A cylindrical rod with a diameter of 15.24 mm and a gauge length of 400 mm is subjected to a tensile load. If the rod is to experience neither plastic deformation nor an elongation of more than 0.45 mm when the applied load is 31000 N, which of the four metals or alloys listed below are possible candi- dates? Justify your choice(3). TABLE P1.12 Material E (GPa) Yield Strength (MPa) Tensile Strength (MPa) Steel alloy 1 Steel alloy 2 Titanium alloy Сopper 180 860 502 200 400 250 110 900 730 117 220 70

Q: I have a question If a sample of steel was acceptable to use at a temperature at -52 degrees c Why…

A: Brief concept introduction- Steel- It is an alloy that mainly contains iron and carbon. It has…

Q: 400 200 Strain 0.05 0.10 0.15 0.20 From your graph, plotting the yield stress against 1/vd, you…

A:

Q: A steel bar 4 inches long and having a square cross section 0.8 inches on an edge is pulled in…

A:

Q: Answer the following questions based on the given information in the table and further calculation…

A: Given, Stress strain data

Q: The stress–strain diagram for a steel alloy having an original diameter of 0.5 in. and a gage length…

A:

Q: A. Which material is considered as ductile and which one is considered as brittle? Explain. What is…

A: Part A) Material A has a typical ultimate stress point and breaking stress point, along with a clear…

Q: A mild steel specimen originally 300 mm long is pulled in tension with astress of 500 MPa. If the…

A: Given: The length of the specimen is 300 mm. The stress is 500 MPa. The modulus of elasticity is 200…

Q: A cylindrical rod with a length of 380 mm and a diameter of 10 mm is to be subjected to a tensile…

A: Answer Based on the given data, we can calculate the minimum Elastic Modulus required for possible…

Q: A piece of steel is said to have Young’s modulus of 29 × 106 psi. Based upon a yield strength of…

A: I

Q: A) A specimen of alloy having the following engineering stresses produces the corresponding plastic…

A: Given :-  To find :-  Engineering stress corresponding to engineering strain of 0.4

Q: 9 A brass alloy has a yield strength of 280 MPa, a tensile strength of 390 MPa, and an elastic…

A:

Q: TABLE P3.19 Specimen No. Carbon Content (%) 1 2 3 0.2 0.5 0.8 Deformation (mm) Load (kN) 0.00 0.07…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts…

Q: A tensile test was done on a steel specimen with the gauge length of 525 and a stress of 175 MPa. If…

A:

Q: Please solve the following problem step by step so I can understand.

A: Solution: