Knowing the tension in cable BD is 1300 N, the shown system can be simplified to the following force-couple system at B: F = (50 i-1950 j) N C=397500 N·mm Another equivalent force-couple system is expressed as simply the resultant force F placed at a certain distance d between points A and B as shown on the figure (measured from B). What is the distance d that gives an equivalent system? 750 N 150 mm 250 mm -500 mm A 450 N 400 mm B C D 600 mm

Q: 16. When a liquid is at a temperature lower than its saturation point, it is said to be

A: When the liquid is at a temperature lower than the saturation point then it is called Compressed…

Q: 1 "16. You have just moved to a hot, dry climate where it is 37C and 20% rh, and the heat is…

A:

Q: b) The bore diameter of each cylinder in a six-cylinder four-stroke internal combustion engine is 32…

A:

Q: Convert each temperature. 22 °C to K (approximate room temperature)

A: Given, temperature = 22oC we know 1oC = 273 K

Q: A power plant turbine releases its discharge into a condenser operating at 20C at 100% saturated…

A: It is given that:condenser temperature is 20°C. Steam enters condenser as 100% saturated vapor.Mass…

Q: 1. A pressure transducer is used multiple times to measure the pressure in a tank. It turns out that…

A: Accuracy is how close the measurement to the true values. While precision is how consistent or how…

Q: The bore diameter of each cylinder in a six-cylinder four-stroke internal combustion engine is 32 mm…

A: Find  Mean effective pressure, Indicated Power

Q: Stall speed of an aircraft depends on:

A:

Q: Diogrum height, cm The bore diameter of each cylinder in a six-cylinder four-stroke petrol engine is…

A: Given  No of cylinder K=6 4 stroke engine,

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.