What will be the surface roughness x of the product due to the compressibility of the oil in the cylinder of the rectilinear hydraulic motor (PCH) of the copier if the pressing force fluctuates due to the unequal hardness of the material in the range Fmin = 720 N to Fmax = 865 N? The diameter of the PČH cylinder is d = 25 mm, the volume in the cylinder and the supply line is V0 = 55 cm3, the compressibility coefficient of the oil

Q: Calendering is a special manufacturing process in which large volumes of rolled thin plastic films…

A:

Q: describe the five types of reservoirs and draw pressure-temperature phase diagram of each fluid

A: Types of Reservoirs : Single phase gas reservoir: It primary consist of recovery mechanism of…

Q: How can we determine the maximum displacement?

A: The expression for the displacement of the simple harmonic motion is given by, Here, x is the…

Q: What does it mean to be an independent slip system?

A: Slip system: It is a combination of slip planes along which the probability of deformation is…

Q: 4. Find the x and y reactions at the pins at A - D and Find the Tension in the cable at the motor.…

A: Find the x and y reactions at the pins at A - D.Find the Tension in the cable at the motor.

Q: A 5.1 cc/rev motor has a volumetric efficiency of 88%. The motor's shaft is turning at 1575 rev/min.…

A: Volume of motor = 5.1 cc/revVolumetric efficiency = 88%N = 1575 rev/min.To find: Flow rate of fluid…

Q: How can the average shear stress be related to the torque?

A: Let us consider an example of a cylinder rotating in viscous fluid with some average shear stress…

Q: Compare viscous damping and coulomb damping。

A:

Q: Determine the transfer function G(s) 82(5) = for the gearing system as shown. T(S)

A: Write the given data by using the diagram.

Q: How did you simplify the torque equation at the beginning of step 5?

A: From step 4, we have following expression by balancing torques 1043.784 cosθ-3.2 N1 sinθ=01043.784…

Q: 2###4### Industrial Pipes Should the reinforcement rings for pipe taps have at least the same area…

A: The question is asking whether the reinforcement rings for pipe taps should have at least the same…

Q: 161 About industrial piping HOW ARE SIZING CALCULATIONS MADE FOR THE DEFINITION OF SPRING SUPPORTS?

A: The objective of this question is to understand how to perform sizing calculations for defining…

Q: when would you use a pressure transducer coupled to an oscilloscope

A: Pressure transducers are the important parts used in an electric curcuit, it convert fluid pressure…

Q: what happens when w/wn > than sqrt(2)? what happens to the damping and why did it switch, like the…

A:

Q: The following Brayton cycle is assumed to operate on air with an inlet pressure of 100 kPa, an inlet…

A: