distillation at 1atm. The feed…

A: Given :A feed mixture of 40% methanol and 60% ethanol is subject to flash distillationPressure

Q: 3. The melting point of pure urea is 132.5-133°C. Which of the following melting ranges is the most…

A: A melting point is a temperature at which the solid and the liquid phases of a substance come to…

Q: In Ammonia production, a reactor is supplied with a feed of 100L of N2 and 400L of H2 both at 22 atm…

A: Given data: The amount of feed is given in the volume. N2 = 100 L H2 = 400 L Temperature of feed =…

Q: 3. Use the eutectic diagram on the following page for the following questions. (a) What is the…

A: