A furnace uses natural gas which consists of hydrocarbons. The flue gas analysis is CO2 - 9.5%, O2 - 1.4%, CO – 1.9 % and the rest N2. i) What is the atomic ratio of hydrogen to carbon in the fuel? ii) What is the % excess air used?  Express the composition of the fuel gas in the form CxHy.

Q: Crude petroleum oil is generally considered to be formed from animal and vegetable debris…

A: Given: Elemental analysis of crude petroleum 80% C 13%H 1% N 3% O 3% S Required to find: (a) Orsat…

Q: Blue water gas (BWG) is obtained by passing steam over red hot carbon-enriched coal. The gas is…

A:

Q: Determine the percentage of excess air fed to this reaction, then calculate the molar flowrate of…

A:

Q: Chlorine trifluoride, CIF3, is a toxic, intensely reactive gas. It was used in Word War II to make…

A: Given that two moles of chlorine trifluoride reacts with ammonia to form nitrogen, hydrogen fluoride…

Q: Gaseous fuel composed of 65% carbon, 30% hydrogen and 5% oxygen saturated with water vapor is burned…

A:

Q: At 103 kPa and 300K , Xylene vapour and Argon mixture gets saturated, contains xylene vapours that…

A:

Q: 3. A ternary blend of gasoline (90% octane no), alcohol (75% ethanol, 25% methanol) anc benzole (75%…

A:

Q: Pyrites analyzing 81% FeS2 and 19% gangue is burned in excess air to produce a burner gas with an…

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: A balanced equation with heats of formation is shown below.  () are the heat of formation 4 FeSO4…

A: The given balanced equation with the heat of formation for the individual species in the parenthesis…

Q: An iron-carbon alloy initially containing 0.255 wt% C is exposed to an oxygen-rich and virtually…

A: Given data: Initial concentration of C = 0.255 wt % Surface concentration = 0.0 wt % Temperature =…

Q: A flue gas from a certain furnace burning a fuel of negligible nitrogen content is found by analysis…

A:

Q: The fuel in the form of biomethane is burned in a furnace. In order for the combustion to take place…

A: Hi and thanks for the question. Since you have not provided the composition of biomethane, I am…

Q: 1 mol ethane (C2H6) and stoichiometric amount of oxygen (O2) needed to combust ethane was preheated…

A: Given data: Number of moles of ethane = 1mol Temperature of feed = 500 K Temperature of product =…

Q: 17.10. Crystallization by cooling. 7,500 lb/h of a 50 wt% aqueous solution of FeCl3 at 100°C is…

A:

Q: A hydrocarbon is burnt with excess air. The Orsat analysis of the flue gas shows 10.81% CO2, 3.78%…

A: When a hydrocarbon, which is composed of carbon (C) and hydrogen (H), is burned in air, it reacts…

Q: In the following reaction, how much heat is generated when 4 moles of CH₄ are burned? CH₄(g)…

A: Given: CH4(g) + 2O2(g) → CO2(g) + 2H2O(g)4 moles of CH4 are burned Heat of reaction ∆H°rxn=-802…

Q: Molar mass of elements (g/mol) C H 0 S N 12.01 1.01 16.0 32.0 14.01 Cl F 35.45 19 Consider the…

A:

Q: 150 kg of gaseous pentane (C5H12) are combusted with 2400 kg air. The overall conversion of pentane…

A:

Q: 8. A pure saturated hydrocarbon is burnt with excess air. Orsat analysis of the stack gas shows…

A:

Q: The naphtha fraction derived from the distillation of Kuwait crude oil is with 0.02 wt% sulfur…

A: Dear User ! As per our  authoring guidelines, we have answered the first of the two independent…

Q: the zeolite at 1 atmospheric pressure. If at the

A: Given data       assume :1 kg  zeolite  composition:   CO2 = .15 mole N2 = .85 mole Selectivity = 22…

Q: A mixture containing 33% n-hexane, 37% n-heptane and 30% n-octane by mole is fed to a flash…

A:

Q: A binary mixture of n-heptane and n-octane at its boiling point containing 70% (mol percent) of…

A: A mixture of n-heptane and n-pentane is separated into distillate and bottom product in a continuous…

Q: A solution of methylene chloride (CH,CI,) and ethanol (CH,CH,OH) is boiling at 62.7 °C. A sample of…

A: A mixture of methylene chloride (M) and ethanol (E) is boiled. The temperature of the boiling…

Q: The exhaust gas from a furnace gives the following Orsat analysis: 13.6% CO2, 2.4% cO, 2.8% O2, and…

A: Basis : 100 moles of exhaust gas- hence, N2 = 81.2 moles hence O2 fed = 81.20.79×0.21 = 21.585 moles…

Q: A lead ore, galena, consisting mainly of lead (II) sulfide, is the principal source of lead. To…

A: Enthalpy change of reaction a = -415.4 kJ Enthalpy change of reaction b = 108.5 kJ

Q: b) Silicon nitride is a very hard, high-temperature-resistant ceramic used as a component of turbine…

A: Given: 3 Si + 2 N2 ----> Si3N4 2 g of Si 1.50 g of N2 Which is the limiting reactant.

Q: 1 mole ethane, C2H6, is combusted in a reactor by using theoretical amounts of air. The products for…

A: Given combustion of 1 mol ethane to form CO2 and H2O at 25o C To find heat of reaction exiting…

Q: 3. In a reactor, carbon dioxide and hydrogen gas are combined to form methanol (CH3OH) gas and water…

A: Fractional conversion is a way of determining the reaction characteristics. It is defined as the…

Q: A of an KC at is to 200 in a The contains 18.67 g water per 100 g of dry KC, what percentage of the…

A: Given that, The initial temperature of KCl feed solution to crystallizer T1 = 100oC The solubility…

Q: 3. A batch combustion chamber is loaded with 250 moles of ethene (C2H4) and 3000 moles of air (21.0…

A: Given that nethene =250 moles nAir =3000 moles  O2 in the air=21 % C2H4  +O2   → CO2+H2O…

Q: 1. Ethane (CHs) is burned with atmospheric air, and the volumetric analysis of the dry products of…

A:

Q: For an industrial process where a large amount of heat is required, a large combustion chamber is…

A: Dear User! The question does not state the relative composition of benzene and methyl alcohol in the…

Q: The burner gas from a sulfur burner analyzes 9.2% SO2, 7.13% O2 and 83.67% N2. The raw sulfur…

A: Given data: The composition of species in the burner gas is given as: SO2 = 9.2 % O2 = 7.13 % N2 =…

Q: Pure sulfur is burned with 30% excess air. As a result of combustion, 7.23% SO 3, 4.06% SO 2, 7.06%…

A: Given: Pure sulfur (S) is burned with 30% excess air by the following reactions: S + 32O2  →  SO3S…

Q: Titanium dioxide, which is the most common white pigment in paint, can be produced from the titanium…

A: Given that- Basis feed= 200000 kg/h (99.9wt % pure TiO2 to be produced) Feed has- TiO2=50 wt%…

Q: An iron-carbon alloy initially containing 0.308 wt% C is exposed to an oxygen-rich and virtually…

A: Given:D=5.5×10-10m2sC0=0.308%Cs=0%Cx=0.231%t=6 h=21600 s

Q: Sulfur dioxide and nitrogen dioxide react at 298 K via the reaction SO,(g) + NO, (g) t SO,(g) +…

A: Given informationreaction SO2(g)+NO2(g)⇔SO3(g)+NO((g)The molar composition at equilibrium moles of…

Q: Pyrite Fines containing 85% FeS2, and 15% gangue are charged to a burner. An analysis of the cinder…

A: Given that, The mass composition of Pyrite fines FeS2: 85% Gangue: 15% The mass composition of…

Q: 1.

A: Thus mass of KNO3 will precipitate out = 480g KNO3  I hope this helps you.Explanation:Step 1: Mass…

Q: 16. In a combustion device, methane (CH4) burns with air at 0.7 equivalence ratio, under constant…

A: Given: Methane to air ratio is 0.7 Water is injected to control product temperature with 0.07 mass…

Q: 4. Barium carbonate is commercially important as a basis for the manufacture of other barium…

A: There are total four reactions involved in this system. Barium sulfide is obtained by heating…