A dryer is designed to evaporate a constant amount of water every hour. When the dryer runs using 5 tons of feed per hour, a product weighing 3.4 tons and containing 11.6% water was produced. If the product must not contain more than 4% water, calculate the amount of feed required and the amount of product formed.

A dryer is designed to evaporate a constant amount of water every hour. When the dryer runs using 5 tons of feed per hour, a product weighing 3.4 tons and containing 11.6% water was produced. If the product must not contain more than 4% water, calculate the amount of feed required and the amount of product formed.

Welding: Principles and Applications (MindTap Course List)

8th Edition

ISBN:9781305494695

Author:Larry Jeffus

Publisher:Larry Jeffus

Chapter11: Gas Metal Arc Welding

Section: Chapter Questions

Problem 10R: Why must you always wind the wire tightly into a ball or cut it into short lengths before discarding...

See similar textbooks

Similar questions

Consider a highly automated processing plant having an output rate of 1.0 kg/s of product and requiring principal processing steps of heat transfer, reaction, and distillation. What are the operating labor requirements for an annual operation of 300 days?
A flat plate is to be cast in an open mold whose bottom has a square shape of 12.5 cm by 12.5 cm. The mold is 7.0 cm deep. A total of 350 cm³ of molten aluminum is poured into the mold. Solidification shrinkage is known to be 6.25%, which is a volumetric contraction, not a linear contraction. Table 7.1 lists the linear shrinkage due to thermal contraction after solidification. If the availability of molten metal in the mold allows the square shape of the cast plate to maintain its square dimension until solidification is completed, determine the final dimensions (width and height) of the plate.
Q2: True centrifugal casting is performed horizontally to make large diameter copper tube sections. The tubes have a length= 1.0 m, diameter= 0.25 m, and wall thickness = 15 mm. (a) If the rotational speed of the pipe = 700 rev/min, determine the G-factor on the molten metal. (b) What volume of molten metal must be poured into the mold to make the casting if solidification shrinkage and contraction after solidification are considered? Solidification shrinkage for copper = 4.5%, and solid thermal contraction = 7.5%? %3D
PLEASE ANSWER QUICKLY
Q1.Write down your answer briefly. i) Why is the permeability of shell mold higher as compared to sand mold? ii)What type of die casting process is mostly preferable for higher production rate? Justify your answer. iii) Bauschinger effect can be reduced by the stress aging process. Justify your answer. iv) Why is the sand for foundry practice called green sand? Can it be used for the core making process? v) What is moldability? How do you determine moldability of molding sand? vi) Which casting process is usually preferred for producing long tubular objects? Is it possible to manufacture a solid and parallelepiped object having different dimensions in a centrifugal casting process? Justify your answer. vii) What is directional solidification? How does a riser promote directional solidification?
Consider a highly automated processing plant having a capacity of 1.0 kg/s of product and requiring principal processing steps of heat transfer, reaction, and distillation. What are the average operating labor requirements for an annual operation of 300 days?
Find the molal flow rates of the distillate and the bottoms
4. Is a fire hydrant more likely to be cast or forged? Why?
How does the tension in the string change as the masses start to move? Or does it?
Do not answer in image format
How did you get the temperature 367? What is the solution?
Question: 965 Ib of Dates (Cured) are entered at 85 °F and stored at 2 °F in storage cooler each day. Calculate the product load in Btu/24 hr.