A constriction in a pipe will cause velocity to increase and pressure to fall at the throat. The pressure difference is a measure of the flow rate through the pipe. This system, shown in the figure, is called a Venturi tube. Find the flow rate Q through the pipe if the fluid is water, the pressures P1 = 300 Pa, P2 = 150 Pa, D = 2 cm and d = 1 cm. %3D %3D pressure taps P2 d D Venturi Meter Parameters

Q: Figure shows a pipe system. At the entrance to the pipe (point 1), the diameter is d₁ and it is a…

A: Given: p1 =ϕ1

Q: From the theory, the equation governing the flow rate through a orifice meter is shown as follows:…

A: The inner diameter is The outer diameter is The difference in pressure is

Q: Q2/ Consider the following liquid level system shown below. The flow through the valve is related to…

A: Given Data:Find:Relationship between the head and time.

Q: The characteristics for a pump are given in the table below. The pump is required to left water…

A:

Q: PLEASE BOX YOUR ANSWERS 3.7 atm : The 6 cm diameter pipe contains a liquid (p = 1260 kg/m', u = 1.49…

A: density of the liquid, ρ=1260kg/m3viscosity of the liquid, μ=1.49kg/mspipe length,L=40mdiameter…

Q: A Pitot tube shown in the figure below has air of velocity V flowing as shown. If one of the…

A:

Q: Question 4 A sprinkler system pumps water through a large pipe inlet with a diameter (d₁). The pipe…

A: (a) To find: The expression for velocity of water leaving the sprinkler. Given: The inlet diameter…

Q: is desired to pass water from point 1 to point 3 to run a fluid engine, pressure p1= 700kpa and…

A: Power to be Transmitted = {density * flow * ( total required head)} / efficiency total head required…

Q: Keeping in mind continuity of flow, compute the velocity of flow for section C (Vc), the 6 inch…

A: Given Data

Q: 49. Water flows at a rate of 200 GPM into a piping system connected in series. Length, diameter, and…

A: Given:To find:(a) Total pressure drop.(b) Diameter of the equivalent pipe.

Q: Q1/ A hydraulic oil ISO 68 is flowing by velocity 20 ft/sec through a hydraulic line at a volume…

A:

Properties of Fluids

The term fluid represents a type of substance that can easily change its shape under any external pressure/force and can flow. Fluids can acquire any shape in which it is stored and can resist normal stresses but cannot resist shear stress in rest condition. Whenever external shear stress is applied to fluids, it starts to flow. The fluids may be liquid or gas. Example- water, air, etc.