4. A gas turbine operates on a Joule cycle and has a pressure ratio of 6/1 and a maximumtemperature of 727°C. The ambient temperature is 15°C and the isentropic efficienciesof the compressor and turbine are 85 % and 90 % respectively.Take Y and Cp for both the compression and expansion process as 1.4 and 1.005 respectively,a) Sketch the schematic diagram of the gas turbine plant and its processes on a T-s diagram.b) Calculate, for the cycle,i) the specific work output, andii) the thermal efficiency.

For solution refer below images.

A gas turbine operates on a Joule cycle and has a pressure ratio of 6/1 and a maximum temperature of 727°C. The ambient temperature is 15°C and the isentropic efficiencies of the compressor and turbine are 85 % and 90 % respectively. Take Y and C, for both the compression and expansion process as 1.4 and 1.005 respectively, a) Sketch the schematic diagram of the gas turbine plant and its processes on a T-s diagram. b) Calculate, for the cycle, i) the specific work output, and ii) the thermal efficiency. 4.

A gas turbine operates on a Joule cycle and has a pressure ratio of 6/1 and a maximum temperature of 727°C. The ambient temperature is 15°C and the isentropic efficiencies of the compressor and turbine are 85 % and 90 % respectively. Take Y and C, for both the compression and expansion process as 1.4 and 1.005 respectively, a) Sketch the schematic diagram of the gas turbine plant and its processes on a T-s diagram. b) Calculate, for the cycle, i) the specific work output, and ii) the thermal efficiency. 4.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

An idealcold air-standard Brayton cycle produces some quantity of power. Air with a mass flow rate of 6 kg/s enters the compressor at 100 kPa, 300 K.It is also known that the compressor has a pressure ratio of 10 and the turbine inlet temperature is 1400 K.If k = 1.4for the working fluid, determine the thermal efficiency, the ratio of back work, and the net power for the cycle in kW.
An ideal diesel cycle powered by air has a compression ratio of 20. At the beginning of the compression process, the pressure of the air is 100 kPa, the temperature is 20 °C and the highest temperature of the cycle must not exceed 2250 K. Show the cycle in the P-v diagram.Then calculate: a) The heat entering and leaving the cycle, the thermal efficiency of the cycle, b) the average effective pressure of the cycle. Assume that specific heat is constant at room temperature constant at temperature. k=1.4 CP=1.005 kJ/kgK CV=0.718 kJ/kgK R=0.287 kJ/kgK
Plz solve in 45min
Two ideal Brayton cycles (see Figure below) have the same inlet temperature and the same maximum temperature of the turbine inlet. Brayton Cycle A has a higher compression ratio than Cycle B. Which of the following statements is true about the cycles? Cycle A has a higher thermal efficiency and Cycle B has a higher work net for a given mass flow rate. Cycle B has a higher thermal efficiency and a higher work net for a given mass flow rate. Since the temperatures are the same the efficiencies and work net are also the same. Cycle A has a higher work net for a given mass flow rate and Cycle B has a higher thermal efficiency. Cycle A has a higher thermal efficiency and a higher work net for a given mass flow rate.
turbine turbine Reheater (4 Boiler P4= P5 = Prcheat Pump Condenser The following data was given for a steam power plant operating on the ideal reheat Rankine cycle. 3-4: Inlet steam at 17.5 MPa and 600 °C 6-1: inlet steam at a pressure of 11.16 kPa at a wetness fraction of 0 1 At state 1, the specific volume is 0.00101 m/kg Find the pressure in bar at state 6 to 3 decimal places
2) The compression ratio of an ideal Otto cycle is 7 and prior to compression air is at 285K and 90kPa. The maximum pressure of the cycle is 4100kPa. Assuming that the specific heats are constant where k = 1.4 and cp = 1.005 kJ/kgK. Calculate a) the maximum temperature, ԴՈՒ --- ..z a uvau pian -paving- AT
A rankine cycle operates between a pressure limit of 6 MPa. and 50 kPa., the steam leaves the boiler at 450 C, the isentropic efficiency of the turbine is 94%, the steam mass flow rate is 20kg/sec. draw the T-S diagram assuming point 1 is at the pumpe entrance. and determine the required power to operate the pump, cycle thermal efficiency. Ans. (122 kW, 30.25%)
the compression ratio of an ideal Otto cycle is 8. Pressure of air at the beginning of the isentropic compression process 95 kPa, Temperature 27 °C and constant volume input to the cycle is 750 kJ / kg. Consider that the specific constant is taking; which of the following are the temperature and pressure values at the end of the heat input into the cycle? (Cp=1.005 kJ/ups, C, =0.718 kJ / ups, R=0.287 kJ/ups, k=1.4) Please select one: a.4392 КРа 1534к O b.4392 Pa 1534 K с. 439.2 КРа 1734 К d.439.2 kPa 1534 K e.4392 kPa 1734 K
19
please try complete solution.