A cylindrical tank having a diameter of 16 cm weighing 100 KN is resting on a horizontal floor. A block having a height of 4 cm is placed on the side of the cylindrical tank to prevent it from rolling. What horizontal force must be applied at the top of the cylindrical tank so that it will start to roll over the block. Assume the block will not slide and is firmly attached to the horizontal floor. Pls show complete solution with figures.

Q: Hi, Can you help me to draw a free-body diagram for the attached picture? Note that at point A and G…

A: Detailed free body diagrams are given in explanation tab below....Explanation:

Q: The 2-ft-dia. can shown is rotated at 100 rpm (a) Find the force acting on the bottom of the can.…

A: Given: The diameter of can, d = 2 ft The speed of can, N = 100 rpm The initial height of water, ho =…

Q: Q2: - The ladder and the person weigh 30 lb and 180 lb, respectively. The center of mass of the…

A:

Q: Lipkin is standing on a scale while leaning with his hands on a wall at an angle of 600.  Draw a…

A: Suppose lipkin apply a force of magnitude 'F' towards the wall,

Q: 250N crate is pulled up a ramp that is angled at 20 degrees above the horizontal. If the coefficient…

A: Given:W=250 Nθ=20°μ=0.25

Q: A filled barrel has dimensions of a = 0.55m, b = 1.1m, and c = 0.6m, a total mass of 108kg, and has…

A:

Q: Consider a hollow clay cylinder, which has a moment of inertia 55 kg-m2. The cylinder is free to…

A: MOI; I = 55 range of force; F = 0 to 75 N radius range; R = 0 to 10m angular distance; o = 4π  time…

Q: The cable spool shown at the right has a weight of 50 lbs and has a moment of inertia of .28…

A: Given                  Weight, m = 50 lbs                  Tension, T = 50 lb Moment of inertia, I =…

Q: A horizontally positioned door weighing 1200 N is held in place by hinges centered at points A and B…

A: Given: The weight of door, W = -1200k

Q: A uniform ladder 5 m long and weighing 80N rests against on a vertical wall at B and one end at A…

A:

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.