A) Determine the primary constants, R, L, G, and C for a distortion-less line working at 300 MHz. Given that the line has characteristic impedance, Zo =752, .attenuation constant a=0.12Np/m, and wave velocity, v=1.4×10*m/s

A) Determine the primary constants, R, L, G, and C for a distortion-less line working at 300 MHz. Given that the line has characteristic impedance, Zo =752, .attenuation constant a=0.12Np/m, and wave velocity, v=1.4×10*m/s

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: 763. (NEW) This is about two points, (x1,y1) and (x2,y2), on a straight line whose slope is given in…

Q: Q3) If the length of the transmission line is one-quarter wavelength (1 = 1 /4). Derive an…

A: We need to find out input impedance for quarter wavelength transmission line

Q: A load impedance given by Z1. = 100 –-ji00 2 is con- nected through a kossless transmission line…

Q: The transmission line has a characteristic impedance equal to 502, and it was found that the speed…

Q: Since a 50 ohm transmission line with phase constant (π/10) rad/m will be used at 500 MHz, what is…

Q: The observed standing-wave ratio on a 100-Ω lossless line is 8. If the first maximum voltage occurs…

A: Given: The observed standing-wave ratio on a 100-Ω lossless line is 8. If the first maximum voltage…

Q: Consider the transmission line in the figure below. RG t=0 VG Zo d The length of the line is d = 3…

A: Given transmission line The length of the line is d = 3 m. The source voltage VG = 15 V, and the…

Q: An air lossless transmission line is operating at frequency of 3 MHz and has a length of 1.75 A,…

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost other…

Q: The magnitude of the [A] parameter of a short transmission line is smaller than that of medium line.…

A: first we will write the expression for A constant for short and medium transmission line to judge…

Q: Write down the general expression for the input impedance of a transmission line of length 1 and…

A: "According to the Company's policy, we will solve only the first part of the question". We need to…

Q: A three-phase, 60-Hz, 69-kV transmission line has an inductance of 1.0531 mH/Km per phase and a…

A: In this question, We need to choose the correct options What is the transmission line parameter A?…

Q: A loss less transmission line with reflection coefficient 3 ⁄ 13 at load end is terminated by a load…

A: The given problem is from transmission lines. The detailed solution is given in the next step

Q: The voltage waveform on a lossless TL in air is given by: /(z)=200e-jßz + 30e*JBZ (V). The TL has a…

A: v(z)=200-jBz+30ejBz voltzo=50Ω, l=2λfind TL,zL, vload

Q: For a frequency of 100 MHz, a transmission line with characteristic impedance Z-100+j50 is…

A: Given, A transmission line with, Characteristic impedance, Z0=100+j50. Load impedance, ZL=50+j100.

Q: If the amplitude of the input reflection coefficient is 0.5 with an angle of 45 degrees and the…

Q: mpedance of Z = 50+ j502. Calculate the reflection load. e: = 0.44263.43° %3D = 0.44Z-63.43° |…

Q: The 0.1A length line has a characteristic impedance of 502 and is terminated with a load impedance…

A: Given data: load impedence ZL=5+j25 ohm. characteristic impedence Z= 50 ohm With the help of smith…

Q: tic impedanc by load 7 =1

A: The characteristics impedance is independent of the length of the line. Now, this voltage and…

Q: A transmission line having characteristic impedance 1202 is operating at 5000 * 105 rad/s, the line…

Q: A three-phase, 60-Hz, 500-kV transmission line has an inductance of 1.0424 mH/Km per phase and a…

Q: 763. (NEW) This is about two points, (x1,y1) and (x2,y2), on a straight line whose slope is given in…

Q: A lossless transmission line uses a dielectric insulating material with &r=2.4. If its line…

A: Given: εr=2.4C'=22pF/mL'=?

Q: A loss less transmission line of length 3.125m with characteristic impedance 502, is operating on…

A: Note :- As per guidelines we are supposed to answer only three subparts at a time. So, I request you…

Q: Problem 2: Given that the voltage standing-wave ratio S = 3 on a 50 O line, that the first voltage…

Q: A lossless transmissic sinusoidal steady sta has an amplitude of C [a] Find the average [b] Find the…

Q: A three-phase, 60-Hz. 765-kV transmission line has an inductance of 1.0071 mH/Km per phase and a…

A: Given Inductance and capacitance of a three phase transmission line.we need to determine the…

Q: We have a load with a return loss of 22dB, calculate the reflection coefficient I and the voltage…

Q: A transmission line has an inductance of 4 mH/loop km and a capacitance of 0.004µF/km. Determine,…

A: Inductance L = 4 mH Capacitance C = 0.004µF Frequency f = 1 kHz

Q: ). A transmission line has a characteristic impedance of 502 and a resistance of 0.1 Q/m. If the…

Q: an unknown impedance. The standing-wave ratio along the line is 2. The first two voltage minima are…

Q: A time domain reflectometer (TDR) of output impedance 50- sends a step voltage down a 50-2…

A: At t =0 (no reflection ) At V(0) = 50100 Vs Given from figure at t=06=12Vs=12 V (source voltage…

Q: Can you please illustrate in diagram and explain on how to do the Conductance Test of the Motor…

Q: Find out the general solution for a transmission line due to transient voltage,where ,e = f(x-at) +…

A: e = f(x-at) + F(x+at)

Q: A distortionless transmission line with a characteristic impedence of 50 N, and the attenuation…

Q: A transmission line in air with characteristic impedance Z0=50 ohm is terminated with a load…

A: The propagation constant (k) of the transmission line can be computed in the following way:

Q: Apply mason Rule (S&P) to block diagnon below. кла то e(s) p Git 623 ST LGH H₂ 6₁ to H3 H₂ ((S) H₁…

A: A system is represented by block diagram. Signal flow graph is graphical representation of system.…

Q: How do you derive the Telegrapher's Equations for a lossy transmission line? Why is it the bottom…

A: According to the question, we need to derive the Telegrapher's Equations for a lossy transmission…

Q: parallel plate transmission line.

A: Parallel Plate Transmission Line A Parallel Plate Transmission Line consist of two conducting…

Q: A lossless transmission line with characteristic impedance of Z0 = 1000 and length I = 52cm was…

A: Given data:

Q: The capacitance per unit length and the characteristic impedance of a lossless transmission line is…

A: Capacitance = C Characteristic impedance = Z0 We have to find the velocity of a travelling wave on…

Question

I want a solution for
branches A and B,
please
A) Determine the primary constants, R, L, G, and C for a distortion-less line
working at 300 MHz. Given that the line has characteristic impedance, Zo =752,
.attenuation constant a=0.12Np/m, and wave velocity, v=1.4×10*m/s
B) A lossless transmission line used in a TV receiver has a capacitance of 50 pF/m
and an inductance of 200 nH/m. Find the characteristic impedance for sections of a
line 10 meter long and 500 m long.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Trending now

This is a popular solution!

Step by step

Solved in 4 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Single Phase Controlled and Uncontrolled Rectifiers

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The Subject is Electromagnetic II .
A dispersionless transmission line is one which the wave velocity is not constant as a function of the frequency f. Select one: True False
I Need the answer fastTable Provided if needed
In a non-resonant transmission line, the reflection coefficient is equal to: a. infinite b. 1 c. 0 d. -1 An open line means that the: a. line can be used at any frequency b. input is open circuit c. termination is open circuit d. line has an air insulator It is the ratio of the load power to the incident power. a. return loss b. mismatch loss c. reflection coefficient d. propagation constant
For a Transmission line, draw the equivalent model & derive voltage and current expression. A transmission line has primary constant R= 0.1 ohm per meter,, G=0.02 mho per meter, L=0.01 micro Henry per meter and C= 100 pico Farad per meter. Find the characteristic impedance (Z0 ) at 5 GHz.
A lossless transmission line (TL) has a characteristic impedance of Zo= 250 2, a load impedance of ZR = 125 - j150 2 and its operating frequency is fo = 150 MHz. Use Smith chart to evaluate the following parameters: 1) The load admittance YR. 2) The reflection coefficient |KR|Z0R 3) The voltage standing wave ratio (VSWR). Then calculate the maximum and minimum impedance in this TL, (Zmax and Zmin). 4) The distance from load to the nearest maximum (dmax) and minimum voltage positions (dmin) (in meter). 5) Find Zd at a distance away from a load by d= 3.3 2. Then calculate Zd using TL equation. %3D 1244 d ENG O Type here to search
Q) A transmission line of negligible loss has a characteristic impedance of 600 Q. Calculate the VSWR along the line when it is terminated by an impedance of (400+j300) . What is the VSWR if the load is changed to a purely resistive one of 500 0?
A load impedance ZL = (45 - j60)2 is connected to a line that has a characteristic impedance 75Q. By using Smith Chart, determine the values for normalized load impedance (Z'), VSWR, reflection coefficient and angle of reflection coefficient (p20), load admittance (YL) and input impedance (Zin) when the length of transmission line is 0.062. 160o dihubungkan dengan talian yang mempunyai (45
For this transmission medium for Temperature as 294 °K, what will be the Noise power in this bandwith?
Return loss for a transmission line in terms of its reflection co efficient is given by: a) -20logl l in dB where r is the reflection coefficient. b) -10logl in dB where r is the reflection coefficient c) -10log (1/l l) in dB where coefficient r is the reflection d) -20log (1/1H) in dB where r is the reflection coefficient
I need the answer as soon as possible