A channel of water at a flow rate of 2 kg/ s flowing through a square section and thin-walled channel with a height of 25 mm on the edge the inlet andi outlet are 25 °C and 75 °C respectively, and the channel surface is maintained at a constant temperature of 100 °C. Completely inside the channel approximate the required channel length value, since full-blown flow conditions are in question (m) (cp-4.185 kJ/ups, u=547x10-6Pas, k=0.643 W/ mK, Pr=3.56)

A channel of water at a flow rate of 2 kg/ s flowing through a square section and thin-walled channel with a height of 25 mm on the edge the inlet andi outlet are 25 °C and 75 °C respectively, and the channel surface is maintained at a constant temperature of 100 °C. Completely inside the channel approximate the required channel length value, since full-blown flow conditions are in question (m) (cp-4.185 kJ/ups, u=547x10-6Pas, k=0.643 W/ mK, Pr=3.56)

Name: A channel of water at a flow rate of 2 kg / s flowing through a squar
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: A channel of water at a flow rate of 2 kg / s flowing through a square section and thin-walled channel with a height of 25 mm on the edge the inlet andıoutlet are 25 °C and 75 °C respectively, and the channel surface is maintained at a constant temp

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Q4 Water flows from a large reservoir to a smaller one through a 5cm diameter cast iron piping system, as shown in Figure below. Determine the elevation z₁ for a flow rate of 5 L/s. ₁ =? Sharp-edged entrance - Standard elbow, flanged =₂=4m Gate valve fully open D=5 cm -System boundary 9m 80 m -Exit
Fluid at 20°C flows through a horizontal galvanized-ironpipe 20 m long and 8 cm in diameter. The wall shear stressis 90 Pa. Calculate the flow rate in m3/h if the fluid is(a) glycerin and (b) water.
A pipe connecting two reservoirs, as in Fig., containsa thin-plate orifice. For water flow at 20°C, estimate(a) the volume flow through the pipe and (b) the pressuredrop across the orifice plate.
A single looped network has to be analysed by the Hardy Cross method for given inflow and outflow discharges. The pipe diameters D and lengths L are given. Use the DarcyWeisbach head-loss discharge relationship assuming a constant friction factor ? = 0.02.
8
what is the pressure drop per meter for water flowing at 6 m/s through a 8 x 4 cm annulus? (dinner = 4 cm , douter = 8 cm)
Prelim discussion fluid
with a head loss of 7.5-m. Use iterative method to find the pipe diameter requires to keep a flow Q3: Oil, with (p- S950 kg/m'; v 2x10s m2/s), flows through horizontal smooth pipe of 80-m long rate of 0.332 m/s steadily flowing, (Start with initial guess of friction factor f-0.01)