A cylindrical pressure vessel has an internal diameter of 2 m and is fabricated from plates 20 mm thick. If the pressure inside the vessel is 1.5 N/mm2 and in addition, the vessel is subjected to an axial compressive load of 2500 kN, calculate the normal and shear stresses on a plane inclined at an angle of 60⁰ to the axis of the vessel.

Q: Neglecting the weight of the bracket, calculate the three principal stresses, and absolute maximum…

A:

Q: the stresses at point A.

A: To find Stresses at point A

Q: A pipe has an outside diameter of 0.8 inches and inside diameter of 0.19 inches. A force of 105 lbs…

A: Given     Outside diameter, d2 = 0.8 in        Inside diameter, d2 = 0.19 in…

Q: Find the longitudinal stress in the tank.

A: To Find the longitudinal stress.

Q: Q6 A spherical vessel of 1.6m inner diameter is constructed by joining two hemispheres with equally…

A:

Q: Calculate the values of ol and o3 in the rock if the differential stress is 40 MPa and the center is…

A: differential stress = 40 MPa. (diameter of the Mohr's circle).Therefore, the radius of the Mohr's…

Q: A thick cylinder has an outside diameter of 100 mm and an inside diameter of 60 mm. It is…

A:

Q: = A machine component is fabricated from a bent tube as shown below. One part of the tube lies along…

A: Outside diameter, d0=122 mmInside diameter, di=108 mmForce F=8.5 kNLengths,L1=258 mmL2=118 mmL3=281…

Q: Applied mechanics: An undersea research vehicle has a spherical hull of 1m radius and a 40mm…

A: Radius r = 1m Thickness = 40mm High strength alloy steel  yield point =700MPa Relative density of…

Q: The closed thin-walled tank has an inner radius of r and wall thickness t and contains a gas of…

A:

Q: The thin-walled pressure vessel shown was fabricated using a spiral seam. The inner diameter is…

A:

Q: Can you please solve this homework problem with step by step solution

A: Step 1:  :

Stress transformation

The term stress indicates the measure of internal forces that develop due to an external force's application on an object. When a specific external force is applied to an object, internal stress generates in the material. The value of stress can obtain by taking the ratio of the externally applied force and cross-sectional area of the object. There are different types of stress depending on the type of external force.