A coal-fired power plant discharges 1 m^3/s of cooling water into a river, which has a flow of 9 m^3/s and a temperature of 20 degree C. According to the regulation, the temperature in the river immediately below the discharge cannot be increased by higher than 1 degree C. Therefore, what is the highest temperature of the cooling water is allowed for discharge?

Q: Subject: Fluid Mechanics/Hydraulics 1.) What is the specific weight of air in N/m3 at 442 kPa…

A:

Q: Water is flowing in a 90° triangular channel at a depth of 39 cm. A hydraulic jump occurs. The depth…

A:

Q: 11. A liquid flowss through two similar pipes 1 and 2. If the ratio of their flow velocities v1 : v2…

A: Head loss is directly proportional to the square of velocity.

Q: 3.18. Water is pumped from a supply reservoir to a ductile iron water transmission line, as shown in…

A: Given : Dia of pipe == 750 mm Pressure at A = 350 kPa

Q: Consider a house that is approximated as a cube that is 8 m on a side and has no windows. The house…

A: Given: Each side of house=8 m Inside temperature=20°C Outside temperature=-20°C Total heat loss per…

Q: Problem 2 Refrigerant-134a enters the compressor of a refrigeration system as saturated vapor at…

A:

Q: A wire 100 meter long at 20 °C has a linear temperature coefficient of 2 * 10-5. The wire is heated…

A: Initial length of the wire (L1) = 100m Initial temperature (T1) = 20°C Coefficient of linear…

Q: 2. With an initial pressure of 30x105 Pa and constant operating temperature of 200°K in a 40 m³-tank…

A: Given data:- Initial pressure =30×105 Pa Operating temperature =200°K Volume of tank =40 m3 Length…

Q: Water is pumped from a lower reservoir to a higher reservoir by a pump that provides 20 kW of shaft…

A: To Determine a) The mechanical energy required to maintain the water flow, b) mechanical power that…

Q: An le Volve Pump open P=150 kPa Water sprotruding entrance

A: Given data in question  Diameter of pipe Density of water Dynamic viscosity of water Length of pipe…

Q: A 10 m aluminium flagpole is installed at 30°C. After 2 days, the temperature drops to -10° C. How…

A:

Q: A well-insulated turbine operating at steady state is shown on the right. Steam enters at 3 MPa,…

A:

Q: 1 kg of steam undergoes a reversible isothermal process from 20 bar and 250 °C to pressure of 30…

A: Given Mass=1kg P1=20bar T1=250℃ P2=30bar

Q: Specific energy of flowing water through a rectangular channel of width 5 m when discharge is 10…

A: Given- Width B=5 m, Discharge Q=10 m3/s, Depth y=2 m,

Q: Water at 50°F is pumped from a lake at 750 gpm through a length of 3-inch schedule 40 commercial…

A: The Reynolds number represents the relationship between inertial and viscous forces. Fluid systems…

Q: A steel bridge span is normally 300m long. What is the difference in length, in cm between January…

A: Given,length of bridge span l=300mtemperature in january = -35°Caugust =40°Cdifference in…

Q: It is observed that the density of an ideal gas increases by 10 percent when compressed isothermally…

A: