A closed cylinder 0.6 m in diameter and 0.6 m in height is filled with water (p=1000 kg/m² ). If the cylinder is rotated about its vertical axis at a speed of 20 rad/s, then the ratio of thrust of water on the bottom cover of the cylinder to the top cover is (Take g = (10 m/s² )(Up to two decimal places) w = 20 rad/s 0.6 m 0.6 m >

A closed cylinder 0.6 m in diameter and 0.6 m in height is filled with water (p=1000 kg/m² ). If the cylinder is rotated about its vertical axis at a speed of 20 rad/s, then the ratio of thrust of water on the bottom cover of the cylinder to the top cover is (Take g = (10 m/s² )(Up to two decimal places) w = 20 rad/s 0.6 m 0.6 m >

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Câu hỏi Câu trả lời đã được lưu Đạt điểm 2.00 Ẹ Đặt cờ G Give mechanical system as shown in the figure. Give P = 1493 lb, a = 14 in; b = 11 in. P a а A Bo C b D F OPPO A77s The magnitude of horizontal component of reaction force at F (Fx) = 2416.55539 lb 2
A 15-kg solid cylinder rolls without slipping down the incline (30° with the horizontal). Determine the acceleration of point G. in the center of the cylinder. 5.66 m/s^2 O 7.83 m/s^2 O 6.32 m/s^2 O 3.27 m/s^2
This closed tank, which is 4 ft in diameter, is filled with water and is spun around its vertical centroidal axis at a rate of 10 rad/s. An open piezometer is connected to the tank as shown so that it is also rotating with the tank. For these conditions, what is the pressure at the center of the bottom of the tank? Provide your answer in psi.
A cylindrical water tower of diameter 3.5 m supplies water to a house. The level of water in the water tower is 30 m above the point where the water enters the house through a pipe that has an inside diameter 5.1cm. The intake pipe delivers water at a maximum rate of 2.2 ×10−3 m3 ⋅s −1. The pipe is connected to a narrower pipe leading to the second floor that has an inside diameter 2.5 cm. What is the pressure and speed of the water in the narrower pipe at a point that is a height 5.5 m above the level where the pipe enters the house?
6.2 At the concrete dam bottom shown in the figure, a pipe of diameter d takes water through a water turbine and discharges it into the 2/3 atmosphere. If the water head is h, the friction loss through the suction pipe is H1, and the pressure at the turbine inlet is p gage. Determine the fluid power P in kW that delivered by the turbine. Water h Concrete dam h = 85 m d = 140 mm p = 12.5 bar HL =10 m
A small boat weighing 40 LT has a submerged volume of 875 ft3 when traveling at 20knots in seawater. (ρ = 1.99 lb-s2/ft4 ; 1 LT = 2240 lb) a. Calculate the magnitude of the hydrostatic support being experienced by boat.b. What other type of support is the boat experiencing?c. Calculate the magnitude of this other type of support.d. What will happen to the submerged volume of the boat if it slows to 5 knots? Explain your answer.
As shown is a cylinder (r=0.8 m,) that is hinged at O. Compute the FR and ϴx. Analyze 1 m length. Use yw = 9.81 kn/m3 . Use 2 decimal places in every solved value, however use the whole value for the computation of volume.
The tank shown has one curved surface restraining a body of static fluid, with the following dimensions: w = 5.25 m h1 = 2.4 m R1 = 0.90 m Required Compute the magnitude of the resultant force, in kN, to the nearest 100th. Water h1 R1
Imagine that the water level in Problem 8.34 rises at a rate of 0.1 cm/s. Knowing the diameter of the tank is 15 cm, what is the average velocity of the water leaving the tank?
The tank shown in the figure below is accelerated vertically down at 9.8 m/s. If the tank is 4 meters wide, find the force acting on the wall BC. A Tank is open to atmosphere Tank is open to A atmosphere t0.5 m 2 m Water В 8 m C a = 9.8m/s²
Determine the natural frequency of the system shown in the figure. The beam is of negligible mass. Given: M=25 kg, E=200 GPa, I=5x10 m4, and k spring =5 kN/m. El 4 m 11
Water flows from 1 to 2 through curved nozzle as shown in the figure. The pressure at section 1 is 74 kPa and water flows into the atmosphere at section 2. The flow rate, Q=0.03 m³/s. Calculate the force to keep the nozzle in place. 25 cm² (2) \45° 150 cm? 40 cm Water (1)