Answered: A D /45 — ф'12 45 — ф'12 Granular soil…

A D /45 — ф'12 45 — ф'12 Granular soil |8 c' =0 B Figure 12.25 Nature of failure surface in soil considered in the analysis to determine Ppe

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: sandy slope. Given: H = 5.cd m., unit weight = 1b.ad kN/m³, and angle of internal friction = 3dº.…

Q: eral earth force per unit length of the wall. Also find the location of H = 5 m, H, = 2 m, H2 = 3 m,…

Q: Given: H = 7 m, y = 18 kN/m', 4' = 25°, c' = 12 kN/m2, 12.7 and a = 10°. Calculate the Rankine…

A: H=7 m, C'=12 kN/m2.

Q: A retaining wall of 6 m high has a saturated backfill of soft clay soil.The properties of the clay…

A: Given data γ sat = 17.56 kN/m3 Cu = 18 kN/m2 High=6m

Q: Figure shows a 4-m-high retaining wall, the wall is not restrained from yielding. Estimate depth…

A: Above given data we have to find depth of tension crack

Q: A 5 m high vertical wall retains an overconsolidated soil where OCR = 1.5, c' = 0, 6' = 33°, and y =…

A: Given Data: Height of vertical wall (H) = 5m Over consolidated soil OCR=1.5 Cohesion (C')=0 (means…

Q: In Figure 12.24, which shows a vertical retaining wall with a granular backfill, let H = 4 m, α =…

A: According to Caquot and Kerisel's theory, passive force per meter length can be calculated with the…

Q: The cross section of a cantilever retaining wall is shown in Figure 1. Calculate the factors of…

A: In Dam there is Two types of force is acting on a dam, one is sliding force which cause overturning…

Q: Refer to Figure 12.6a. Given the height of the retaining wall, H is 18 ft; the backfill is a…

A: Calculate the Rankine active earth pressure using formula σa=kaγH-2cka Here, ka is the coefficient…

Q: Refer to Figure 12.15. Here, H = 5 m, γ = 18.2 kN/m3, Φ' = 30º, ẟ' = 20º, c' = 0, α = 10º, and β =…

A: Given:- The height of the wall (H) = 5 m The unit weight of the soil (γ) = 18.2 kN/m3 Φ' = 30º, δ'…

Q: 8.1 For the cantilever retaining wall shown in Figure P8.1, let the following data be given: Wall…

A: Retaining walls are generally built to sustain the lateral action of soil to create sliding and…

Q: 26° and : A 6.0 m high retaining wall is to support a soil with unit weight 17.4 kN/m³, p= C=14.36…

Q: 12. A backfill of a retaining wall consists of y=19 kN/m³ which is 6 m high. Find the total earth…

A: Given data: A backfill of a retaining wall consist, Y = 19 kN/m3 Height, H = 6 m Coefficient of…

Q: 16.6 A 5 m high smooth vertical wall retains a clay backfill with c' = 10 kN/m², d' = 25°, and y =…

A: The given data is: c' = 10 kN/m2 ϕ' = 25° γ = 19.0 kN/m3 Clay is in active stage.

Q: Su = 50 kPa Vary = 17 kN/m³ Y = 18 kN/m³ 'sat 6 m

A: Assumption of Rankine Earth Pressure Theory :- Soil is Homogeneous and Isotropic.Backfill surface is…

Q: QUESTION 4. A retaining wall 6 m high with a vertical back face retains a homogenous saturated soft…

A: Given that: Height of retaining wall, H = 6mSaturated unit weight of soil,…

Q: A rigid retaining wall of 6 m eight has two layers of backfill. ne top layer to a depth of 1.5 m s…

A: To find depth of tensile crack

Q: A retaining wall is shown in Figure 11.23. Determine Rankine's active force, Pa, per unit length of…

Q: a. determine the active force, Pa, per unit length of the wall for Rankine’s active state. b.…

Q: Assuming a smooth retaining wall as shown below. Calculate the resultant passive force from all…

A: ConclusionThe passive earth pressure coefficient (Kp) for the retaining wall with a wall friction…

Q: Q.12 Two soil profile are used as backfill defined a retaining wall as shown in figure, where y, is…

A: Given- depth of soil=2 mcohesion c=0unit weights are 18 & 20 kN/m3

Q: Use Eq. (12.3), Figure P12.2, and the following values to determine the at-rest lateral earth force…

A: calculate the coefficient of earth pressure at rest for a normally consolidated soil using the…

Q: The following figure shows a soil system supported by a 4m high retaining wall. This is normally…

A: Height of retaining wall= 4mYw= 9.81kN/m³

Q: A 6 m vertical retaining wall is supporting a cohesionless horizontal backfill having a unit weight…

Q: Surcharge Sand Groundwater table Sand Y2 (saturated unit weight) Frictionless wall Figure 13.37…

A: Solution for problem 13.13: Using Rankines Passive Earth Pressure Given: γ1 = 16.2 kN/m3; γ2 = 19.9…

Q: Q5) Refer to the Figure below. Given the height of the retaining wall, H is 5.4 m; the backfill is a…

Q: 16N, 6 = 7. For a vertical retaining wall 5 m high with level backfill and the properties y = 32°, &…

A: Note : Since you have asked multiple questions, we will solve the first question for you. If you…

Q: 9, = 22.5 kPa %3D H, = 2.5 m Yr = 17 kN/m3 O = 25° %3D H2 = 4.5 m Ysat = 18.5 kN/m3 O = 30° %3D a)…

Q: Prob.9. A retaining wall 6 m high with vertical back, supports a cohesive backfill having unit…

A: Given that, Height of retaining wall, H = 6m Unit weight of soil, Y= 19kN/m³ Apparent cohesion, c =…

Q: The figure below shows a 6 m retaining wall in a non-homogeneous soil. Determine the total active…

Q: N 0 2 m 1 m y = 15.72 kN/m³ φ' = 30° ci = 0 Groundwater table Ysat 18.86 kN/m³ $2 = 26° c₂= 10 kN/m²…

Q: 45.) A retaining wall supports a horizontal backfill that is composed of two types of soil. First…

Q: A cantilever wall made of reinforced concrete (y. = 24 kN/m³) based on normally consolidated clay…

A: Pressure on the back of the wall will be active pressure calculation where as pressure at the front…

Q: For the given retaining wall as shown, determine the following: Note: The water table for the given…

Q: A vertical wall of 6 m height with a smooth back has silt as backfill, has following properties:…

A: to find the passive earth pressure acting on the wall from

Q: 13.13 through 13.15 A retaining wall is shown in Figure 13.37. For each problem, determine the…

A: Solution 13.13:- If the cohesion is zero σ'a=Ka×σ'v For the top soil layer and for bottom layer,…

Q: Prob.9. A retaining wall 6 m high with vertical back, supports a cohesive backfill having unit…

A: Height of retaining wall (H) = 6 m Unit weight of soil γ = 19 kN/m3 Apparent cohesion (C) = 26 kN/m2…

Q: 15. A backfill of a retaining wall consists of y=19 kN/m³ which is 6 m high. Find the lateral earth…

A: Given data: A backfill of a retaining wall consist, Y = 19 kN/m3 Height, H = 6 m Coefficient of…

Q: For a smooth vertical wall supporting a granular backfill with ϕ' = 34°, determine Ka using Eq.…

A: Ka is given by:

Question

Consider a 4-m-high retaining wall with a vertical back and horizontal granular backfill, as shown in Figure 12.25. Given: γ = 18 kN/m³, Φ' = 40º, c' = 0, ẟ' = 20º, k_v = 0, and k_h = 0.2. Determine the passive force P_pe per unit length of the wall taking the earthquake effect into consideration.

A
D
/45 — ф'12
45 — ф'12
Granular soil
|8
c' =0
B
Figure 12.25 Nature of failure surface in soil considered in the
analysis to determine Ppe

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Lateral earth pressure distribution against retaining walls

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A retaining wall supports a horizontal backfill that is composed of two types of soil. First layer: 5.64 meters high, Unit weight of 16.86 kN/m3, coefficient of active pressure of 0.281 Second layer: 5.42 meters high, Unit weight of 18.46 kN/m3, coefficient of active pressure of 0.304 Determine the distance of the total active force measured from the bottom of the wall. Round off to three decimal places. A Click Submit to complete this assessment. F2 FS F6 FB DIE 4 5 6 7 8 9 R Y G H K B LT V フコ因

Q.12 Two soil profile are used as backfill defined a retaining wall as shown in figure, where y, is total unit weight and d' and ' are effective shear parameters. Find the resultant active earth pressure is kN/m 2m 2m TKK 3 = 18 kN/m 3 1/2 = 20 kN/m c'= 0, 6 =30° d' = 0, & =40°
For the concrete gravity retaining wall shown in Figure (2), find the minimum base width of the wall for no tension to develop at the edge of the base. use yc = 24.0 kN/m³ F 6.0 m B kN m³ Yt 18.0- Ø=30.0° 8 = 0.0⁰ C₁=0 Figure No. 2
Q. Result. Thurst
sy
The following figure shows a section of an anchored retaining wall embedded into a saturated stiff clay layer. The sand has a unit weight of = 18 kN/m³, c' = 0 kPa and o' = 34º. The clay has a unit weight of = 20 kN/m³, c₁ = 80 kPa and = 0°. A uniform pressure of 40 kPa is applied on the soil surface. The short term stability of the wall is considered in an undrained analysis. Use the Rankin's theory of lateral earth pressure to determine the active and passive horizontal stresses. You should apply the requirements of AS 4678 and the partial factors of safety method in estimation of soil pressures. Assume the soil is in-situ and use a structural classification factor of ₁ = 1. 3m 1m Water table 1.5m 40 kPa Not to Scale Sand Clay Ta
is 7 m high with a horizontal backfill. For 12.4 A vertical retaining wall the backfill, assume that y = 16.5 kN/m', ' 26°, and c' = 18 kN/m2. Determine the Rankine active force per unit length of the wall after the occurrence of the tensile crack. For the retaining wall, determine the Rankine active force per unit length of the wall and the location of the line of action of the 12.5 resultant. 12.6 For the retaining wall, H = 8 m, h' = 36°, a = 10°, y = 17 kN/m', and e' = 0. a. Determine the intensity of the Rankine active force at z 2 m, 4 m, and 6 m. b. Determine the Rankine active force per meter length of the wall and also the location and direction of the resultant. 12.7 Given: H = 7 m, y = 18 kN/m', ' = 25°, c' = 12 kN/m2, and a = 10°. Calculate the Rankine active force per unit length of the wall after the occurrence of the tensile crack. YI H Groundwater table H Figure P12.2
4. A frictionless retaining wall is shown. Find the passive resistance (P) due to backfill and the location of the resultant passive force. q = 12 kN/m² Y = 15 kN/m³ o' = 26° c' = 10 kN/m² 4 m
A frictionless vertical retaining wall has a height of 4 meters and retains a horizontal surcharge of 11 kPa. The unit weight of the backfill is 15 kN/m3 with cohesion of 8 kN/m2 and an angle of friction of 260. Compute the active force (in kN) after the tensile crack.Answer: 26.82
Find the passive earth pressure coefficient. For a vertical retaining wall having a backfill of dry sand inclined at an angle of 20° from the horizontal