A chemistry student in lab needs to fill a temperature-control tank with water. The tank measures 27.0 cm long by 21.0 cm wide by 10.0 cm deep. In addition, as shown in the sketch below, the student needs to allow 2.0 cm between the top of the tank and the top of the water, and a round-bottom flask with a diameter of 7.5 cm will be just barely submerged in the water. Calculate the volume of water in liters which the student needs. Round your answer to the nearest 0.1 L. 2 cm flask water

A chemistry student in lab needs to fill a temperature-control tank with water. The tank measures 27.0 cm long by 21.0 cm wide by 10.0 cm deep. In addition, as shown in the sketch below, the student needs to allow 2.0 cm between the top of the tank and the top of the water, and a round-bottom flask with a diameter of 7.5 cm will be just barely submerged in the water. Calculate the volume of water in liters which the student needs. Round your answer to the nearest 0.1 L. 2 cm flask water

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

An atom of a particular element has a volume of 6.1 x 10-31 m° . What is this volume in cubic nanometers please do in dimensional analysis
Copper is in the left beaker and zinc is in the right. Write a description of the macroscopic observations you may expect when testing this experimental design. We have a volt of +1.10. Will the light bulb glow? Example of Macroscopic observations are attached.
I need the inverse of each volumes Volume 1: 10.0 nm Volume 2: 6.0 nm Volume 3: 14.4 nm Volume 4: 11.3 nm Volume 5: 15.0 nm
1. Several students performed this experiment without paying adequate attention to the details of the procedure. Briefly explain what effect each of the following procedural hanges would have on the size of the volume- to- temperature ratio calculated by the students. (a) One student failed to replenish the boiling water in the boiling- water bath as the flask was being heated. At the end of the 6 min of heating, the boiling water in the bath was only in contact with the lower portion of the flask. (b) Following the proper heating of the flask in the boiling water, a student removed the flask from the boiling- water bath but only partially immersed the flask in the ice-water bath during the cooling period. (c) A student neglected to close the pinch clamp before removing the flask from the boiling water bath and immersing it in the ice-water bath. (d) One student neglected to measure the volume of the flask before leaving the laboratory. Because the procedure called for a 125-mL…
A marine biologist is preparing a deep-sea submersible for a dive. The sub stores breathing air under high pressure in a spherical air tank that measures 79.0 cm wide. The biologist estimates she will need 8600. L of air for the dive. Calculate the pressure to which this volume of air must be compressed in order to fit into the air tank. Write your answer in atmospheres. Be sure your answer has the correct number of significant digits.
The results for the demonstration for polarity of various substances presented in the image below. Note that each vial has two liquid layers, water and oil. (Oil is a hydrocarbon chain.) Use this image to complete the following question. oil oil oil oil oil water water water water water With iodine (dark purple solid) Blank With copper sulfate (ight blue solid) With sulfur (yellow solid) With sodium chloride (no solute) (colortess, ionic solid) Classify each of the compounds on display as a polar liquid, non-polar liquid, polar solid or non-polar solid.
Sketch a graph of density against temperature to show the variation of water density with temperature. Determine the density of water at 34 degrees in g/ml. Place the point on the graph. The temperature as the x axis and density as the y axis (g/ml).
The speed of light is (2.998e8m/s) How far does light travel in 4.0μs? Set the math up. But don't do any of it. Just leave your answer as a math expression. Also, be sure your answer includes all the correct unit symbols.
please see attached image
The following information is given in a science supply catalog: 60,00 rubber stoppers = 500.00 grams = $4.89.Each student in a class will need 4.0 stoppers. There are 24.0 students in the class. What mass of stoppers must be ordered? What will be the cost of the stoppers?
Volume: 200 mL Diameter = 5.45 cm Height = 9.72 cm Using the equation V= ??2ℎ, calculate the actual volume of the beaker.
In water conversation, chemistry spread a thin certain inert materials over the surface of water cut down on the rate of evaporation of water in reservoirs. This technique was pioneered by Benjamin Franklin three centuries ago. Franklin found that 0.10mL of oil could spread the surface of water of about 42.9m2 in area. Assuming that oil forms a monolayer ( that is, a layer that is only one molecules are roughly cubic. (1mm=1*10^-9m)