A fully loaded, slow-moving freight elevator has a cab with a total mass of 1000 kg, which is required to travel upward 52 m in 2.5 min, starting and ending at rest. The elevator's counterweight has a mass of only 940 kg, so the elevator motor must help pull the cab upward. What average power is required of the force the motor exerts on the cab via the cable? Number i Units

A fully loaded, slow-moving freight elevator has a cab with a total mass of 1000 kg, which is required to travel upward 52 m in 2.5 min, starting and ending at rest. The elevator's counterweight has a mass of only 940 kg, so the elevator motor must help pull the cab upward. What average power is required of the force the motor exerts on the cab via the cable? Number i Units

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter7: Work, Energy, And Energy Resources

Section: Chapter Questions

Problem 41PE: (a) How long would it takea 1.50105 -kg airplane with engines that produce 100 MW of power to reach...

See similar textbooks

Similar questions

(a) How long would it takea 1.50105 -kg airplane with engines that produce 100 MW of power to reach a speed of 250 m,/s and an altitude of 12.0 km if air resistance were negligible? (b) If it actually takes 900 s, what is the power? (c) Given this power, what is the average force of air resistance if the airplane takes 1200 s? (Hint: You must find the distance the plane travels in 1200 s assuming constant acceleration.)
A loaded ore car has a mass of 950 kg and rolls on rails with negligible friction. It starts from rest and is pulled up a mine shaft by a cable connected to a winch. The shaft is inclined at 30.0 above the horizontal. The car accelerates uniformly to a speed of 2.20 m/s in 12.0 s and then continues at constant speed. (a) What power must the winch motor provide when the car is moving at constant speed? (b) What maximum power must the winch motor provide? (c) What total energy has transferred out of the motor by work by the time the car moves off the end of the track, which is of length 1 250 m?
A student expends 7.5 W of power in lifting a textbook 0.50 m in 1.0 s with a constant velocity. (a) How much work is done, and (b) how much does the book weigh (in newtons)? The answers to Confidence Exercises may be found at the back of the book.
A 5.0-kg box rests on a horizontal surface. The coefficient of kinetic friction between the box and surface is K=0.50 . A horizontal force pulls the box at constant velocity for 10 cm. Find the work done by (a) the applied horizontal force, (b) the frictional force, and (c) the net force.
A 6.50 102-kg elevator starts from rest and moves upward for 3.00 s with constant acceleration until it reaches its cruising speed, 1.75 m/s. (a) What is the average power of the elevator motor during this period? (b) How does this amount of power compare with its power during an upward trip with constant speed?
(a) Find the useful power output of an elevator motor that lifts a 2500-kg load a height of 35.0 m in 12.0 s, if it also increases the speed from rest to 4.00 m/s. Note that the total mass of the counterbalanced system is 10,000 kg—so that only 2500 kg is raised in height, but the full 10,000 kg is accelerated. (b) What does it cost, if electricity is $0.0900 per kW h?
. A particular hydraulic pile driver uses a ram with a mass of 1040 kg. If the maximum pile energy is 11,780J, how high must the ram he raised to achieve this value? Assuming it takes 0.62 s for the pile driver’s winch motor to raise the ram at a constant speed to this height, what is the power output by the motor in completing this task? Express your answer in both watts and horsepower.
Give an example of a situation in which there is a force and a displacement, but the force does no work. Explain why it does no work.
The force acting on a particle is Fx = (8x 16), where F is in newtons anti x is in meters. (a) Make a plot of this force versus x from x = 0 to x = 3.00 m. (b) From your graph, find the net work done by this force on the particle as it moves from x = 0 to x = 3.00 m.
A 537-kg trailer is hitched to a truck. Find the work done by the truck on the trailer in each of the following cases. Assume rolling friction is negligible. a. The trailer is pulled at constant speed along a level road for 2.30 km. b. The trailer is accelerated from rest to a speed of 88.8 km/h. c. The trailer is pulled at constant speed along a road inclined at 12.5 for 2.30 km.
. A compact car can climb a hill in 10 s. The top of the hill is 30 in higher than the bottom, and the car’s mass is 1,000 kg. What is the power output of the car?
A sled of mass m is given a kick on a frozen pond. The kick imparts to the sled an initial speed of 2.00 m/s. The coefficient of kinetic friction between sled and ice is 0.100. Use energy considerations to find the distance the sled moves before it stops.