(a) For the circuit shown in Fig. 20-27, let & = 10 V, R = 5.0N, and C = 0.1 F. What is the current %3D %3D at b just after the switch is closed? (b) How much charge will have passed b by the time the current goes to zero? (c) Find the current at the instant the capacitor has a charge of 0.20C.

(a) For the circuit shown in Fig. 20-27, let & = 10 V, R = 5.0N, and C = 0.1 F. What is the current %3D %3D at b just after the switch is closed? (b) How much charge will have passed b by the time the current goes to zero? (c) Find the current at the instant the capacitor has a charge of 0.20C.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Related questions

Q: (a) Of what material is a wire made, if it is 20.0 m long with a 0.150 mm diameter and has a…

A: Given: The length of the wire is 20 m. The diameter of the wire is 0.15 mm. The resistance of the…

Q: The resistance R of a copper wire at temperature T = 22°C is R = 13 2. Estimate the resistance at T…

A: Given data The initial resistance is, R1=13 Ω The initial temperature is T1=22oC The final…

Q: E- 18 V -W- -W- 12 2 52

Q: (C) A coil of 400 turns is wound uniformly on an annealed steel core with a mean circumference of…

A: Reluctance is the opposite that the magnetic circuits offers to the passage of magnetic flux through…

Q: .35 O In Fig. 26-30, current is set up through a truncated right circular cone of resistivity 731 n…

A: The current i enters the truncated cone at left end and leaves at the right end. Let this represent…

Q: 51 GO SSM www Wire C and wire D are made from different materials and have length Lc LD = 1.0 m. The…

A: I have use the concept of Ohm's law

Q: (!) THE FOLLOWING QUESTIONS ARE BASED ON THE INFORMATION GIVEN HERE. A rod of semiconducting…

Q: 27-1. In Figure, the ideal batteries have emfs E,= 10.0 V and E2 = 0.500 E,, and the resistances are…

A: i1= current in R1 i2= current in R2 i3= Current in R3 E1= emf of battery 1 = 10 v E2= emf of battery…

Q: (b) Suppose node f in Figure 2 is connected to ground, and the elements in the circuit have the…

Q: If the resistor is made of carbon, what will its resistance be when its temperature is increased by…

Q: (b) A voltage of 3 V is applied across the ends of a copper alloy conductor which has a resistance…

Q: The temperature coefficient of a certain conducting material is 4.78 × 10-3 (°C)-1. (a) At what…

Q: As shown in Fig.28-2(a), a battery (internal resistance 1 ohm) is connected in series with two…

A: E = V + Ir Where E = emf of the cell I = current through the circuit r = internal resistance of the…

Q: 80. FIGURE 21-54 shows a simplified circuit for a photographic flash unit. This circuit consists of…

A: For charging of capacitor we will use

Q: (a) At what temperature would the resistance of a copper conductor be double its resistance at 20.0…

Q: A capacitor of capacitance C is discharging through a resistance R. (A) in terms of the time…

A: Given: capacitance c resistance R time constant T=RC

Q: The temperature coefficient of a certain conducting material is 4.52 x 10-4 (°C)-1. (a) At what…

A: Thermal coefficient of temperature (alpha) = 4.52 x 10-4

Q: The resistance R of a copper wire at temperature T = 25 °C is R = 112. Estimate the resistance at T…

A: The resistance R of a copper wire with a temperature T in C is R(T).Then, given that R(25)=11 and…

Q: The resistance R of a copper wire at temperature T = 30°C is R = 13 Q. Estimate the resistance at T…

Q: (b) 1. A platinum resistance sensor has a resistance of 100 £2 at 0 °C and a temperature coefficient…

Q: 95 In Fig. 27-79, E, = 6.00 V, 12.0 V, R = 100 0, 200 N, and R, = 300 N. R = One point of the…

Q: (6) Calculate the valui of resistors havring colou bands in the following order. is Blue, Grey,…

A: (i) Explanation: According to the color code of carbon resistor, blue stands for 6, grey stands for…

Q: () THE FOLLOWING QUESTIONS ARE BASED ON THE INFORMATION GIVEN HERE. R2 The emf source, E = 2.1 V, of…

A: Charge on capacitor: The charge on the capacitor is proportional to the potential difference between…

Q: (i) A battery has an emf of 3.0 V and an internal resistance of 0.0200 Ω. What is the terminal…

A: Given: The emf in the battery is ε=3 V. The internal resistance is R=0.02 Ω. The current is I=2 A.…

Q: For each circuit shown in Fig. 28-3, determine the current I through the battery.

Q: (a) To what temperature must you raise a copper wire, originally at 20 °C, to double its resistance…

Q: For problem 27.29 find the magnitude of the current in resistor 1 if it has a resistance of 18.4…

Q: (II) A rectangular solid made of carbon has sides of lengths 1.0 cm, 2.0 cm, and 4.0 cm, lying along…

A: Current is dependent on voltage between 2 terminals. This is called Ohm's law. Mathematically,…

Q: An initially uncharged 4.77 x 10- F capacitor and a 6550 2 resistor are connected in series to a…

A: Given: C = 4.77*10-6 FR =6550 ohmV = 1.50 volt

Q: A nickel wire has a resistance R. If its length and diameter are both reduced by a factor of 4, its…

Q: Prove that when n identical resistors of resistance R are connected in parallel the equivalent…

Q: A block of weakly-conducting material with conductivity sigma has two pieces of metal embedded…

A: Given that: The capacitance of the capacitor isC. The conductivity will be σ. The resistance is R.…

Q: (a) When measuring the voltage across a resistor and the current through it, the voltmeter and the…

A: Remember:Ideal meters are theoretical concepts, and real meters have some internal resistance and…

Q: (c) Find the resistance per unit length of a gold wire with radius of 0.025 m. Given the…

Q: 17-2.A given copper wire has a resistance of 5.18 Ω at 20.0°C while a tungsten wire of the same…

A: Given, resistance of copper wire at 20.0°C , Rcu = 5.18 Ω resistance of tungsten wire at…

Concept explainers

Ohm's law

Ohm’s law is a prominent concept in physics and electronics. It gives the relation between the current and the voltage. It is used to analyze and construct electrical circuits. Ohm's law states that the voltage across a conductor is directly proportional to the current flowing through it.

Path of Least Resistance

In a series of alternate pathways, the direction of least resistance is the actual or metaphorical route that offers the least resistance to forwarding motion by a given individual or body.

Question

35 (a) For the circuit shown in Fig. 20-27, let & =
10 V, R = 5.0 N, and C = 0.1 F. What is the current
at b just after the switch is closed?
(b) How much charge will have passed b by the time
%3D
%3D
%3D
the current goes to zero?
(c) Find the current at the instant the capacitor has a
charge of 0.20 C.
9.
Soitch S

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

17-11 The thinnest copper wire normally manu- factured has a radius of 4 x 10-5 m. Find the resistance of a 10-m long segment. cha sec ch m in
In the circuit shown, R,=R2=R, and ɛ2 =. The power %3D 2 dissipated in R, is 40 W. Does battery &2 supply or absorb energy, what is the rate of energy &2 exchanges with the circuit? Assume that the batteries are ideal. R2=R R www www R R,=R www R Supply 48 J/s Supply 8 W O Absorb 8 W O Absorb 1 W O supply 120 J/s Absorb 12 W O Supply 1 W O Absorb 120 J/s O Supply 12 w Supply 4 J/s O None of them O Absorb 48 J/s Absorb 4 J/s
(III) A length of aluminum wire is connected to a precision10.00-V power supply, and a current of 0.4212 A is preciselymeasured at 23.5°C. The wire is placed in a new environmentof unknown temperature where the measured current is0.3818 A. What is the unknown temperature?
(1) THE FOLLOWING QUESTIONS ARE BASED ON THE INFORMATION GIVEN HERE. A rod of semiconducting material of length L = 9 m and cross-sectional area A = 5 mm² lles along the x-axis between x = 0 and x = L. The materlal obeys Ohm's law, and Its resistivity varies along the rod according top = po 1- where on = 3 x 104 2 · m. The end of the rod at x = 0 is at a potential V = 35 V greater than the end at x = L. A) What is the total resistance, in units of 2, of the rod? Answer: B) What is the current, In units of miliamperes, in the rod? Answer: C) What is the electric potentlal, In units of Volt, in the rod at x = L/2? Answer: D) What is the electric-field magnitude E, In units of V/m, In the rod at x = L/2? Answer:
(!) THE FOLLOWING QUESTIONS ARE BASED ON THE INFORMATION GIVEN HERE. A rod of semiconducting material of length L = 4m and cross-sectional area A = 4 mm? lies along the x-axis between a = 0 and a = L. The material obeys Ohm's law, and its resistivity (1=) varies along the rod according to p = Po where po = 4 × 10 4 2. m. The end of the rod at r = 0 is at a potential Vo = 35 V greater than the end at x = L. L² A) What is the total resistance, in units of N, of the rod? Answer: B) What is the current, in units of miliamperes, in the rod? Answer: C) What is the electric potential, in units of Volt, in the rod at a = L/2? Answer: D) What is the electric-field magnitude E, in units of V/m, in the rod at a = L/2? Answer:
Is it possible to connect a group of resistors of value R in such a waythat the equivalent resistance is less than R? If so, give a specificexample
Electrical conduction is a property of ionic solutions and the conductance of such electrolytic solutions depends on the concentration of the ions and also the nature of the ions (charges and mobilities). Given that electrolyte solutions obey Ohms law – express the resistance R of a solution in ohms (Ω).
Calculate the magnitude and direction of the durrents in each resistor of fig. 19-58. There are two solutions to this problem given on the website. However, both are leaveing out steps.
(1) THE FOLLOWING QUESTIONS ARE BASED ON THE INFORMATION GIVEN HERE. A rod of semiconducting material of length L = 10 m and cross-sectional area A = 4.5 mm2 lies along the x-axis between e = 0 and z = L. The material obeys Ohm's law, and its resistivity varies along the rod ~(1 -). where po = 5 x 10 4N · m. The end of the rod at z = 0 is at a potential L² according to p = Po Vo = 30 V greater than the end at z = L. B) What is the current, in units of miliamperes in the rod? Answer:
(d) Finally, consider the following circuit constructed with both copper (blue) and nichrome (orange) wires. + Assume all wires in the circuit have a diameter of 1.024 mm. If the total length of copper wire is 25 cm, the total length of nichrome wire is 115 cm (this wire is coiled so the length is greater than it appears in the figure), and a voltage of 1.5 V is applied to the circuit, what current will flow? I = 0.0210 ХА
(b) A circuit is shown in Figure 1. Given that the current, I = 0.500 A and resistance, R = 12.02. E + R 2R www 2R Figure 1 (i) Determine the current in the battery. (ii) Determine ε. [3 Marks] A [3 Marks] 24V
The terminal voltage of an isolated practical battery of EMF 8 V is: also 8 volts; O (The direction of the current it supplies should be given to determine whether the terminal voltage is less or greater than the EMF.) greater than 8 volts; less than 8 volts;