A fluid, contained in a horizontal cylinder fitted with a frictionless leak proof piston, is continuously agitated by means of a stirrer passing through the cylinder cover. The cylinder diameter is 0.40 m. During the stirring process lasting 10 minutes, the piston slowly moves out a distance of 0.485 m against the atmosphere. The net work done by the fluid during the process is 2 kJ. The speed of the electric motor drivingthe stirrer is 840 rpm. Determine the torque in the shaft and the poweroutput of the motor.

Q: nk y

A: Distillation is a process where the liquid mixture is seperated by boiling dur to the difference in…

Q: A pump delivers water, density =1000kg/m3, at a volume flow rate of 0.004256 m3/sec.  If the head…

A: Given:Water density, ρ=1000 kg/m3Volume flow rate of water, Q=0.004256 m3/secHead developed by the…

Q: A power plant requires 940 L/min of water. The required net head is 5 m at this flow rate. An…

A:

Q: 4. A pump pushes 1000 m³ of liquid water at 15°C up to a reservoir at 200 m higher elevation. The…

A: 4. Given data :

Q: Please answer my quistion. The indicated efficiency of a steam engine is 65 %. The engine entrance…

A: Given, h1 = 2600 kJ/kg h2 = 2100 kJ/kg m˙=3000 kg/hr  ηI=65%ηM=90%

Q: A steam turbine is used to test a large pump. The inlet temperature and pressure of the turbine are…

A: The inlet condition of turbine is P1=4 MPa, T1=300°C The exhaust condition of turbine is P2=0.101325…

Q: A booster pump on a brake system designed to be used horizontally consists of two cylinders capped…

A:

Q: you have a flat tire and need to pump up the tire on your car  with a hand pump, what force do you…

A:

Q: Q3/ A reaction turbine has mean blade speed of 220 m/s and blade speed to steam velocity ratio of…

A: To determine the angle at inlet of blade and work done per kg of steam flow, we can use the…

Q: Determine the electrical power supplied to a boiler when the temperature of the entering water is 20…

A: The inlet and exit temperature respectively are 20 degree Celsius and 89 degree Celsius. Also, the…

Q: Q2) A motorist equips his automobile tyres with a relief – type valve so that the pressure inside…

A:

Q: The characteristics of a centrifugal pump operating at 1000 rpm is given by H=41-2100². The system…

A: GivenThe characteristics of a centrifugal pumpwhen N=1000 rpmH=41-210 Q2The system characteristics…

Q: The minimum fresh air requirement of a residential building is specified to be 0.35 air change per…

A: Calculate the volume of the building:

Work and Heat Transfer

It is generally related to thermal engineering which tells about the use, creation, conversion and transfer of heat energy between the systems. It is also considered that to transfer heat from one source to another, transfer of masses is also required. There are various mechanisms by which, transfer of heat takes place i.e. thermal conduction, convection, radiation or by change of phase. All these mechanisms have their own specific features which sometimes occur simultaneously within the same system.