A dirigible is tethered by a cable attached toits cabin at B. If the tension in the cable is1040 N, replace the force exerted by the cableat B with an equivalent system formed by twoparallel forces applied at A and C.AB6.7 m '4 m60°D To keep a door closed, a wooden stick iswedged between the floor and the doorknob.The stick exerts at B a 175-N force directedalong line AB. Replace that force with anequivalent force-couple system at C.y750 mm67 mm1850 mmB990 mmA594 mm100 mm

Answered: Image /qna-images/answer/f3677474-cb5f-4105-9751-04c1fb12a208.jpg

A dirigible is tethered by a cable attached to its cabin at B. If the tension in the cable is 1040 N, replace the force exerted by the cable at B with an equivalent system formed by two parallel forces applied at A and C.

A dirigible is tethered by a cable attached to its cabin at B. If the tension in the cable is 1040 N, replace the force exerted by the cable at B with an equivalent system formed by two parallel forces applied at A and C.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: 0.4 m A 4.8 m 0.6 m 5.6 m 4.8 m x PROBLEM 3.51 A farmer uses cables and winch pullers B and E to…

Q: The force P has a magnitude of 300 N and is applied at the end C of the rod ABC, as shown. Assuming…

Q: Part A: The cell tower in Figure a is guyed by three cables as shown. If the tension in cable AC is…

Q: The weight of the plate is 300-N.. The tension in cable AB is 350-N, and tension in cable CD is…

A: Given data, Weight of the plate, W = 300 N Tension in cable AB, TAB = 350 N Tension in cable CD, TCD…

Q: 4m m 1500 kN 2500 kN 3 2m m 3m m 10 m 4.

A: Given, External forces are 2500 kN and 1500 kN

Q: A 10-H boom is acted upon by the 50 - lb force shown. Determine the tension in each cable.

A: Write the position vector of point B and C, Write the unit vector from B to D.

Q: Two strings are passed around the four 1-in.-diameter pegs that are attached to a board and pulled…

A: Two loads are 35 lb ad 25 lb peg diameter = 1 in find magnitude and direction of resultant couple…

Q: O5) The motor mounted on the bracket is acted on by its 300 N weight, and its shaft resists the 200…

A: Data given - force along x- direction, Fx =-200 i` N Write the force along y-direction, Fy = 0 j`…

Q: A horizontal beam weighing 300 N is attached to a wall. It is supported by a cable which makes an…

Q: A farmer uses cables and winch pullers B and E to plumb one side of a small barn. If it is known…

Q: A transmission tower is held by three guy wires attached to a pin at A and anchored by bolts at B,…

A: we solve this question by resolution of component of force in 3D ( 3 dimensions). given dimensions…

Q: A 550 N cylinder 1.4 m in diameter is lodged between two cross pieces which make an angle of 110°…

Q: The tension in cable AB is 17 kN. Replace this force as it acts on point A by an equivalent…

Q: Determine the magnitude of the moment about A ( lb in) that produces the 125 lb force necessary to…

A: According to the given dataWe need to findmoment due to force to open the window.

Q: Show the detailed diagrams, calculations, and solutions. A transmission tower is held by three guy…

A: B=-20,0,25A=0,100,0 T=525 lb=2335.316348 N≈2335.316 N

Q: ane shown in the figure below is subjected to three coplanar forces. Replace this ➡ an equivalent…

A: Given: The first force acting on crane is, F1=175 lb. The second force acting on crane is, F2=60 lb.…

Q: A crane boom is supported by cables ac and ad. a worker lifts a 25 kg block by pulling a rope that…

A: Given Datam=25kgIn this we are taking the Vector componets according to the Points A,B,C,D,E

Q: A |C 70°/ A 50 kg load is lifted by the pulley system shown. Determine the tension in the cable ABC…

Q: Three cables are used to tether a balloon as shown. Determine the vertical force P exerted by the…

Q: 5. A transmission tower is held by three guy wires attached to a pin at A and anchored by bolts at…

A: (a) To find: The force exerted by the tower at point A. Given: The tension in the wire AB is TAB=110…

Q: A transmission tower is held by three guy wires attached to a pin at A and anchored by bolts at B, C…

A: Given data To determine the vertical force P exerted by the tower on the pin at A if the tension…

Q: with the following modifications: Replace the vertical 6kN at point B with a horizontal force 6kN…

Q: Show the complete solution: Two cables tied together as shown in figure , Knowing that Q = 60 lbs…

A: Consider the free body diagram of the point C.

Q: A uniform beam ( weight 71 N, length 6m) is being supported by cable and a hinge on a wall. The…

Q: b. Find the tension in the string. C. Find the magnitude of the force exerted on mass m₂ due to mass…

Q: A small boat hangs on two cranes, one of which is shown in the figure below. The tension in the line…

A: Given data: T=82 lb Need to determine the moment about C of the resultant force RA exerted on the…

Q: Cable AB is 65 ft long, and the tension in that cable is 3900lb. Identify the (a) x, y, and z…

Q: Given a system made of the force F, couple M and distributed loads defined by w1 and w2, find the…

A: To find : The equivalent system at B Given : The Force is F=8 kN The moment is M=5 kN·m The…

Q: 5. A transmission tower is held by three guy wires attached to a pin at A and anchored by bolts at…

A: Given: The tension in wire AB, TBA = 110 lb

Q: An 8-m long cantilever beam is loaded with vertical forces A = 60 kN and B = 108 kN, separated by a…

Q: Problem 3 Determine the moment exerted by cable AB about point C. The force in the cable is 700 lbs.…

A: Given data Force in cable AB (F) = 700 (lbs) Find the moment about point C

Q: 30° F y 5 m 3 m 6 m 3 m --x T

Q: A disabled automobile is pulled by means of two ropes as shown. Knowing that the tension in rope AB…

A: `Given: The tension in rope AB is FAB = 3 kN. The resultant force at A is R = 4.8 kN.

Q: A 6-ft-long fishing rod AB is securely anchored in the sand of a beach. After a fish takes the bait,…

A: Given: length of the fishing rod = 6 ft Resultant force = 8.6 lb

Q: Two cables are tied together at C and loaded as shown. Determine the tension (a) in cable AC, (b) in…

A: The free diagram of the cables are shown below, Here, TAC and TBC are the tension in cable AC and…

Q: Q.1/The top view of a revolving entrance door is shown. Two persons simultaneously approach the door…

Question

A dirigible is tethered by a cable attached to
its cabin at B. If the tension in the cable is
1040 N, replace the force exerted by the cable
at B with an equivalent system formed by two
parallel forces applied at A and C.
A
B
6.7 m '4 m
60°
D

To keep a door closed, a wooden stick is
wedged between the floor and the doorknob.
The stick exerts at B a 175-N force directed
along line AB. Replace that force with an
equivalent force-couple system at C.
y
750 mm
67 mm
1850 mm
B
990 mm
A
594 mm
100 mm

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The link shown is subjected to two forces F1 and F2. ... Determine the magnitude and direction of the resultant force. ... F = 750 N F = 300 N F = 400 N 30° 50°
A barge is pulled by two tugboats. The barge is aligned horizontally while the rope of tugboat 1 is inclined with the horizontal 0-degrees upward, and rope of tugboat 2 is inclined with the horizontal 'a'-degrees downward. If the resultant of the forces exerted by the tugboats is a 6,261-lb force directed along the axis of the barge and 0=36 degrees, determine the magnitude of the tension (Ib) in rope 1 if a = 51° Answer in 2-decimal places only if applicable, and don't include units. A
A transmission tower is held by three guy wires attached to a pin at A and anchored by bolts at B, C, and D. If the tension in wire AC is 920 lb, determine the vertical force P exerted by the tower on the pin at A.
3. The hinged door shown has a chain attached at point C connected to point B. It has a tension force of 250 N. To maintain the door in that position shown, what is the magnitude of the moment of the axis where the hinges are attached? 2.5 m 1.5 m Fc = 250 N. 30 1 m 0.5 m
Refer to Fig. 2.4. The tension in the cable BD is 1 kN. As a result, cable BD exerts a 1-kNforce on the “ball” at B that points from B toward D. Determine the moment of this forceabout point A. please show the detailed solution. thank you
The cable shown supports a girder which weighs 850 lb/ft. Determine the tension in the cable at points A, B, and C.
Two forces A and B are applied on an object. If force A is 15 N at 30 degrees North of East and force B is 20 N at 30 degrees West of North. Determine the magnitude and direction of a third force C to be applied on the object that will put it in equilibrium.
The bracket, which is fastened to a wall by anchor bolts at A and B, is loaded by the force P = 140 N and the couple C = 180 N•m. Replace P and C with (a) an equivalent force-couple system, the force of which acts at A; and (b) two vertical forces, one acting at A and the other at B.
2. The resultant of the three cable forces pulling on A is vertical and equal to the weight, W, of the suspended object. All three cables are in ten- sion. (They pull on the ring at A.) If the angles ß and y, as well as the weight W and forces FAB and FAc in cables AB and AC, respectively, are given, what are the force FADİN cable AD and the angle 8 in terms of given quantities? B D. A
Knowing the tension in cable AC is 795 N, determine the components of the force exerted by the cable on the support at A. in this problem. The wooden board will not be in your FBD.) (Note: Our FBDS are focused on points not objects. Your FBD should show the “special points" 400 mm 450 mm 600 mm B D C 600 mm