A cylindrical tank has a mean radius of 40 cm and thickness of 10 cm. It is subjected to an external pressure of 140 kg/cm2 and maximum internal pressure is 900 kg/cm2 . Determine the maximum internal tangential stress of the tank. A. 3,884.7 kg/cm2 B. 4,623.6 kg/cm2 C. 1.7684 kg/cm2 D. 2,947.5 kg/cm2

Q: A 1-m-diameter cylindrical mass, M, is connected to a 2-m wide rectangular gate as shown in the…

A:

Q: e resultant force (kN

A: In the given figure,  The force on the plate considering atmospheric pressure has to be computed.…

Q: Consider the long gas container shown in the figure under an internal pressure pof 7 N/mm. The mean…

A: step 1-

Q: Air (1.23 kg/m³) flows past an object in a 2-m-diameter pipe and exits as a free jet as shown in the…

A:

Q: The piston rod of diameter 20 mm and length 700 mm in hydraulic cylinder is subjected to compressive…

A: A piston rod- Diameter d=20 mm, Length L=700 mm, Compressive force P =10 kN, End conditions- Guided…

Q: n the pressure at m is increased by 5.59 lb/in2, while the pressure at n remains constant, determine…

A:

Q: Neglecting the weight of all members, compute the maximum value of P that can be applied in the…

A:

Q: A flow of a viscous fluid with μ = 1.0 u a velocity distribution given by u = The shear stress at y…

A: velocity distribution = 0.9y - y2To Find :The Shear stress at y = 0.45 m

Q: 30 0.9 m 1.2 m •At depth h the pressure is pgh. •Force on a small element = pressure x area

A: To determine hydrostatic pressure force on submerged plate.   Given, Angle between the plate and the…

Q: A spherical pressure vessel has an inside diameter of 6 m and a wall thickness of 15 mm. The vessel…

A: Given: Spherical pressure vessel  Inside diameter  Thickness  Internal pressure  Yield strength

Q: 1. The Dam ABC has a width of 30 m into the paper and the dam bottom length is 60m. The dam material…

A: We will calculate each moment and find FOS.

Q: The vertical reducing section shown in the figure contains oil with S flowing upward at the rate of…

A:

Q: A spherical balloon with an outer diameter of 490 mm and thickness 0.3 mm is filled with a gas.…

A: step 1-

Braced cuts

The braced cut is a method of providing lateral support to the soil in foundation trenches, to prevent the trenches from deformation by the caving in of soil and resisting it from moving laterally. During shallow excavation in firm soil, generally, slopes are provided to resist the caving in of soil. During shallow excavation in soft soil and deep excavation, the chances of caving in of soil increase. Hence, it becomes necessary to make a provision to resist the deformation of trenches due to caving in of soil. The braced cut is the method used for such conditions. The excavation using braced cuts is a bit uneconomical as compared to the traditional open-cut excavation method but provides better safety than the cut excavation method.